Determine Ax, Ay and NB, i.e. the horizontal and vertical components of reaction of the pin A and the reaction of the rocker B on the beam. Given: F.  Note: give answers in terms of F.

Q: Calculate the force and moment reactions at the bolted base O of the overhead traffice-signal…

A: Given:The mass at the point A is the mass at point B is The mass of member OC is the mass of member…

Q: Q.5) A crank mechanism is supported by a spring and bearings B and C. Bearing B does not exert any…

A: Given: To find: Minimum force P Normal reaction at D

Q: Q.4) The rod is supported by journal bearings at A, B and C and subjected to a force of 500 N (in…

A: Given F=500Nθ=45°M=400N.mRod is supported by the jornal bearing A,B,C As we had drawn the free body…

Q: For the same truss in the previous question, and using the Method of Joints, the forces in members…

A:

Q: 7 kip 10 kip 2 kip 5kip -8 ft -6ft- -6 ft- A 0.5 kip 6 ft B

A:

Q: Problem #2 Given: Two roughnecks apply forces of equal magnitude 500 N to the torque device shown…

A: To Draw:  The F.B.D of member ACB. Free body diagram  The F.B.D of ACB is,

Q: A 16 lbs cylinder rests in the trough shown. Assume that the contact surfaces are smooth…

A:

Q: 1000 N 90 2000 N 90 1000 N 90 90 90° 130° 30 GG 12 m 12 m 12 m 1000 N

A:

Q: D. C E. L, y= B L, w Find the magnitude of the horizontal and vertical components of the pin…

A:

Q: For the frame shown in figure below. Determine the reactions at A, C, and F. 30 kN/m 15 kN/m C D 3m…

A: For the frame shown in figure below. Determine the reactions at A, C, and F.

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.