D. Determine the adequacy of the tension members of the determinate bolted truss shown below based on the service loads shown. Use A-50 Steel. Hint: There are three tension members in the truss.

Q: C 15 ft D 74.4 A 30 ft B 30 ft 6.5 7.3 5.4 30 ft E 5.6 F 8.7 G 6.7 30 ft H/3.9 I|4.4 15 ft 15 ft J…

A: Consider the following diagram: Each borrow pit has been marked with a number.

Q: ∆VB answer is not correct. could u pls check again?

A: Given: Require: Additional load on wheel B correctly  Note:The calculation done by previous expert…

Q: Estimate the diameter of an asphalted cast iron pipe carrying water with a flow rate of 1.18 ft/s,…

A: From Continuity Equation Q=AV V=Q/A=…

Q: The following net accumulations were calculated. The free haul area begins at station 4+30 and…

A: Given Data: The free haul area begins at station 4+30 and continues to 14+30.   To Determine: The…

Q: Calculate the end areas for depths of fill from 0 to 20 ft using increments of 2 ft for level…

A:

Q: lem 3.46 - Enhanced - with Flints and Feedback ch spring in (Figure 1) has an unstretched length of…

A:

Q: Q2. After surveying a borrow pit, the surveyor produced the following pit grade below. What is the…

A: Given figure-

Q: A laser scan of a pavilion's roof is performed, and the point cloud data is obtained. The roof of…

A: 1) To calculate the surface area of the pavilion's roof, we can consider it as two triangular faces…

Q: 2. A stone A is dropped from rest down a well, and in 1 second another stone B is dropped from rest.…

A:

Q: A pipeline carrying water has an average height of irregularities projecting from the surface of the…

A: Average height of irregularities projecting from the surface of the pipe,h= 0.155 mmFor pipe surface…

Q: Describe the “Core runs” and tell its length.

A: The Core run is the actual depth or length of penetration of the driller. It includes both, the…

Q: Sieve 3/8 inch 4 10 40 100 200 mydrometer d (mm) 9.52 4.75 2 0.425 0.15 0.075 0.04 0.01 0.005 0.002…

A: Given data:

Q: The following data are cross-section notes of the ground which will be excavated for a roadway…

A: Given Data:     It is asked to find area of excavation using end-area method.

Q: Compute the average end volume Sta 25+00 2,875 2,502 3,336 Sta 25+75- 107' A₁ 125' (in cubic yards -…

A:

Q: An averaged vitrified sewer pipe (n = 0.015) is laid on a slope of 0.0002 and is to carry 2.36 m3/s…

A: Given: Manning's constant, n = 0.015 Channel slope, S = 0.0002 Discharge, Q = 2.36 m3/s Pipe flow, h…

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.