Determine the angle measured clockwise from the major principal axis to the x axis of the section, in degrees. Answers in 2 decimal places. 100 mm T 400 mm с. -X + 100 mm T 600 mm- 400 mm -100 mm

Q: Treat the trapezoidal region as a composite of a rectangle and a triangle to find: a. Find X bar…

A: It is required to find the centroid and moment of inertia.

Q: 1- find the area of the region lies above the line y = -x and inside the circle r = -3cose

A:

Q: Locate the centroid using Integral method y? = x 1m y = x² 1 m

A: A polar coordinate system is a way of calculating points in a system area with the correct…

Q: 2. LOCATE THE CENTROID USING VARIGNON'S THEOREM Locate the centroia of the snaded area. -120- 120 40…

A: Centroid is defined as the centre of mass or the point at which the entire mass of the body is…

Q: why you didnt included the 5*(5+5)= 50 kn in the midle ? is it nececarry to include or its against…

A: Uniformly distributed load of 5 kN/m over the span of 10 m.Beam is simply supported.

Q: Determine the height h above the base of the centroid of the cross-sectional area of the beam.…

A:

Q: A plate and angle column is composed of four 8x4x1 in.angles with the short legs connected to a web…

A: Consider the given figure and data

Q: 5. Determine the force in each member of the truss by substituting member AB with one placed between…

A:

Q: Represent the following 1-Line perpendicular to the horizontal plane and pass through the origin.…

A: In a three-dimensional coordinate system, a line that is perpendicular to the horizontal plane (XY…

Q: 0 = 6.1 Rod OA rotates counterclockwise at a constant angular rate (rad/s) . The double collar B is…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.