determine a. ID. b. VDS. c. VGG.

Q: In complete model the reverse resistance provide pass to( ........)

A: Given: In complete model the reverse resistance provide pass to( ........)

Q: It is desirable to attach the electronic circuitry to a substrate material that is the best for…

A: Solution- The best substrate material is Aluminium Oxide (Al2O3). The thermal conductivity of…

Q: The platinum RTD has been connected to the wheatstone bridge circuit represented by R3 with Vin =…

A:

Q: 202 Open with Google Docs 3. The network of Figure below is the basic biasing arrangement for the…

A:

Q: V1 Si T1 120 Vrms 60 Hz 0, R1 S2.5kO 4:5 Determine the following using 2nd approximation a) VDC b)…

A: as per our company guidelines we are supposed to answer ?️only first 3️⃣ sub-parts. Kindly repost…

Q: (b) Design a 20V D.C. power supply using full-wave rectifier(s), a transformer (220Vms SOH2) and a…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: For the PN junction under sun light, the short circuit current amount is Isc. Please sketch the I-V…

A: We need to sketch the I-V curve of PN under the sun based on that under the dark condition above…

Q: ollowing circuit. Use diode constant voltage drop (C Vị V

A: If the diode current is positive then it is called as the diode is forward bias and if the diode…

Q: B) The interface shown can be used for low current LEDs. Assume the LED voltage drop is 2.5 V. The…

A: Given: with R= 5 K Ohm, VDD = 5 V, LED voltage drop = 2.5 V, PPO = 0.4 V when LED is on. To find:…

Q: 1-) demodulating using carrier signal 2-) demodulation using envelope detector 3-) demodulating…

A: (1) Demodulation is the technique to extract original information signal from the carrier waves. A…

Q: Find for the given npn BJT circuit: Ip, Ic, lg. VCB, B VBE = 0.7V VCC = 8V R 470n R 8 V Vec 4.7 kn…

A: so we will apply kcl to find the required voltage and current.

Q: The circuit below was connected to investigate the relation between the voltage and current in the…

A: Part (a): When VD = 0.57, ID = 1.54 mA RD1=VDIDRD1=0.571.54RD1=0.370 kΩ When VD = 0.66, ID = 51.1…

Q: H.w1: Determine the following for the network below: a) IDQ and VGSQ. b) VD. For the n-channel…

A: Given IDSS = 8 mA VP = -8 V

Q: DE NG 4. Discussion: Phase Lead Compensator Prove mathematically the effect of compensator at the…

A: Given: Phase Lead Compensator.To prove: The effect of compensator at the system and its comparison…

Q: For the given circuit find the VRL Voltage of the load; VR Voltage in the resistance R; Iz Current…

A: Given:A Zener diode voltage regulator circuit, with To find:Voltage of the load, ,Voltage in the…

Q: For the circuit shown find: a. Power consumed in RL b. DC voltage of current source Ip dc. c. Q…

A:

Q: Q3. State the main advantages and disadvantages of the dual-slope ADC circuits.

A: In the question, advantages and disadvantages of a dual slope ADC circuit is asked.

Q: A-) Explain with the help of diagrams the structure and operation of Hybrid (Magic) Tee

A: A tee in microwave use to connect a section of waveguide in series or parallel to the main…

Q: Determine the average voltage

A:

Q: Q3.A. State the main differences between PLA, PAL and PROM? Ans.:

A: here we have to write the differences between the PLA , PAL , PROM.

Q: A single-phase full-wave rectifier produces a fix output Vo(avg) = 197 V from an AC (a) source of…

A: In this question,  If variable output voltage 197V of full wave rectifier.  To become variable…

Q: Q1) What is the value of Vout for each branch of the circuit? Vz= 10 v , V barrier = 0.7 || V 1 KO…

A: " Since you have asked multiple questions, we will solve the first question for you. If you want an…

Q: What are Linear Voltage Regulators? Give an example.

A: A linear voltage regulator maintain the steady output. Here resistance of the regular varies…

Q: c. The filter is a device that allows passing the dc component of the load and blocks the ac…

A: A filter circuit is an electronic device which blocks the ac component present in the rectified…

Q: VCC 24V 12v 3.5K VBB 40K 100 Q1) For the circuit, exactly find:- 1. VCEQ and ICQ and D.C load line…

A:

Q: which the voltage regulation is maximum and the value of this regulation.

A:

Q: lain operation Its app Discuss, how to work Limiter circuit in detail.

A: operation of the limiter circuit,   A circuit is formed public as a tool that limits some a part of…

Q: Consider the following circuit. Find the values of the voltages V.V and v, Find the currents in the…

A:

Q: Izl min=lmA ZDi Vzl=3.1V Iz2 min.=1.5mA The maximum power of each of the three zener diodes in the…

A:

Q: The filter is a device that allows passing the dc component of the load and blocks the ac component…

A: Rectifiers- Rectifiers are the one which are used to convert AC voltage into DC voltage. But the…

Q: The platinum RTD has been connected to the wheatstone bridge circuit represented by R3 with Vin =…

A:

Q: 2- The condition for modulator to work as 4Q balanced is : a. V, or V; Vr. d. Vi or V2> VT-

A: Choose the correct option What is conditions for the 4Q balance modulator?

Q: Q2/ D'Arsnoval moving coil meter that modified to measure AC current with full wave rectifier, if…

A:

Q: 4. BJT is considered as a device controlled by current while FET is a device controlied by.. .

A: BJT is considered as a device controlled by current because its output characteristics are…

Q: Based on the IV characterstic plots, what are the cut-off voltages of D1 and D2 in units of [V ]?…

A: The diode circuit is given as

Q: Electronics Question:- What is difference between "==" and "===" in behaviour modellina of verilog

A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static in…

Q: Upload your Transition Table here with the Equations being used...

A: As shown in figure,  D of first block is D=AX+BX similarly for second block D=AX And Y=(A+B)X these…

Q: QI: If an averaging d.c. Ammeter is connected in series with the Zener diode of circuit -Amp? Fig.…

A:

Q: Compute the Approximate output voltage of a PV cell. a. 0.5V b. 150V c. 15V d. 1.5V

A: We need to select correct option for pv cell .

Q: ") The circuit shown below contains an ideal emf device with emf & and a network with three…

A:

Q: 38 - Which element shows short circuit characteristics in AC analysis of transistor circuits? A)…

A: capacitive reactance is given by Xc=1/wC c- capacitance w-Angular frequency In a.c. analysis,…

Q: 2.48 With a 1-W load, the voltage at the terminals of a cer- tain voltage source is found to be 10.0…

A: In this question, we need to determine the source voltage, source resistance and terminal voltage if…

DC Series Motors

A DC motor is a type of electric motor which converts electric energy into mechanical energy. The forces that are produced by the magnetic field are what those common types of motors rely upon. Either electro-mechanical or electronic, all types of DC motors have some internal mechanism to change the current direction in part of the DC motors. As the DC motors could be powered from existing DC lighting power distribution systems, these motors were the first form of motors widely used. By changing the strength of the current in its field winding or by using a variable supply voltage, the speed of the DC motors can be controlled over a wide range.