Design a decanter to separate a light oil from water. The oil is the dispersed phase. Oil, flow rate 1000 kg/h, density 900 kg/m³, viscosity 3 mN s/m². Water, flow rate 5000 kg/h, density 1000 kg/m³, viscosity 1 mN s/m².

Q: A batch of wet solid whose drying rate curve is represented by the following Figure is to be dried…

A:

Q: 3. What effect does flowrate have on MS ionization efficiency with regards to capillary…

A: Charged molecule separation and analysis using capillary electrophoresis (CE) is powerful. CE…

Q: I have a stream with three components, A, B, and C. On a molar basis, the stream is half A, and the…

A: suppose total moles of input stream =1 moles then moles of A in input stream =0.5 moles moles of B…

Q: 5) What is the work-energy theorem? a states that energy is created, work is done b. C. requires…

A: According to the work-energy theorem, the net work done by the forces on an object equals the change…

Q: I finally convinced my leadership to get me a scale that had a little more precision in the…

A: To calculate the average amount of the chemical used and the uncertainty in that number, we need to…

Q: How was 146 degrees Celcius obtained?  I know how the 5250 mmhg was obtained.

A: Temperature corresponds to the vapor pressure of the n-hexane is to be calculated.

Q: For point 1, I cannot locate the humidity and enthalpy.  For point 2, I cannot locate the humidity…

A: we have to find the enthalpy and humidity ratio from the given graph by given vales

Q: 4. What is the value of P, if the value of A = 10 mole, B = 15 mole, C = 6 mole, D = 8 mole? H

A: From the diagram we can write that.. Input = output A= P + D P= 10 -8= 2 mole

Q: The dual combustion cycle uses a compression ratio of 12:1. The cut off ratio is 2:1. If the…

A: Give data The compression retio,(r)=12 The cut off redio= 2 The inlet temperature=273K The inlet…

Q: Determine the melting point of phenol at 500 atm.

A: Densities of solid phenol,ρsolid =1.072 gmlDensities of liquid phenol,ρliq =1.056 gmlenthalpy of…

Q: Find the necessary volume V of a CSTR for the following problem dm³ min C V = 10 CAO V = ? Ca = 0.1…

A: given = Vo = 10 dm3/minCA = 0.1CAOK = 0.23 min-1 To find = V =?

Q: Q2/ A triple effect backward feed evaporator are used to concentrate NaOH solution of 10 percent and…

A:

Q: Q1(mm): Evalute the following: (B.1) The gradients of f(x, y, z) = x²y³z4 at a point P(1,2,2). (B.2)…

A:

Q: Q3 A dryer must take up 400 lbm/hr of H2O. Entering fresh air at barometric pressure, 70 °F and 50%…

A: Volume of R per volume of P at given conditions is to be calculated.

Q: 6. For an enzymatic reaction that follows the Michaelis-Menten kinetic model, what is the percentage…

A:

Q: Q2 A steel cylinder contains ethylene (C₂H4) at 200 psig. The cylinder and gas mass is 372 lbm. The…

A: Initial Conditions of the Cylinder: Initial Pressure of the ethylene in the cylinder = 200 psig…

Q: A fuel - air mixture at 400K was burnt, the analysis of production gases shown as : the number moles…

A: To determine the equivalence ratio, type of fuel, and the limiting reactant, we need to analyze the…

Q: A distillation column contains a mixture of 60% benzene and 40% toluene, by mass, at 1 atm pressure.…

A: Mole fraction of benzene in feed, XF,B = 0.6 Mole fraction of toluene in feed, XF,T = 0.4 Feed rate,…

Q: P8-6 (4th edition) The elementary irreversible organic liquid-phase reaction A + B → C is carried…

A: Elementary  organic liquid phase reaction is given by A+B→C Under Adiabatic Conditions The equimolar…

Q: What is the oxidation number of the monoatomic ions of the following elements? Drag each item to the…

A:

Q: 9A.5. Estimation of the thermal conductivity of a pure liquid. Predict the thermal conductivity of…

A:

Q: 1

A: Two parallel steam chambers are connected by a valve. Volume of each chamber, V1 = V2 = V =28.32 m3…

Q: In an open vessel with a diameter of 0.3 m, there is water that evaporates into the atmosphere at…

A: Given = Diameter = 0.3 mT = 350Kx = 1 mmheight = 5 cmPAo = 41.8 kN/m2 (350 K)PT = 101.3 kN/m2DAB =…

Q: Reconsider Prob. 14–56. Using the EES (or other) software, evaluate the effect of pipe wall…

