Describe the different types of domestic solid waste.

Q: 3. A hard drive manufacturer uses Nickel to plate its disks and then polishes them, resulting in a…

A: Given data, Flow rate = 50,000 gallons /day Nickel concentration = 50 mg/l Industrial permit for…

Q: If the BOD5 of waste is 75 mg/L and the k is 0.150 d-1, What is the ultimate BOD?

A: BOD (Bio-Chemical Oxygen Demand) is defined as the amount of oxygen demanded by the microorganisms…

Q: Calculate actual draft of a Carding m/c for mechanical draft=80, Waste extraction=9%, Lap hank is…

A: Given:-          Mechanical Draft = 80          Water Extraction = 9%          Lap Hank = 0.0011…

Q: hoose the correct answer Which of the following can be used to determine the transport velocity of…

A: Question is multiple choice type . Question is based on  landfill leachate in surface. Transport…

Q: Summary: Because of the amount of handling that occurs during material production, within…

A: 1.hot-rolled bars of AISI 1020 and 1040 steel Both of the bars are hot rolled.Both of the bars are…

Q: differences and similarities with solid and hazardous waste

A:

Q: Q4 Estimate the energy content of a solid waste sample with the composition below and what is the…

A: The solid waste is important in evaluating the needs of equipment's, system and the management…

Q: The eight categories of waste and examples as it relates to a University are

A: Introduction- Waste is defined in lean manufacturing as anything that does not add value to a…

Q: Question 4. Consider the liner system at the base and on the side slope of a landfill in figure…

A: All of these components which are used in slope landfillGeotextileGeomembraneGeonetCompacted clay

Mechanical Processes

In civil engineering, the materials have to undergo a series of manufacturing processes before using them in construction and structural applications. These manufacturing processes form the foundation stone of mechanical processes. Some of the civil engineering materials such as bars, metallic beams, metallic columns, surveying equipment, earthmovers, overhead cranes, structural and construction components, and even cement that is the most fundamental construction component need to undergo different manufacturing processes before they are ready to use. These processes are mechanical.