Determine support reaction

Q: Use the method of sections to determine the forces in members BD, CD, and CE. Note: The support…

A: Given data  Given truss system

Q: 4 m A B 2 kN/m

A: THERE IS ONLY TWO UNKNOWN REACTION AT PIN B  IS VERTICAL REACTION Rb AND HORIZONTAL REACTION Hb.…

Q: Can you give me the free-body diagram?

A: Given data:- A pendulum of mass M1=1 kg  length L = 0.75 m . Mass of Block M2= 2 kg To find :- Free…

Q: A post is supported by a ball-and-socket joint at O and cables BC and BD. A triangular distributed…

A: Given data, w = Maximum intensity of UVL = 36 N/m rOA = Length OA = 1.6 m rOB = Length OB = 2.5 m…

Q: Write the three equations of equilibrium?

A: A body is said to be in equilibrium it is not acted upon by any net force in either of the two…

Q: The total number of independent equations of equilibrium that we can write for a frame or machine…

A: Six independent equations of equilibrium that we can write for a frame or machine.Option first is…

Q: In analyzing the unknown forces acting on a given pin in a plane truss, obtaining a negative answer…

A: Option 3 is correct  The direction that was chosen for the force was incorrect, and the correct…

Q: Help!!! Answer this correctly!! Please

A: Step 1: Step 2: Step 3: Step 4:

Q: Problem 8 Determine the reaction at the roller support A and B and pinned support C. El is constant.…

A: Step 1:Step 2:Step 3:

Q: Question 4 What are the reaction forces at point A? A PETER -1.5 m B G 20 KN 1.5 m C D F 1.5 m-1.5 m…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.