3. Calculate the BHP of the system feed pump with the described details:Total feed water mass flow rate = 100,000 Ib/hrSuperheater Outlet pressure: 600 psigDC heater pressure = 50 psig,!3!• Assume: pump efficiency of 70%, water is at saturated conditions, ignore headpressure from DC heater, and no friction loss going to feed pump.What is the steam flow required with the above BHP and a Stream Rate of 25 lbs /HP-hr (this includes Ah of steam into and out of the turbine and turbineefficiency)

TO given thatwater mass flow rate,m=100000Ib/hr=12.5998KG/Sout let…

DC heater pressure = 50 psig, Assume: pump efficiency of 70%, water is at saturated cor ressure from DC heater, and no friction loss going to feed What is the steam flow required with the above BHP and a S

DC heater pressure = 50 psig, Assume: pump efficiency of 70%, water is at saturated cor ressure from DC heater, and no friction loss going to feed What is the steam flow required with the above BHP and a S

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A Liquid dominated Geothermal PP, single flashed separator receives water at 255° C, the pressure at the separator is 1.21Mpa, the direct contact condenser operates at o.05Mpa, assume a turbine polytropic efficiency of 78%, for a plant output of 35MW, find the mass flowrate of ground water. (kg/sec)
A refrigerant 134a of a vapor compression refrigeration system includes a liquid-suction heat exchanger. The heat exchanger cools saturated liquid coming from the condenser from 45 °C to 37 °C with the saturated vapor which comes from the evaporator at -8 °C. Calculate: a.) The COP of the system without heat exchanger. b.) The COP of the system with the heat exchanger. c.) Find the percent increase of performance of the system with the heat exchanger based on the system without heat exchanger. d.) Draw the schematic and P-h diagram of the two set-up.
I. Draw the h-s & T-s diagram of the system below CONSIDERING "WORK IN" AS PROCESS 1-2. 2 POUT BOILER TURBINE SUPERHEATER EVAPORATOR ECONOMISER PUMP Differentiate state, process and cycle. II. IN 4 ⓇOUT CONDENSER
What is the answer of the following asked: (need solution ASAP, thank you)The heat rejected in the condenser in kJ/kg is:The net work in the turbine in kJ/kg is:
! Room sat.liquid 50C Condenser Compressor stage 2 OValve Q2- Find the coefficient of performance for the fallowing cycle and coefficient of performance of simple refrigeration cycle for same temperatures at evaporator and condenser R-134a sat. vapor -20C Flash Mixing chamber chamber Sat. liquid -20°C Compressor stage 1 O Valve Evaporator sat liquid -40C Cold space
Please solve using the methodology (Given, find, schematic diagram, solution and discussion)! Please! A deaerator heater supplies 150 L/min of deaerated feedwater into a booster pump at 115°C pumping temperature. The heater pressure is maintained at 100 kPag by bleed steam. Pump centerline is located 1.0 m above the floor level. Suction line losses is 0.60 m. Determine the minimum height of water level in the heater that must be maintained above the centerline of the pump to avoid cavitation, if the pump to be installed has a required suction head 5.8 m. (PV = Psat at 115°C; Pv = 172 kPa)
5. In a Stirling cycle with an ideal regenerator, the volume varies between 0.03 and 0.06 m2, the maximum pressure is 2 atmosphere, and the temperature varies between
The efficiency of the heat engine is 36 %. The COP of heat pump is.
Q1/ Refrigeration unit using R-134a as shown in figure below contains two compressors and two evaporators . the first evaporator is used for getting low temperature operate with temperature of (-20°C) and 20 ton refrigeration capacity , the second evaporator is use for cooling air purpose operate with temperature of (10°C) and 10 ton . condensing temperature is (40°C) , calculate 1. Power required 2. C.O.P 5 Condenser 9. Wen -4 Evaporator - II Compressor - II Compressor - I E Eтарогator- I Wa
Exercise & with a beat capacity at constant pressure = 4.10³ kJ K², is initially at the outside air temperature T. 305 K. An air conditioner, which dithermal reversible cyclic manner Coutside air and room), brings the temperature of the operates in a 293k) in one hour. power P must have received A N = = mo ruum, 4 room to 20⁰°c CT₂ What average This air conditioner? Please answer the above question step-wise, showing detailed explanations, including diagrams if necessary. Thanks in advanced !!!! B electrical MARKU