Determine the available suction head of the pump that is taking a gasoline at 204°C at a closed tank with a pressure 585 kPa gauge. the specific gravity of gasoline is 0.78 and it’s vapor pressure is 620 kPa absolute. the loss in suction pipe is 0.60 m and the pump center line is located 3.60 m above the gasoline level A. 8.66m B. 3.67m C. 7.66m D. 4.47m

Q: a. A U tube differential manometer containing mercury was used to measure the difference of…

A:

Q: Convert 235.268 Kelvin to Rankine

A: Solution  Given Data Teperature in Kelvin (K) = 235.268 K

Q: In the system, 900 L/min of oil is pumped with (s=0.92), from an underground storage tank to the…

A: Given: The flow rate of the oil, Q = 900 L/min The specific gravity of the oil, SG = 0.92 The loss…

Q: Calculate the NPSHA in ft for the following configuration of pumping system. (Hint: Use steam tables…

A: Net Positive Suction Head is the pressure margin over vapour pressure at the pump suction nozzle…

Q: At a flow rate of 30 LPM, what will happen if the pressure stays the same in 30, 60, and 90 seconds…

A: The flow rate of the fluid:Hydrostatic pressure:

Q: To what height will the jet of water rise for the conditions shown in Fig. 6.40?

A: Given data: p=12 psig

Q: 8. R12 saturated liquid at 35°Cis throttled to a pressure corresponding to a temperature of 5°C.…

A:

Q: Calculate the minimum volume of air required for the complete combustion of 1 m³ of a gaseous fuel…

A: INTRODUCTION: The fuel has a distinct composition that undergoes the combustion process, and a…

Q: Flow Pump 6-in Schedule 40 4-in Schedule 40 4 in Engine Oil 30 in Mercury (sg =13.54)

A: Calculate the pressure change from point 1 to point 2. P1-ρoilg4 in-ρhgg30 in+ρoilg34…

Q: The velocity of a fluid flowing in a pipe is to be measured by two different Pitot-type mercury…

A: we have to evaluate which pitot tube will be more accurate

Q: Design a two-stage compound spur gear train for an overall ratio of approximately 17+6:1. Specify…

A: Overall ratio=17+61=231

Q: Which step of the following steps is for use of a manometric tubes to measure the * differential…

A: Given: Which step of the following steps is for use of manometric tubes to measure the differential…

Q: Variable displacement pumps used in hydraulic applications can

A: Variable displacement pumps used in hydraulic applications can 1) can have variable flow rate 2) can…

Q: Q3/pond water is supposed to use for fire extinguishment in an institute for an emergency if any…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: Liquid of sp.gr and u is in a closed tank with air at pressure measured by a manometer of R reading.…

A:

Q: How much flow comes out of the cap end port of the cylinder when the cylinder retracts? Is that more…

A: A hydraulic cylinder is a hydraulic actuator that converts hydraulic energy into mechanical…

Q: Figure below shows a siphon that is used to draw water from a tank. The siphon tube has an inside…

A:

Q: Industrial pipes Do the guides allow movement of a pipe only in two directions (in a plane)?

A: The objective of the question is to understand the movement of a pipe in a guide in terms of…

Q: Oil at specific gravity of 0.761 flows from tank A to tank E as shown. Lost head may be assumed to…

A:

Q: What is the pipe velocity at point 12 Given the specific gravity of pink liquid S=3.9 and height…

A: Given    Height, h = 0.4 m

Q: Determine the relationship between the air pressure in the tank and the maximum height to which the…

A:

Q: P/ IF the Flow vate through the Pum 0.1 mls of water, Find the Punp head.The manometer reading is…

A: The pump head is 14.7157 m.

Q: What is the maximum height the higher reservoir can sit and be filled using a fixed-speed pump with…

A: Pump Power, P=114HP=1+0.25=1.25HP=687.50lb.ft/s Pump Efficiency, η=57% Volumetric flow rate,…

Q: 0 oil volume flow rate

A: given:

Q: the ratio of power output of the pump to the power input to the pump is known as

A: Pump efficiency,η=Power output of pumpPower input to pump where,Power output=ρgQHwhere,ρ=density of…

Q: Consider the fluid between two parallel plates, in which we move both plates. Which of the ff. is…

A: When there is a liquid between the two plates in motion, the velocity distribution is not fixed and…

Q: В4. An orifice meter with orifice area 945 mm2 is inserted in a pipe of area 1890 mm2 The pressure…

A:

Q: the specific speed for pump

A: Given; In terms of speed of rotations of the impeller N, discharge Q and change in total head H,…

Q: a. A U tube differential manometer containing mercury was used to measure the difference of…

A:

Q: Define a pump. Explain the working principle of any one of the pumps with neat sketch

A: Pump is a device used to add the energy to the liquids in order to move, raise, compress and deliver…

Q: A "spa tub" is to be designed to replace bath tubs in reno- vations. There are to be 6 outlet…

A: Flow area of the pump is A1=π4D12 The flow rate for the suction is Q=A1v1=π4D12v1⋯⋯⋯(1) Discharge…

Q: At a flow rate of 20 LPM, What will happen if the 30 seconds is 2.943 kPa, the 60 seconds drops to…

A:

Q: Liquid of sp.gr and u is in a closed tank with air at pressure measured by a manometer of R eading.…

A:

Q: A U tube differential manometer containing mercury was used to measure the difference of pressures…

A: Given that, Specific gravity of water, sw=1Specific gravity of mercury, sm=13.6 (b) Drawing the neat…

Q: In the system given below, the water taken from the A chamber is transmitted to the D chamber with…

A: We know that power =ρghQviscosity gives =1.13×10-6m/sget velocity of flow in pipe from head…

Q: derive the equation of the efficiency of the pump.

A: The pump is used to convert mechanical energy into the hydraulic energy (flow, velocity and…

Q: A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open…

A:

Q: total energy

A:

Q: Use the Goulds Pump Selection System to find a pump capable of delivering at least 500 gpm against…

A: To solve the given problem, we will use the Goulds Pump Selection System. This system helps us…

Q: Find the difference in pressure head and velocity of flow of an oil through a pipe, when the…

A: Given that H= 110 mm of Hg ;sp. gravity of oil= 0.9 ; Density of oil= ρ= 900 Kg/m3 ;The coefficient…