Determine the gage pressure in kPa at point "a", if the liquid A has a SG = 1.20 and liquid B has SG = 0.75. The liquid surrounding point "a" is water, and the tank on the left is open to the atmosphere. The definition of specific gravity (SG) = p / p H20. - Liquid A 0.9 m 0.25 m Water 0.125 m |0.4 m Liquid B

Determine the gage pressure in kPa at point "a", if the liquid A has a SG = 1.20 and liquid B has SG = 0.75. The liquid surrounding point "a" is water, and the tank on the left is open to the atmosphere. The definition of specific gravity (SG) = p / p H20. - Liquid A 0.9 m 0.25 m Water 0.125 m |0.4 m Liquid B

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

h = 4 ft F 2 ft A hemispherical glass bubble is installed in the side of a tank as a viewing window with its center 4 ft below the surface of the water. What is the magnitude of the vertical component of the force on the glass in lbs? The specific weight of water is 62.4 lbf/ft3.
The total pressure force of a square plate is 25 kN, placed vertically in water so that the center of the plate is 1.5 m below the free surface. Determine the size of the plate and the depth of center of pressure. The above square plate is taken out of the water which weighs 370.5 N in air and 180.3 N in water of specific gravity 0.99. Find the volume and specific gravity of the square plate. Draw a neat sketch.
A tank contains 400 kg of a fluid. If the volume of the tank is 2.5 m?, then what is the density of the fluid and what is the specific gravity? With explanation
Consider the system shown in Fig. P1-77. If a change of 0.7 kPa in the pressure of air causes the brine-mercury interface in the right column to drop by 5 mm in the brine level in the right column while the pressure in the brine pipe remains constant, determine the ratio of A, /A,. Air Area, A₁ Water Mercury SG 13.56 Brinc pipe SG= 1.1/ Area, A₂
1. An irregular container, closed at the end, is filled with water (999 kg/m). Consider the opening exposed to the atmosphere at 1 atm, find the pressure at point A. Refer to the figure below. P. atm 0.5 m, 40° 60° 0.4 m 0.4 m 3 m 3 m 2.6 m А. 0.3 m all in meters 0.5 0.5 0.5 2.7 m- 1 m
Problem 2 В A manometer was used to determine the pressure of the gas at B. Three fluids were used, two of which are made of liquid having specific gravities of 1.25 and 0.80 while the third is a gas with an unknown specific gravity. What is the pressure (in Pa) at B? The specific weight of water is 9,810 N/m³. 5 сm A 60° 6 ст S.G. = 1.25 4 сm S.G. = 0.80
An airship of 100m3 in size is launched from sea level and it gradually attains height until it reaches the desired altitude. A manometer measuring the gage pressure of the inside filled Helium gas show a reading of 1.2 bar at the altitude of A meters from the ground. Manometer shows reading of 2 bar when it reaches to a height of B meters. Assume; Density of air at point A = 1.00 kg/m3 and at Point B= A = 0.80 kg/m3. You can also assume average density = 0.9 kg/m3 where required. Consider temperature inside the balloon = 10°C and negligible change in temperature during the process. (a) How much payload mass can it carry if the mass of airship itself is 5Kg? Do you expect any change in lifting capacity while moving from point A to point B? (b) Calculate the mass of helium to be expelled out to maintain the constant pressure of 2 bar at point B.
1. Find the absolute pressure (kPa) at a depth of 5m below the surface of a liquid with relative density 0.85. The barometer reading on the surface is 1.5 bar. Use 1000 millibars = 101.325 kPa = 1 atm. (2 decimal)
An airship of 100m3 in size is launched from sea level and it gradually attains height until it reaches the desired altitude. A manometer measuring the gage pressure of the inside filled Helium gas show a reading of 1.2 bar at the altitude of A meters from the ground. Manometer shows reading of 2 bar when it reaches to a height of B meters. Assume; Density of air at point A = 1.00 kg/m3 and at Point B= A = 0.80 kg/m3. You can also assume average density = 0.9 kg/m3 where required. Consider temperature inside the balloon = 10°C and negligible change in temperature during the process. (a) Calculate external atmospheric pressure difference between Point A and B (b) Neglecting the effect of altitude on local gravitational acceleration, determine the height attained from A to B.
Determine the pressure in a vessel of oil (specific gravity is 0.85) at a point 15.75 feet below the surface, in (a) pounds per square gage; (b) pounds per square inch gage; (c) pounds per square foot absolute; (d) pounds per square inch absolute. NOTE: Clear handwritten solution
Question #2: Pressure acts on a wall below as shown. The pressure varies with z-position on the wall by P = (z/100)2, where P has units of lb/ft². The wall width is 100 ft, while the wall height is 100 ft. Determine the magnitude and position of the resultant pressure on the wall. Give position in terms of both z and y axis. h a b O Figure P 100 y lb/ft²