Determine blank diameter ?

Q: Q2/ A force P = 1 KN applied to a right bar suspended by three wires, as shown below. all wires are…

A:

Q: PROBLEM 3 3 Mechanical system consists of solid body 1 of mass mm which is connected by non-elastic…

A:

Q: A 3-cylinder, 22.86 cm by 31.75 cm, 4-stroke cycle Washington Tron Works Diesel engine runs at 400…

A: Given,  No. of cylinder, n =3  Diameter of the cylinder , D =22.86 cm Length of the cylinder , L =…

Q: For this overhang beam, draw the shear and bending moment diagrams. Determine the values…

A: In the given problem following steps will be followed. 1.Replace supports by reactions and determine…

Q: A simply supported beam of width 100 mm, height 200 mm and length 4 m is carrying a uniformly…

A:

Q: A rocket engine can generate hot gas conditions at the exit of the combustion chamber Po=100 atm, To…

A:

Q: (b) For the X-Z plane, i.e., between applied loads w₂, F₂, and Moy and the internal shear force V₂,…

A:

Q: A floor hoist supports an engine of weight WE 2.9 kN. As illustrated in the figure below, the floor…

A:

Q: A portion of the Fe-C equilibrium phase diagram is shown below. A steel containing 0.76wt% C is held…

A: Given: 0.76 % C steel held at 900 C and then cooled to 700 C To find : Change in structure during…

Q: etermine the specific speed by a pump delivering 5gpm when running at 1350 rpm if the head required…

A:

Q: Air is inside a compressor at 100 kPa and 13 C. It is isentropically compressed to 800 K, where the…

A: Data given: initial pressure =100kPa initial temperature = 13°C = 13+273 = 286K final temperature =…

Q: A shaft given in the figure has four masses of 200 kg, 300 kg, 400 kg and 200 kg, respectively. and…

A: Consider the balancing masses in plane L as and in plane R as .Represent the position of planes and…

Q: Prob 6 Draw the load and moment diagram of the beam shown: v (lb) 2 2400 3 2 2

A: Givenshear force diagram

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A:

Q: 5. A muon has a mass if 1.88x10-28 kg and impacts the Earth's atmosphere. It slows its travel from a…

A: Dear Student you have posted two different questions but as per Q & A guidelines I will solve…

Q: A 20 N collar slides with friction 0.3 along a Horizontalrod as shown. The spring attached to the…

A:

Q: PROBLEM 3 Mechanical system consists of solid body 1 of mass mm which is connected by non-clastic…

A: Given:The mass of the solid body 1, The mass of the disk 2, The radius of the disk The coefficient…

Q: If the velocity of water is 8 m/s and the pressure is 140 kPa on the discharge side of a pump. a.…

A:

Q: A Carnot power cycle operates on 3lb of air between the limits of 800°F and 600°F. The pressure at…

A:

Q: A monkey of mass m kg slides down a mass less rope attached to a fixed spring balance with an…

A:

Q: A mass m, of 100 kg travelling with a uniform velocity of 5 m/s along a line collides with a…

A: cofficient of restitution is zero, this is a case of perfectly inelastic collision. cofficient of…

Q: B/ Find the flow rate in units of L/s that an axial piston pump delivers at 1000 rpm. The pump has…

A:

Q: 4. Determine the x, y, z components of reaction at the ball-and-socket joint A and the tension in…

A:

Q: The following data was obtained from a tensile test on Load (kN ) Extension (mm) 16 32 56 72 95 110…

A: Given, Load (kN) Extension (mm) 0 0 16 0.2 32 0.4 56 0.7 72 0.9 95 1.5 110 2.5…

Q: A wall has a total of 2084 square feet. The insulated portion has R-15 insulation, but 4.2% of the…

A: The insulated portion has R-15. 4.2 % Of the total area has gaps of (R- 4.5) in the insulation. 15 %…

Q: Air flows into the duct of air-conditioner at 101 kPa and 10° C at a rate of 17 m³/min. The diameter…

A: Given data: P=101 kPaTi=10°CQ=17 m3/mind=23 cmQ˙=5 kW Need to determine the speed of air enters and…

Q: What is the maximum flexural stress develop? A 60 KN 20 kN/m B 40 kN C D -2m-2m-2 m-4m- 50 kN E 50…

A:

Q: 6. Obtain the dynamic equation of the system given below in terms of the position of mass M. tew…

A: The study of how moving objects act is known as dynamics. The branch of mechanics that analyzes…

Q: A rocket engine can generate hot gas conditions at the exit of the combustion chamber Po= 100 atm,…

A:

Q: A metal block of weight 10 N in air and 2N in water fully submerged in water. Given the density of…

A:

Q: If the Poisson's ratio of an elastic material is 0.6 the ratio of modulus of rigidity to Young's…

A:

Q: Determine the exit velocity of the steam.

A: Given; A small steam whistle( perfectly insulated and doing no shaft work)It causes a drop =0.8…