Determine the endurance limit for this material as well as the value after correction for surface finish, sizing, and loading. The endurance limit for this material is 235 MPa. The endurance limit after correction is 176.4 MPa.

Q: Problem 6 You've been asked to design a stamping tool as shown. What are the internal forces at A…

A: FBD

Q: The first gear in a single - stage gear train has 42 teeth and an angular velocity of 2 revolutions…

A: Given,The first gear in a single - stage gear train has 42 teeth and an angular velocity of 2…

Q: Cven Torque 1. NM = for each gear Draw Free body diagram for the gear train that Include: Speed,…

A: To draw the free body drawing of gear train from the given picture.

Q: Two meshing ge ocity ratio Moc I, e=2 Pressure angle

A:

Q: A compound gear train with gears P,Q,R and S has number of teeth 30, 50, 20 and 30 respectively.…

A: Given that: Number of teeth in gear P, Q, R and S are 30, 50, 20 and 30 respectively. Gear Q and R…

Q: 8-5 lem 8-5 The machine shown in the figure can be used for a tension test but not for a compression…

A:

Q: For a shaft diameter of 7.50 inches, a rectangular key size of 2.0 in.(W) x 1.50 in. (H) should be…

A: As per the diagram and question given For a shaft diameter of 7.50 inches, a rectangular key size of…

Q: For an internal thread, If the 3.75mm pitch and Tap drill size is 12 mm. Find the Nominal diameter.…

A: pitch=3.75 mm  tap drill size =12mm nominal diameter =?

Q: Hey there!  Calculate the IMA of the interlocking gears shown if the larger wheel (30 teeth) is…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.