DETERMINE FORCE (N) OF MEMBER EG in the truss shown. F1 = 237 N F2 = 682 N F3 = 456 N α = 40 degree x = 8 m. Note: for compression, include a negative sign ( - ) and for tension, type your answer as is. Input your answer in two (2) decimal places only.

Q: A ruler is clamped clamped at weight 0-36 ку weight is at = deflection at deflection at It is x=17cm…

A: A ruler is clamped at x=3 cm and x=30 cm,Weight of 0.36 kg is concentrated at x=17 cmDeflection at…

Q: In the figure, one end of a uniform beam of weight 270Nis hinged to a wall; the other end is…

A:

Q: A beam of the cross section shown is extruded from an aluminum alloy for which Oy= 250 MPa and ou=…

A: Given,  σy = 250 MPa FS = 3

Q: Let P = 191 N, Q = 198 N, a = 2.5 m, and b = 5.0 m. Type the unit, N, after typing your numerical…

A: Determine the force in member EI. Lets solve using method of joints.

Q: Rigid bar ABCD is loaded and supported as shown. Steel [E = 30600 ksi] bars (1) and (2) are…

A:

Q: e if the members are in tension or compression. Take that = 140 lb. re -2 ft- -2 ft- 3 ft 1 of 1…

A:

Q: The Cantilever truss in figure below is hinged at D and E. Find the force in each member. 1000 lb B…

A:

Q: 1. The bar AB with cross section Ag is shown in the figure, the strength condition is just…

A:

Q: A tapered steel member of length, / (feet) is subjected to external loading of 25 kips as shown in…

A:

Q: The rigid beam is supported by a pin at B and wires AD and CE. (Figure 1) The load P on the beam…

A: Objective: To determine the normal strain in wires AD and CE.   Given: Displacement of end A of the…

Q: В 4 30 k Figure 2-35

A: P

Q: Consider the pin-jointed truss as shown in figure below: A B D 30° 45° 90° 60° Coordinate direction…

A:

Q: Determine the force in each member of the loaded truss. The force is positive if in tension,…

A:

Q: Consider a rectangular cross-section beam having width b and height h that is taking bending load.…

A:

Q: A double tee cross section is used for the beam shown below. Assume the following lengths and loads:…

A: Moment of inertia (Iz) = 110 in.4 Determine the maximum tensile bending stress.

Q: The beam cross section shown below has been proposed for a short pedestrian bridge. The cross…

A: observe the diagram shown below carefully width of the web from end of pipe joint to point k =…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.