Determine the following for the network shown: a. lp b. VGs C. VDS d. Vs e. VG f. VD 1 ΜΩ RG +69 G 20 V IDY RD VGS | 3.3 ΚΩ OD S IDSS = 8 mA Vp=-6 V Rς 21kΩ Rs +₁

Q: Find the node voltages & calledor current. Which Region is the BJT operating in? -15/02 5105 P=100…

A: The question is about finding node voltages, collector current and operating region of the…

Q: Question 3: A very simple model for the distribution of clectricity to a typical home is shown in…

A:

Q: 93uF 7 L 301 3302 5 Pa ssband ain190 vj İVJ I got the exact ftsl98.0549Hz- vil is the Voltage gan…

A: Write the expression to find exact value of lower cutoff frequency for the given circuit as follows:

Q: Ex (H.W) Calculate the value of R₁ for which it will receive maximum from Power the Load. and…

A:

Q: EX Ageueration Stien of lo Mw suPPly regien of two Consumes A and B when the Varatienof the lead is…

A:

Q: 1.0 ΚΩ 2.0 ΚΩΤ +12 1.8 ΚΩ 1.5 ΚΩ R₁. 1.0 ΚΩ Ip = 2 mA Vasorr = -6V Determine a) VDS b) gi c) Aus

A: Brief description:  For the given MOSFET circuit we need to calculate it's VDS , gm & Avs. By…

Q: R2 Q1 R3 VCC R1

A: We need to find base resistance of given circuit

Q: Calculate the value of RB in ohms. at VE=4V, RE=315 ohm, IB=13uA, RC=2139ohm and VCE=11V

A: In this question, We need to Calculate the value of RB in ohms.   If VE=4V, RE=315 ohm, IB=13uA,…

Q: 73. The full-load copper loss of a trans¬former is 1600 W. At half-load, the copper loss will be

A: —

Q: Three coils each having resistance of 14 0 are connected in delta across 414 V, 50 Hz supply. Then…

A:

Q: 3. Determine the voltages 2A(t) 30. 0.9i 18 0

A:

Q: + 17V 14A+ R, 25V 0.41

A: Applying the nodal analysis at the node:

Q: Find the Value of I/PT if I=63 P=840 and t =219/365

A: According to the question we have to find the value of I/PT.

Q: How it is come like that !!? Please can you explain for me!??

A:

Q: 3 2 + V2 is v5 70 24 V + Vi

A: We need to find out current and voltage and power for given circuit

Q: 9-1/ For the fixed-bius configurantion as shown in the figure tind © Isg O Icq ' ©Vcfg' OVe ' © VB '…

A:

Q: What are the branch currents, 12 and 13? R₁ 4 kOhm V₁ 35 V R2 7.5 kOhm R 12.5 kOhm

A: Introduction Current divider rule: The current divider rule is an electrical principle that explains…

Q: VL120° V ( V₁/-120° V O a. IAB=4.22 A, lb-6.68 A O b. IAB=5.45 A. lb-3.45 A V₁Z0° V 1₂ O c. IAB=4.45…

A:

Q: In a parallel circuit, ET = 120 V, R = 1500 $2, and XL 1000 2. What is the apparent power? O a.…

A: Given: In a parallel circuit, ET=120 VR=1500 ΩXL=1000 Ω

Q: Three coils each having resistance of 30 Q are connected in star across 427 V, 50 Hz supply. Then…

A: total power consumed = 3×Phase voltage2Resistance for star connection, phase voltage = line voltage3

Q: • Find Thevenins eguivalent for the chage EL • Get the value of impedance to Find max power trars…

A:

Q: 41. In the figure, the value of Ris 8 A R ww 100 V- 10 2 102 (a) 2.5 2 (c) 7,5 0 (b) 5.0 2 (d) 10 O

A: According to the question we have to find the value of R.

Q: mine the approximate value of Ip of Figure 18 V 2 k2 750 k2 VG Ipss 8 mA VGS 91 k2 0.68 k2 Figure 56…

A:

Q: Findthe following Values (ve -VE - Vg-VGE - Vec -Ie -Ic-T)

A: According to question: Applying KVL, this will give Let…

Q: In a circuit R-L-C in series, R 300 V, XC 300 V and XL 500 V. The average electrical power consumed…

A:

Q: H. W 25.2 ?? 50V 5H PL to

A: Given :   Note :  In the given question that did not mentioned for which time instant they want…

Q: perform the following operations in Octal (with and without complement): 152 – 77

A:

Q: 1) 2A 8A 10 ohm

A: Here i have applied the kcl and found the answer.

Q: ÉA fab j-Xab Eg Ec -j- Xca Ea=220+j0 V, Eb=-110-j190.5 V, Ec=-110+j190.5 V. Rab=200 Ohms, Rbc=150…

A:

Q: How many hours C O A) 0-24 O B) 0-48 O9 0-12 O D) 0-72 O E 02

A: UPSs generally feed their loads for 0-2 hours

Q: a. Determine re. b. Find Avid Vo/Vi- == c. Calculate Zi.

A: In the given circuit the value of the re resistance, mid voltage gain and the input impedance needs…

Q: 36 A 96 SOK vzi=8.6V 38V v22=11.2v S100K

A:

Q: Q4) Use delta to star or star to delta , find the total resistance between a-b Rab 95 bo

A:

Q: Explain why a bridge rectifier would be used instead of a two-diode full-wave rectifier.

A: There are two types of full wave rectifier, one is 2-diode full wave rectifier and the other is…

Q: the circuit shown below, determine load current. 0.62 0.8N 36 V 32 V RŽ1.8N 0.12N 0.242

A:

Q: 3. Given the information provided in Figure 3, determine: 12 V 오 a. Ro b. RE C. IB d. RB e. VCE f.…

A: We need to find out the value of unknown resistance and current and voltage for given circuit.

Q: A 10A current is lagging the voltage by 47° and a 12A current is lagging the voltage by 58°. What is…

A: Given:  10 A current lagging the voltage by 470 and 12 A current lagging the voltage by 580. We have…

Q: Pt = Pt = P+ = Pt Pr G+ x Gr > (4nd)² 1x106 (00X100 x/0.112 1x 10-6 4X3.14 X 600² 10000 x 0.1…

A:

Q: What is the phasor diagram of the voltages at bus one and two, in per unit, of the attached image?

A: A diagram of a two bas bur power system is shown in the question. We need to draw the phasor diagram…

Q: + Vourlt) ३10 H InF O A. 1591.5 Hz O B. 333 Hz OC. 5032.9 Hz O D.316 Hz

A: The frequency of a RLC circuit is given by  f=12πLC=12π10*1*10-9=1591.5 Hz

Q: Rectifier Circuit for nos. 1 to 7. Determine the reading of each meter and PLave. AL A2 3:2 220V 1k…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.