Determine the following (a) IB (b) Ic (c) VE (d) VCE 18 V 9.1 kQ 510 kQ B=130 510 kQ 7.5 k2 -18 V

Q: 125 K C/+ 50k Ne 6805

A:

Q: MVI A, 32H LDA 1234H STAX D MOV M, B

A: Given,  MVI A, 32H LDA 1234H STAX D MOV M, B

Q: or the circuit shown below calculate I, Iı and Iz. 33 Ω 10Ω W 109, 30V Σ47Ω 33 Ω 47 Ω

A:

Q: Sketch i0  and v01 for the network below for the input shown (Both diodes are Si. Vd = 0.7 V)…

A: During the positive half cycle only diode D1 is forward biased and it will conduct and with the help…

Q: Using Kirchhoff analysis, determine the initial current in each section along with its direction and…

A:

Q: 5. Given a variable input voltage in the circuit shown, a Zener diode is used to regulate the output…

A: Given:a zener diode circuit, with, we need to find:a) minimumb) maximumvalue of Vin for sustained…

Q: a. Find VL, IL, Iz, and IR if RL is 180ohms. b. Find the value of R₁ that will stablish maximum…

A: We need to find out current and resistor for given circuit

Q: Determine the aspect ratio of the NMOS in the circuit to produce a drain current of 150 uA. R2 2.5k…

A: Brief description : Generally mosfets are known as high input impedance devices. MOSFET's have four…

Q: Problem 2: Consider the circuit shown in the below figure in which the diode cut-in voltage is Von =…

A: GivenA diode circuit diagram is given by,The cut-in voltage is To findPlot  Vs  for .

Q: Analyze the ON/OFF states of all diodes (D1 and D2) in this circuit, using the ideal-diode model.

A: The above problem is based on diode circuits.We assume all diodes are ON initially and find the…

BJT (Bipolar Junction Transistor)

A BJT is a semiconductor device with 3 terminals that consist of a p-n junction diode that can amplify the signal or current. It is a current-controlled device. The three BJT terminals are base, collector, and emitter. The BJT works with the charge carrier, the two type of carriers in the BJT are holes and electrons, the charge carriers flow by the process of recombination. The signal to be amplifier is generally given as the input at the base terminal and an amplified form of it is available at the collector terminal.