Decide whether each of these statements is True (T) or False (F). The Figure shows a ladder diagram rung for which: (i) The input contacts are normally open. (ii) There is an output when there is an input to the contacts.Required to answer. Single choice.

Q: QUESTION 8 What electronic element can be used as the switching device for a 120 VAC discrete output…

A: Ans: Triac PLC outputs are of two general types: Relay and  Solid state Relay outputs are…

Q: 4)Comparison instructions A)may be combined in AND (series) as well as OR (parallel) configurations…

A: To execute the comparison instructions, the combination of the AND and OR gates is required. The OR…

Q: QUESTION 5 Determine the gate output for the input waveforms in Figure3 and draw the timing diagram.…

A: Given waveform with the logic circuit,

Q: (a) Construct a transition table and state graph for the circuit shown in Figure 5. Is the circuit a…

A: Moore circuit is the finite state of circuit . whose current output value are evaluate current…

Q: voltage regulator is a device that maintains a fix what

A: voltage regulator is device that maintains constant voltage irrespective of input voltage variations…

Q: of the following statements is true for an SCR. It is an on-only controllable switch, which is…

A: There are three types of switches: Uncontrolled switches : In these turn on and turn off can not be…

Q: In an on/off control systems, to prevent rapid switching of control valve position an upper and…

A:

Q: Consider the block diagram of system shown below. A zone sensor act as an input to the switching…

A:

Q: The circuit in Figure Q4 (c) consists of edge triggered flipflops. The second flipflop receives the…

A: Give the circuit: 1. We need to define clock skew. 2. We need to explain with a timing diagram,…

Q: A PWM signal is required for a motor controller. The PWM is generated by a TPM in a KL25Z. The…

A: It is given that: Time Period= 10 msDuty Cycle=50 %