Determine the equation and draw the elastic curve. Determine the deflection and slope at end B if E = 12 GPa.

Q: Can placing riprap and building cement walls prevent the retreat of sea cliffs being attacked by…

A: yes by placing the riprap be protect the embankment and other structure against erosion. its used in…

Q: What is a sill sealer used for?

A: It is a closed-cell product that is used to reduce the air gap between the foundation wall and the…

Q: Description of column and its types?

A: A column is a vertical component of the structure designed to move a compressive charge. For…

Q: What type of floor tile is used for areas subject to heavy use?

A: Tiles Tiles in building construction are thin plates or elements which are used to cover up the…

Q: What are the types of walls. Please write it in short as chart to remember.

A: classification based on load bearing load bearing wall eg. masonary wall ,retaining wall non load…

Q: Explain pipe earthing

A: Brief concept- Earthing- It is a process by which charge is transferred to the earth with the help…

Q: Define Caisson

A: Caisson: It is a hollow box or in the shape of a cylinder that is prefabricated which is sunk into…

Q: Explain the minimum no of bars to be provided in circular column ?

A: The minimum number of bars in column is 6 for the circular column.

Q: Why hopper walls are steeply sloped ?

A: When hoppers square measure designed inconsiderately of the particular materials being handled,…

Q: Can we apply Eurocode 6 for RC walls?

A: The member which is in compression and carries all loads made up of reinforced cement concrete is…

Q: Define when designing a water storage tank, should movement joints be installed?

A: Different types of joints are used in reinforced concrete water tank structures for various…

Q: A wall partition 5.8m long and 3.4m high specify the use of 2”x3” studs space at 60cm on both ways.…

A: Solution:- Total area of partition, Ap=Length×Width     =5.8×3.4  =19.72 m2     =19.72×104 cm2…

Q: What are the forces that can move water through a joint in an exterior wall? How can each of these…

A: There are four forces that are responsible and can act independently or jointly to move water:.These…

Q: draw a structural base in a picture

A: Structural layout shows the structural components of a building like beams & colums. This layout…

Q: How many risers are required if the height between floors is 10' (3000 mm)?

A: The vertical part of the staircase is called as a Riser. The standard values of the height of one…

Q: Howcan I  design  a shear wall ,Could you give steps ?

A: Oi

Q: Define Water-Retaining.

A: Water retention in soil can be understood as the water retained by the soil after it runs through…

Q: ind the number of 7 1/2" risers required for a flight of terrazzo steps that is 4' 4 1/2"

A: Height of flight of terrazzo steps = 4' 4 1/2" = 4x12 +4.5 = 52.5 " Height of Riser = 7 1/2" = 7.5"

Q: List the precautions needed to use level rods.

A: The levelling rod should be always held straight along line of sight. Selection of rods must be made…

Q: 1/ For the plan and section of the wall shown below. Calculate quantities for each of the following…

A:

Q: 4#8 12" 15" I 3: fó= tooopsu Grade Go Steel NWC. &Mn = ?

A:

Q: A & C are incorrect, please re-work

A: As per question , I solve here only a and c. Find out - (a) Radius of curve  (c) Tangent length

Q: What perameters are used for Existing ground level ?

A: Solution: Ground level means the existing level of the site at any of the point. When earth filling…

Q: WOULD THE BEARINGS BE THE SAME?

A: Finding the bearings of a line AB, BC, CD, DA. In above solution find out the azimuth of lines is to…

Q: Design brief for ramp and stairs?

A: Design for Ramp: A sloped pathway which is used to provide access between two vertical levels is…

Q: Describe in detail two ways to drain roof water

A: Draining of roof water means when water gets accumulated on the roof and we have to drain it so that…

Q: flowchart detailing the deisgn of One-way Slab

A: One-way Slab: - It is a slab in which longer span is equal or greater than 2 times of shorter span…

Q: A CPLD is based on

A: A CPLD- Complex Programmable logic device It is a programmable device based on complexity PALs and…

Q: Draw a simple weir drawing plan (show side elevation and top view)

A: Weir is a hydraulic structure used for various purposes like storage, discharge measurements, silt…

Q: What is the minimal number of bars required in a circular column?

A: Introduction: It consists of three bars that create a Ronchi ruling in its simplest form. These 54…

Q: A series 31 engineering drawing will contain information about which of the following? General notes…

A: An engineering drawing is a fundamental part of any construction or design project, serving as a…

Q: what method did you use there

A: For forces in member , method of joints have been used and for displacement calculation virtual work…

Q: Draw the structural details of the following sections (an elevation view and a side view)

A: Approach to solving the question: used autocad Detailed explanation: Examples: cad Key references:…

Q: Q5/ In the plan below there is a conventional L shape stair, the distance between slabs is 2.9m find…

A: Solution: Given: Area for staircase provision: 2 m x 3 m staris width = 90 cm landing area = 90 cm x…

Q: Define struts.

A: Struts:- They are long, slender structural members in an assembly which are subjected to the only…

Q: draw finished floor to floor height = 3000m total width of stair (u shaped stair) = 2400 mm

A: Given finished floor to floor height = 3000m total width of stair = 2400 mm To Draw  a (U) shaped…

Q: 23 Draw your own neat and detailed sketch of a Simple Flap Gate and paste this into the Student…

A: Flape gates are a special type of valve, that allows water to flow only in one direction.Flape gates…

Q: Hi we are looking for 5 please add another 2

A:

Stair construction and layout

Stair is a type of vertical transportation in a building which consist of a series of steps in a flight of stairs that enable the vertical movement of people and materials from one floor to another. A staircase consists of steps that comprises of riser & tread, handrail, baluster, stair stringers, newel post and waist slab. The construction of staircase with all the components is termed as stair construction. A staircase is an enclosure that contains the entire stairway. The materials used for the construction of stairs are bricks, reinforced cement concrete, stone, lumber, steel and a combination of these materials.