Dětérmine the magnitude of the force P, acting as shown, that will cause the 120 N crate to move. Assume the coefficient of static friction between the crate and the ground are us = 0.3. 120N O 45 N O 50 N O 20 N O 36 N

Q: Three identical steel balls, each of mass m=80kg, are placed in the cylindrical ring which rests on…

A:

Q: 150-lb block is placed on a 33° incline and released from rest. The coefficient of static fric 0.46.…

A:

Q: As shown in this image, water fills a tank with a sloped side, which has a flat, rectangular gate of…

A:

Q: The tongs are used to lift the 150-kg crate, whose center of mass is at G. Suppose that 0 = 26 °.…

A: Answer The least coefficient of static friction at the pivot blocks so that the create can be lifted…

Q: 3 ft 2 ft Block 1 3 ft (150 lbs) H,-0.35 Block 2 3 ft (100 lbs) 4,=0.2 P.

A: Given: w1=150 lbw2=100 lb

Q: The simply supported beam is subjected to the forces and moment as shown in the diagram and table.…

A: Given:Required:Equivalent resultant load at point A

Q: 6 - A circular bar is subjected to a lateral load and axial torque, as shown in the figure. If the…

A: GivenMaximum allowable shear stress=100MPaLength of circular bar=600mm=0.6mDiameter of circular…

Q: Figure STC 012 shows a bin holding cylinders. Each cylinder weighs 800 kN and has a diameter of 3600…

A: Given:- Weight of each cylinder = 800 kN Diameter of each cylinder = 3600 mm = 3.6 m Radius of each…

Q: The top box weighs 125 lbs. and the bottom box weighs 150 lbs. The coefficient of static friction…

A: Given : Weight of top box = 125 lbs weight of bottom box = 150 lbs coefficient of static friction =…

Q: Problem 2. A trapezoidal channel has a 4 m wide bed and side slope of 2H:1V. What is the critical…

A: Given: The width of the channel is 4 m. The side slope is 2H:1V. The flow rate is 85 m3/s.

Laws of Equilibrium

A body is said to be in equilibrium if the system of forces acting on the body tends to keep the body at rest, in other words, there is no translation motion or net torque on the body. Under such conditions, the equilibrium conditions are to be applied to analyze the condition. The branch of mechanics that deals with this condition is known as 'statics'. Under equilibrium, there are no net forces on the body.