Determine resultant internal loadings acting on cross section at B of pipe Mass of pipe = 2 kg/m, subjected to vertical force of 50 N and couple moment of 70 N m at end A. It is fixed to the wall at C

Q: Assume that Young's modulus for bone is 1.5x10 ^ 10 N / m2 and that a bone will fracture if more…

A: Given : Young's modulus (Y) = 1.5 x 1010 N/m2 Stress (σ) = 1.5 x 108 N/m2 Diameter (d) = 2.50 cm =…

Q: The homogeneous wire ABCD is bent as shown and is attach to a hinge at C. Determine the length L…

A: this question is about to measure center of gravity of wire for equilibrium.

Q: a)What is the magnitude of the bone shear force acting on the vertebra?Report in  N  b)what is the…

A: The objective of the question is to calculate the magnitude of the bone shear force and the bone…

Q: P4. If the cross section of the femur at section a-a can be approximated as a hollow as shown,…

A: Maximum normal stress = 235.98 lb/in2 = 236 psi Detailed solution is given below: Please UPVOTE sir

Q: The beam is supported by a pin at A and a short link BC. Figure 0.5m 1 m 4P 1.5 m 4P 1.5 m 0.5m 1 of…

A:

Q: The beam BE shown is used for hoisting machinery. If is anchored by two bolts at B and C; it rests…

A: Nb and Nc are suppot offered by bolts at B and C respectively

Q: c) A hollow connecting rod has an inner diameter of 26.25 mm and is subjected to an axial tensile…

A: Write the given values with the suitable variables. d=26.25 mm=26.25×10-3 mF=500 MN=500×106 Nσ=325…

Q: The radius ofa copper bar is 4 mm. What force is required to stretch the rod by 20% of its length,…

A: The Young’s modulus is given by,

Q: The point where the stress-strain diagram for structural steel becomes almost horizontal is called…

A: We have to plot the stress strain diagram to do this question.

Q: A 195-kg load is hung on a wire of length of 3.40 m, cross-sectional area 2.00 x 10 5 m2, and…

A: Mass hung =195kg Length of wire =3.4m Cross section =2×10-5 m2 Young's moduls = 8×1010 N/m2

Q: Assume that if the shear stress in steel exceeds about 4.00 x 108 N/m², the steel ruptures. (a)…

A: Shear stress in steel is Diameter is Note:Find:(a) The shearing force.(b) Force required to punch a…

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics. 

Equilibrium of Forces

The tension created on one body during push or pull is known as force.