A: Diffusion rate of hydrogen through the walls of the pipe is to be calculated by varying the…

Q: In a heat exchanger That operates gaseous carbon dioxide enters steadily at 25°C and 5.1 atm, and an…

A:

Q: Explain the given diagram. Emphasize the process of distillation, cracking and reforming

A: The given image is of a distillation column which is a key unit operation in chemical engineering…

Q: If 1000kg/h of nicotine-water solution containing Iwt% nicotine is to be counter currently extracted…

A:

Q: Problem 30-1E. The photocatalytic tubular reactor shown in Figure 30-1E is used to decompose organic…

A: Note: Since you have posted a question with multiple sub parts, we willprovide the solution only to…

Q: Problem 29-6E. Natural gas from a "fracking" operation containing hydrogen sulfide vapor enters to…

A: A mixture of H2S and CH4 is contacted with a brine solution to separate the H2S from the mixture.

Q: Assuming the validity of Raoult's law, do the following calculations for the Denzene (1)/toluene (2)…

A: With Raoults law being valid , the tabulation is given (1) - Benzene and (2) - TolueneWe need to…

Q: Q5: In a closed vessel the 100 kg of steam at 100 kPa, 0.5 dry is to be brought to a pressure of…

A: given = mass of steam = 100Kg at 100 kPasteam is brought to a pressure of 1000 kPato find = mass and…

Q: 10.8 ARCRA landfill is characterized by diurnal variations in the volatilization of contaminants as…

A:

Q: 5. When 66g of CO2 and 3.0 g H₂ are placed in a 3.00 L container at 395°C, the following reaction…

A: Given that- Mass of CO2 =66 g Mass of H2=3.0 g Molar mass of CO2=44 g/moL Molar mass of H2=2 g/moL…

Q: Problem 6.3 The radiator of a steam heating system has a volume of 20L and is filled with…

A: The data provided are-Volume, ; as Initial pressure, Initial temperature, Final temperature,…

Q: A gas turbine engine is fueled with 3000 kg/h of methane at 15°C and 1000 kPa, and supplied with…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: How were the points determined on the isotherms?  Read the underlined sentence

A: The enthalpy of sulphuric acid solution at given temperature is to be determined.

Q: The vapor pressure of Substance X is measured at several temperatures: temperature -84. °C -70. °C…

A: The data for the vapor pressure and temperature is   Calculate the temperature in Kelvin scale and…

Q: For the following situations, state under what conditions the following equations would apply. Be as…

A:

Q: A     sphere     of     naphthalene     having     radius     of     4    mm    is     suspended…

A: Naphthalene (A) sphere is suspended in large volume of air (B) with following parameters,Radius, R =…

Q: The reaction rate constant for zero order reaction is 5 mole/(L.s) equivalent to... in kmole/m3.h?

A: The value of reaction rate constant is given as, k = 5 mole/L.sthe unit is to be changed from…

Q: For one of the following, determine the ratio of the fugacity in the final state to that in the…

A: given = T = 673.15 Kand Pressures drop from 9000 kPa to 3000 kPaTo find = fugacity ratio

Q: The reaction A+B→C+D is carried out at 80 °C in an isothermal, perfectly stirred tank batch reactor.…

A:

Q: wetted wall column is used to absorb NH3 by water

A:

Q: Type the answer (value only) in the boxes below for the following questions given the equation…

A: Given reaction is-The rate of disappearance of reactants and the rate of appearance of products are…

Q: Q5: Find the expression between the output concentration Y (t) and response time (t) for the tank in…

A: We need to find the expression between  the output concentration  y(t)  and the response (t)  for…

Q: Q5:Air flows inside pipe 12 cm diameter with mass flow 1.5 kg/min. 1-Is flow laminar or turbulent?…

A:

Q: A 1.5 mole sample of an ideal gas at 28.5 °C expands isothermally from an initial volume of 22.5 L…

A: moles of ideal gas, n =1.5 moleT = 28.5 + 273 = 301.5 KV1 = 22.5 LV2 = 75.5 LPext = 0.498 x 105 Pa

Q: 100 kmol-h-1 of a mixture containing 10, 20, 30, and 40 mol % of propane, n-butane, n-pentane, and…

A: A mixture of hydrocarbons is preheated and then fed o a flash separator.The operating temperature of…

Q: Consider the data in the table for the reaction at 45 °C in carbon tetrachloride solution. z(s) 0…

A: Average rate of reaction at each time interval is to be calculated.

Q: 6. Using the data in the table below, calculate the reactor volumes V₁ and V₂ for the plug-flow…

A: