Describe the strength values for various consistency of clay such as soft and stiff.
Q: The primary mineral found in sedimentary rock sandstone is: a. clay b. quartz c. halite…
A: This question related to Building Stone from Building Material . In this Question Ask about Primary…
Q: 4'-0" Nominal 5.25"- 5 @7.5" = 3'-1.5" 5.25" € 5.25" Voids 2" Topping 1.13" 1.75" 5.75" 1.13" 1.75"…
A:
Q: 7 The specific gravity and absorption test (ASTM C128) was performed on fine aggregate and the…
A:
Q: What is the rate of application of load on a compression perpendicular to grain test specimen?
A: Asked: To give the loading rate for compression perpendicular to grain testing of timber. The…
Q: I have been given a set of data from the lab on soil samples - performed triaxial test. I have a…
A:
Q: How does the deformation results in the soil?
A: Deformation in the soil is defined as the condition during which distortion or change in the soil…
Q: A clay sample was tested in the laboratory for unconfined compressive test. Determine the undrained…
A: Given data in question Clay sample Unconfined compressive strength test was performed. Unconfined…
Q: what type lf clay is used in the foundry industry
A: It is asked to explain what type of material(clay) is used in foundry industry. So it comes under…
Q: Sandstone samples were collected from an underground mine and a laboratory investigation was…
A: Given Data: Uniaxial compressive strength σc=165Mpa.Uniaxial tensile strength σt=18Mpa.To Determine:…
Q: How is a universal sand strength testing machine determine the tensile strength, of molding sand?…
A: The qualities of sand or molding sand for casting are assessed using sand testing procedures. Just…
Q: Please calculate the clay content %, this w%
A: Given the table, Sample number 1 2 3 Mass of empty, clean can (grams) 3.47 3.69 3.75 Mass…
Q: Several buildings have foundations made of material such as concrete. In fact, the compressive…
A:
Q: 3. Why andesites are undesirable as crushed stone aggregates.
A: the secondary products of andesite influence greatly its mechanical properties they have bad effect…
Q: Explain the interlocking behavior of sand and its effects on the stress-strain behavior of sand?
A: Soil is one of the most dubious, variable, and uncertain materials which shows the wide variation of…
Q: A dry sandstone sample of diameter 22 mm and length 35 mm weighs 32 g. the sample is crushed and a…
A: Pycnometer method is used for the determination of specific gravity of dry soil sample. It is a very…
Q: Find 4 published values for bulk density for small coarse aggregate, and quote their references.
A: Four Values of Bulk density of small coarse aggregates are: The approximate bulk density of…
Q: What are the reason for the difference in behavior between clay and silt?
A: The reason for the difference in behavior between clay and silt are : 1- Clay particles are smaller…
Q: An 8 meter high granite column sustains an axial compressive load of 500kN. If the column shortens…
A:
Q: granular materials
A: true
Q: Explain the types of clay minerals as the silica tetrahedral sheet.
A: The clay minerals are found to have following two fundamental building blocks : 1- Silica…
Q: Proposed fill Fine to medium . sand (SW) Dr = 80%* Medium clay (CH) y = 100 lb/ft³ Cc/(1+ eo) = 0.18…
A:
Q: less clay content in aggregate lead to enhance ... ...... ....
A: Less clay content in aggregate lead to enhance the workability of concrete, performance, quality and…
Q: What are the major types of metamorphic rock used in building construction?
A: Answer Metamorphic Rock= Metamorphic rock is formed by the metamorphism of the parent rock. so the…
Q: Which of the following(s) is/are the significant source of compression when loading is applied to a…
A: Which of the following(s) is/are the significant source of compression when loading is applied to a…
Q: If you have 3/4-inch NMAS with a dry rodded unit weight of 93 lb/ft^3,a fineness modulus of 2.5 for…
A: Nominal maximum aggregate size (NMAS) = 3/4-inchDry rodded unit weight = 93 lb/ft^3Fineness modulus…
Q: 1- The reason of place the weights over CBR sample to ......curve 2- The relationship between…
A:
Q: Calculation: Compressive Strength (CS) = P/A Where: CS = compressive strength of the specimen, psi…
A: given- Gross Area data- Net Area data-
Q: What are the forms in which clay is found?.
A: Solution: Clay minerals are basically form under the limited range of the condition of geology.The…
Q: What is the axial stress at failure in an unconfined compression test?
A:
Q: 1.7 The compressive strength of a stone under the conditions of absolute dryness and water…
A: Solution:- Given details: Compressive strength under absolute dryness, Rdry=178 MPa Compressive…
Q: A series of unconsolidated undrained (UU) triaxial compression tests have been performed on two…
A:
Q: What properties and characteristics are used to identify a limestone sedimentary rock? Be specific
A: sedimentary rock is the type of the rock which is formed by the decomposition of rock fragments into…
Q: Briefly describe the three forms clay can be found in with supporting examples.
A: Clay are generally form when rock comes in contact with water, air, and strem. There are two types…
Q: In a concrete mix design (at oven dry condition), the amount of water needed is a function of…
A: In a concrete mix design ( at oven dry condition) ,the amount of the water needed is a function of…
Q: Which state describes soil that does not show cracks when deformed (choose correct state that…
A: Liquid state is that state of soil in which soil behaves as a liquid and has negligible shear…
Q: which of the follwoing(s) is/are the significant source of compression when loading is applied to a…
A: which of the follwoing(s) is/are the significant source of compression when loading is applied to a…
Q: What volume of solid material is present in one cubic meter of sandstone if the porosity is 20% ?
A: Given, Porosity (η) = 20% or 0.20
Q: How does the water molecules become attracted to the clay particles?
A:
Q: This is the moisture content when permeable voids just filled with water.
A:
Q: What are the “building blocks” of most clay minerals? Comment on the comparative length–…
A: Clay minerals are crystals formed from soluble products of primary minerals. The kind of clay formed…
Q: 1: B: The specific gravity and absorption test was performed on fine agg ollowing data were…
A: Given data A-Mass of dry sand=495.5g B- Mass of pycnometer with water only=623.0g C-Mass of…
Describe the strength values for various consistency of clay such as soft and stiff.
Step by step
Solved in 3 steps
