(d) In an experiment to standardize a solution of sulphuric acid, using a standard solution of sodium hydroxide, the following results were obtained. 25.00 cm³ of a sodium hydroxide solution containing 20.00 g dm³ required 23.6 cm³ of a sulphuric acid solution of unknown concentration, for complete neutralization. Show clearly how to calculate the concentration of the acid in both mol. dm³ and g. dm³.

(d) In an experiment to standardize a solution of sulphuric acid, using a standard solution of sodium hydroxide, the following results were obtained. 25.00 cm³ of a sodium hydroxide solution containing 20.00 g dm³ required 23.6 cm³ of a sulphuric acid solution of unknown concentration, for complete neutralization. Show clearly how to calculate the concentration of the acid in both mol. dm³ and g. dm³.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

What is the correct volume of 2.5 M PhMgBr in THF is needed to completely react with 1.5 mL of methyl benzoate? You do not need to consider an excess and should calculate (and choose) the minimum amount as required by the reaction stoichiometry). Enter your answer to one decimal place WITH the proper unit of measurement.
Suppose the fluid in the stomach of a man suffering from indigestion can be considered to be 250.mL of a 0.063 M HCl solution. What mass of NaHCO3 would he need to ingest to neutralize this much HCl ? Round your answer to 2 significant digits.
1) A 1.20 gram sample of ammonium phosphate is dissolved in 100. mL of water. The solution is poured into 50.0 mL of a 1.5 M magnesium nitrate solution. What mass (g) of solid product will be produced if the reaction runs to completion? Concentration of M of NH+4NH4+ (M)? Concentration of M of PO3−4PO43− (M) Concentration of M of Mg2+Mg2+ (M) Concentration of M of NO−3NO3− (M)
By titration it is found that 114.3mL of 0.562M NaOH is needed to titration 48.0mL of Hcl. what is the concentration of the HCl in molarity?
During a titration the following data was collected. A 50.0 mL portion of H2SO4 was titrated with 0.500 M KOH. 200. mL of the base was needed to neutralize the acid. Calculate the molarity of the acid
A student weighs out a 3.48 g sample of manganese(II) chloride, transfers it to a 125 mL volumetric flask, adds enough water to dissolve it and then adds water to the 125 mL tic mark. What is the molarity of MnCl, in the resulting solution?
1 A 185.0 mL sample of 1.200 M Pb(NO3), is mixed with 73.50 mL of 1.500 M NaCl, and the PbCl, precipitate is filtered from the solution. Then 200.0 mL of 3.000 M NaBr is added to the remaining solution, and the PbBr, precipitate is also collected and dried. What is the mass (in grams) of the PbBr, precipitate, assuming the yield in each precipitation step is 100%? F1 Q 2 F2 W 211 # 3 80 F3 E $ 4 NOV 20 a F4 R 475 % F5 T A 6 tv ♫ c F6 Y Ⓒ & 7 Ni F7 U 8 DII F8 ZA | ( 9 C
Calculate the molarity of the student's sodium hydroxide solution. Be sure your answer has the correct number of significant digits.
By titration, it is found that 66.3 mL of 0.116 M NaOH(aq) is needed to neutralize 25.0 mL of HCl(aq). Calculate the concentration of the HCl solution.
if 23.1g of NaOH ( MM= 40.00g/mol) are added to a 500ML volumetric flask, and water is added to fill the flask, what is the concentration of NaOH in resulting solution?
2) Determine the molarity of a solution formed by mixing 8.56 g KIO; with sufficient water to obtain a total volume of 2000. mL.
A 0.205 g sample of a monoprotic acid was dissolved in 25 mL of water. The acid solution was titrated to its endpoint with 28.1 mL of 0.0788 M NaOH solution. What is the molar mass of the acid?