Determine the hydroxide, carbonate, bicarbonate and total alkalinity for the following watersamples. The titrant used was 0.02 N H:SO. and the sample volume was 50 mL. Expressyour results in mg/L as CaCO, Explain the differences between the samples.Jumlah ml titran untuk mencapai takat akhirTotal mL titrant to reach end pointSampelSamplepHBromkresol Hijau/Bromcresol Green, pH 4.5Fenolftalin/Phenolphthalein, pH 8.3A8.10.09.2B10.46.713.410.410.324.6D10.410.34.3

Given:Determine the total alkalinity of .Alkalinity is a measure of a its ability to neutralize…

Determine the hydroxide, carbonate, bicarbonate and total alkalinity for the following water samples. The titrant used was 0.02 N H₂SO4 and the sample volume was 50 mL. Express your results in mg/L as CaCO3 Explain the differences between the samples. Sampel Sample ABCD PH 8.1 10.4 10.4 10.4 Jumlah mL titran untuk mencapai takat akhir Total mL titrant to reach end point Fenolftalin/ Phenolphthalein, pH 8.3 0.0 6.7 10.3 10.3 Bromkresol Hijau/ Bromcresol Green, pH 4.5 9.2 13.4 24.6 4.3

Determine the hydroxide, carbonate, bicarbonate and total alkalinity for the following water samples. The titrant used was 0.02 N H₂SO4 and the sample volume was 50 mL. Express your results in mg/L as CaCO3 Explain the differences between the samples. Sampel Sample ABCD PH 8.1 10.4 10.4 10.4 Jumlah mL titran untuk mencapai takat akhir Total mL titrant to reach end point Fenolftalin/ Phenolphthalein, pH 8.3 0.0 6.7 10.3 10.3 Bromkresol Hijau/ Bromcresol Green, pH 4.5 9.2 13.4 24.6 4.3

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

For each of the following compounds, decide whether the compound's solubility in aqueous solution changes with pH. If the solubility does change, pick the pH at which you'd expect the highest solubility. You'll find K, data in the ALEKS Data tab. sp Does solubility change with pH? highest solubility compound pH = 3 pH = 5 pH = 6 yes K C1 no yes Ca(он), no yes PbF, no ? O O
CS 10 nousT200 7. Tooth enamel (Ca5(PO4)3OH) is a slightly soluble compound that exists as the equilibrium shown below. If the Ksp of tooth enamel in water is 6.8 x 10-37 calculate the molar solubility of tooth enamel. a. b. 2+ 3- Cas(PO4)3OH (s) → 5Ca²+ (aq) + 3PO4 (aq) + OH- (aq) 2.7 x 105 M 5.84 x 10-8 M C. 8.2 x 10-¹9 M d. 6.4 x 109 M 2.00
For each of the following compounds, decide whether the compound's solubility in aqueous solution changes with pH. If the solubility does change, pick the pH at which you'd expect the highest solubility. You'll find K data in the ALEKS Data tab. sp highest solubility Does solubility change with compound pH? PH = 6 pH = 7 pH = 8 yes BaCO3 no yes Ar Cal2 no yes Cu Br no X Ś ?
A 20.0-mL sample of 0.30 M weak acid, HA was titrated with 0.15 M Ca(OH)2. The following data were collected during the titration. mL Ca(OH)2 added: 5.00 10.00 15.00 20.00 pH: 6.98 7.46 7.93 10.31 What is the Ka for the weak acid (HA)? O 1.2 × 10-8 3.5 × 10-8 O 1.1 × 10-7 4.9 x 10-11
Based on your ICE table (Part 1) and the definition of Kb, set up the expression for Kb in order to determine the unknown. Each reaction participant must be represented by one tile. Do not combine terms. Kb = = 5.2 × 10-4 RESET [0] [0.075] [0.10] [5.2 × 10] [x] [2x] [2x]² [0.075 + x] [0.075 - x] [0.075 + 2x] [0.075 - 2x] [0.10+x] [0.10 - x] [0.10 + 2x] [0.10 -2x] < PREV 2 3 Based on your ICE table (Part 1) and the equilibrium expression for Kb (Part 2), determine the pH of the solution. pH = RESET 0 7.86 6.14 0.075 3.9 × 10 3.41 10.59 1.12
For each of the following compounds, decide whether the compound's solubility in aqueous solution changes with pH. If the solubility does change, pick the pH at which you'd expect the highest solubility. You'll find K data in the ALEKS Data tab. sp Does solubility change with pH? highest solubility compound pH = 5 pH = 4 pH = 3 Ca, (PO.), yes O no O yes AgCN O no yes PbCl2 no Explanation Check Accessibili O 2021 McGraw-Hill Education. All Rights Reserved. Terms of Use Privacy 17 MacBook Air F10 F9 F7 F8 o oo o
11) A 520 ml solution contains 0.130 M formic acid (K, = 1.80 x 10) and 0.130 M sodium formate. First determine the pH of this initial solution. Next, determine the pH if 1 mL of 5.5 M of HCI was added to this solution. Finally, determine if rather than HCI, 1 mL of 5.5 M NaOH was added to the solution.
= 0.01 x 0.100 = 0.001 001 50.0 X0-250 = 0.0125 0.0123 025 0.06 0.300 x0.01 0.100. X 0.01 B. 9.25 0.06 6A 10.0 mL solution of 0.300 M NH3 is titrated with 0.100 M HCI. Calculate the pH after the addition of 10.0 mL of acid. A. 9.55 0.001 -0.003 0.300 x 0.0 0.001 C. 8.95 0.02 PH = PKG +10g [0.0156 2.67=4.744+ [19165 TI-84 Plus TEXAS INSTRUMENTS D. 9.73 = Pl= 3.68 - 267 28.3. 0:3 0002 0.002 M Plt = -log = .05 U.2 E. 8.77 Pit=Pkg tog 20.015 = 1.01 [A] [HA]
12
Use activity coefficients to find the concentration of hydrogen ions in a solution of 50.0 mM butanoic acid (C,H,COOH) and 0.01 M NaCI. The ionization constant of butanoic acid is K, = 1.52 x 10-5. Take the size of C,H,COO" to be 500 pm. Activity coefficients can be found in this table. 8.7 x10-4 [H*] = M Incorrect What is the pH of this solution? Include activity coefficients in your calculation. pH = 3.06 What is the fraction of dissociation of butanoic acid in this solution? 3.04 x10-4 Incorrect
An analytical chemist is titrating 127.2 mL of a 0.9000M solution of nitrous acid (HNO₂) with a 1.200M solution of KOH. The pK of nitrous acid is 3.35. a Calculate the pH of the acid solution after the chemist has added 105.0 mL of the KOH solution to it. Note for advanced students: you may assume the final volume equals the initial volume of the solution plus the volume of KOH solution added. Round your answer to 2 decimal places. pH = X S
The pKa of hypochlorous acid is 7.530. A 51.0 mL solution of 0.122 M sodium hypochlorite (NaOCI) is titrated with 0.323 M HC1. Calculate the pH of the solution after the addition of 7.44 mL of 0.323 M HC1. pH = Calculate the pH of the solution after the addition of 20.0 mL of 0.323 M HCl. pH = Calculate the pH of the solution at the equivalence point with 0.323 M HCI. pH =