Define the site for a wind farm?

Q: Note: (Draw T-S diagram, take Slale Tu Q1/ Consider a steam power plant that operates on a reheat…

A:

Q: Problem 18 %. The overall efficiency of an electric system, coal pile to lights a lamp is What…

A:

Q: Example 2.8 Consider a regenerative cycle using steam as the working fluid (see Figure 2.12). Steam…

A: The stepwise procedure to solve this problem is shown in the following attached images:

Q: how hydropower water turbine energy refinement is useful and efficient to the environment

A: Given question: how hydropower water turbine energy refinement is useful and efficient to the…

Q: A Three stage

A: Given data: The atmospheric pressure is PATM = 1.013 bar. The atmospheric temperature is TATM = 15…

Q: What determines the cut off point in performance of wind turbine

A: Turbines cut in and cut off speeds are determined by the manufacturer to protect the turbine from…

Q: The lap joint shown in fig. Is fastened by FOUR 20-mm diameter rivets. Assuming that p = 50 kN,…

A:

Q: Q1- Draw the wind turbine power curve characteristics and discuss the regions of the curve. What is…

A: INTRODUCTION: Wind turbines are a significant source of renewable energy generating, by increasing…

Q: Quation 2 Siven According to figure 1, Given data as (COP)Hp =3.5, Q= 90000 KJ/h (rate) and 1KW =…

A:

Q: What is probable length of blade if the wind turbines are separated with the distance of 200 m?

A: The spacing between two wind mill is around 3 to5 times the diameter of blades. Therefore, S=3D to 5…

Q: ON TWO A gas-turbine power plant operating on the simple Brayton cycle has a pressure ratio of 7.…

A:

Q: purpose of wind power system (whole) ?

A: Given Wind power system To find Purpose

Q: Why renewable energy sources are called sustainable? List out any two reasons why they are…

A: Renewable energy sources lend themselves well to sustainable development, especially when compared…

Q: Which of the following is the Camot Efficiency? work input /work output (input temperature - output…

A: Carnot efficiency: It is maximum efficiency of a thermodynamic cycle. Heat input and heat output is…

Q: Discuss Uniform temperature loads (TU)

A: Temperature loads over a structure can be uniform in nature which is base upon specific field of…

Q: Main Components of wind power system (whole)?

A: given; ⇒main component of wind power system (whole)?

Q: Discuss the basic operating principle of Internal combustion engines (ICE) we are currently using…

A: The ICE or internal combustion engines are the engines in which the combustion of fuel take place in…

Q: Why Blade Numbers are essential and needed to be considered in establishing the design of a wind…

A: Blade Number in wind turbine: Blade number refers to the count of blades attached to the rotor hub…

Q: Define the ENERGY CONVERSION EFFICIENCIES.

A: The energy conversion efficiency:- Energy conversion is basically the transfer of energy from one…

Q: Seaside wind power generates total power of 418 KW with 12 wind turbine installed, what is the…

A: Total power generated, P = 418 KW  No of installed wind turbines, n = 12

Q: Question: 3 Consider the cylinder of reciprocating internal combustion engine, as shown in Fig. 1.…

A: Given , Reciprocating engine cylinder. Crank length = a Connecting rod length = l

Q: a) Piston movement causes the flywheel to rotate, which generates electricity. What causes the…

A: In IC engines (Internal Combustion), energy generated is intermittent. Only during the combustion…

Q: 6. A6-m³ tank contains helium at 400 K and is evacuated trom atmospheric pressure to a pressure of…

A:

Q: With a aid of a diagram briefly describe how wind energy is generate

A: A wind turbine with two or three blades are used to generate electricity. Power is generated through…

Q: Hydro Tasmania has initiated the Battery of the Nation (BotN) strategic initiative to investigate…

A: Disclaimer from Bartleby:Hello. Since your question has multiple sub-parts, we will solve the first…

Q: A steam power plant as shown in Fig. operating in a Rankine cycle has saturated vapor at 3.0 MPa…

A:

Q: For the Venturi meter shown in the figure, the deflection of mercury in the differential gage is…

A:

Q: Subject - Evaluate the factors that inform the selection of a renewable energy system in relation to…

A: Introduction: Renewable energy technology consists of ecofriendly technology where output of the…

Q: Dry air enters an inclined pipeline in the upward direction being an inner diameter of 0.3 m and a…

A: The inner diameter of the pipe is d=0.3 m The total length of the pipe is l=5 m. The inclination is…

Q: 3. An engine operating on the air standard heat engine, initially at 1.02 bar and 23 °C is…

A: Write the given data. P1=1.02 barT1=23°CP2=21 barT3=940°C Here, P1 is the pressure before…

Q: Which of the following is the right .4 ?one

A: This question is based on the concept of dry bulb temperature and wet bulb temperature from…

Q: problem Show that Cg = F where: Cq= Isothermal Compressibility Coefficient psi'

A: Solution: To Derive:

Q: How to extract geothermal energy ?

A: Geothermal energy is natural heat energy that is obtained by the earth. This is an eco-friendly and…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.