Design a boost converter to provide an output of 18 V from a 12-V source. The load is 20 W. The output voltage ripple must be less than 0.5% and inductor current ripple less than 30%. The switching frequency is 25 kHz. Specify the duty ratio, the inductor size, and the capacitor size Assume ideal components.

Design a boost converter to provide an output of 18 V from a 12-V source. The load is 20 W. The output voltage ripple must be less than 0.5% and inductor current ripple less than 30%. The switching frequency is 25 kHz. Specify the duty ratio, the inductor size, and the capacitor size Assume ideal components.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Draw circuit for Boost Converter. Also derive its Output equation. What will be the value of Duty Cycle (D) if the input voltage is 50 V DC and desired output voltage is 20 V DC.
In the full-wave rectifier circuit of figure , the transformer has a turns ratio of 1:2. The transformer primary winding is connected across an AC source of 230V (rms), 50 Hz. The load resistor is 50ohms. For this circuit, determine the peak-to-peak ripple in the output voltage
is Idc -Idc 0 K de 27 If ripple-free load current in steady-state is assumed, the input current is waveform of the single-phase full-wave rectifier may then be depicted as shown in the figure above for an ideal input transformer. With the assumption that the supply is ideal and perfectly smooth and ripple free load current, which implies an infinitely large load inductance, it is quite straightforward to obtain an analytical expression for the input current harmonics. The rectangular wave is defined as when 0
A single-phase half wave uncontrolled rectifier circuit is operating with a purely inductive load and a source voltage of 100 sin (277t) V. An ideal PMMC ammeter is connected in series with the inductive load reads 20 A. Calculate the distortion factor of the rectifier. Answer Choices: a. 0.866 b. 0.707 c. 0.577 d. 0.816
electronic
DERIVE AVERAGE OUTPUT VOLTAGE EQUATIONS FOR 3-PHASE SEMI CONVERTERS.
Derive the average and rms values of output voltages and currents for three phase semi converter. Power Electronics
Example 3:-
3.
An unipolar PWM full bridge circuit has a Vr.rms of 125V at a duty cycle D1 of 0.7. What is Vd? What is Vo.rms?
The input voltage (vin) of the following circuit is a sinusoidal signal with an amplitude of 2Vrms,consider a silicon diode.graph the output voltage ?? and the current across the resistor.
The wave power per length is 1740 W/m, the device-width of the wave energy system is 5.1 m, the capture width ratio is 0.36, the rated power is 18608 W. Determine the percentage degree of utilization. O 14.59 O 17.17 O 15.45 O 18.88