(D) For the network in Figure (8), find: 1) The total impedance Z, and total admittance Y 2) The Quality factor (Q). 3) The power factor of the network and indicate whether it is leading or lagging. R9.11 Z7 V = 60 VZ30 X 12n YT Xc = 121 Fioure (8)

(D) For the network in Figure (8), find: 1) The total impedance Z, and total admittance Y 2) The Quality factor (Q). 3) The power factor of the network and indicate whether it is leading or lagging. R9.11 Z7 V = 60 VZ30 X 12n YT Xc = 121 Fioure (8)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Find the total impedance ZT in polar form b. Draw the impedance diagram c. Find the current I and…

Q: Ipp 4.5826A Vpp 27.496V IRMS 1.6251A VRMS 9.7504V Av -1.9923pA VAV -11.953pV fi 100.00HZ v 100.00HZ…

Q: Find the current and voltages Vr,Vl and Vc in phasor form. 2. Verify the kirchoffs volatage law…

A: Obtain the circuit impedance Z, Z=R2+XL-XC2 =18002+2000-6002 =18002+14002 =5200000 = 2280.35 Ω=…

Q: 1) For the circuit in Figure, what is the value of S1, S2, S3, S4 and ST? Response format: a complex…

A: Given loads are 1. (100+55) kW =155 kW at 0.6 power factor (lagging) 2. 200 kVAR at 0.8 power factor…

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

Q: In RLC series circuit, if the voltage across capacitor is greater than voltage across inductor, then…

A: Series RLC circuit- Applying KVL we get-

Q: 13. List the formulas for the Ohm's law used in the analysis of RC circuits. 1. Describe the phase…

A: In this question , some part related to seriss RC circuit and parallel RC circuit is given...We have…

Q: impedance of a series RC circuit is given as (8- j6) ohms and is connected to an ac source of…

A: In this question , we will find capacitive reactance...

Q: The active and reactive powers of an inductive circuit are 60W and 80VAR respectively. The power…

A: According to the question we have to find the value of the power factor.

Q: i, = 3 sin(377t + 60°) R1.2 N XL 1.20 Ω Χ. 20 Xc

A: The solution is given below

Q: noninductive load with a resistance of 30 Ω is connected in series with a capacitor. The capacitor…

Q: For the two coupled branches shown above, Za = j2, Zb = j4 & Zm = j2. Find Yb O a. j O b. j0.25 O c.…

A: We need to find out admittance for given impedance.

Q: ANSWER THE FOLLOWING PROBLEM: MAKE SURE TO SHOW YOUR COMPLETE SOLUTION AND ANSWER MUST BE IN FOUR…

A: In this question we have given three impedance in parallel ... We have to find out resultant power…

Q: uestion 3 nt) - 60cos(200t+50) - 50sin(200t+40") + 15cos(200t) a. Combine the above three sinusoidal…

A: GivenV(t)=60cos(200t+50°)-50sin(200t+40°)+15cos(200t)

Q: Determine the power factor of the system with v(t) = -120sin(wt - 30)V and i(t) = -12sint(wt - 50)A.…

Q: A. Find the total impedence Zt in polar form. B. Draw the impedence diagram. C. Find the current and…

Q: Apply a sinusoidal input voltage with 2V p-p and vary the frequency according to the table below.…

Q: For the circuit shown, ZL = 21 - j45 N. What component is needed to form impedance ZpFc in parallel…

Q: A 5+j1552 15-j5r

A: Given data, Circuit diagram is given as,

Q: Component values of the following circuit are listed in the Table I. Answer the following questions…

Q: 12. Derive the following. Assume an ideal current source a. frequency response b. input impedance…

Q: AV X ms Soru 3) Yukarıdaki grafikte periyot T-76 ms ve iki işaret arasında X=8 ms zaman farkı…

Q: Three Impedances each of (8 - j24)N are connected in mesh across a three-phase 420V ac supply.…

A: Calculate the above parameters

Q: Q-9) The current source the circuit shown in Figure below supplies 131.16-j36.048 VA and the voltage…

Q: For the next three items, consider a series R-L-C circuit energized by a sinusoidal voltage source…

A: In this question, we need to determine the phase angle between voltage and current. Also need to…

Q: For the coupled circuit shown, find the 12 J52 A J82 value of mutual inductance "M" and put the dots…

A: The solution is given below

Q: 1. Draw an RLC parallel circuit and draw current triangle (using phasor representations) if source…

A: In this question we will describe parallel RLC circuit...

Q: b) Derive the formula for total voltage and impedance for series RC circuit. Find the equation of…

Q: Given a delta wye circuit with L=265mH, C=27uF, f=60Hz, and R=100Ω, complete the table and find the…

Q: L=0.15H R = 120 VR- C=100uF V=100v f=50HZ

A: Series RLC circuit

Q: Two impedances 2+j4 and r+j0 are connected in parallel. Determine R so that the PF of the circuit is…

Q: What is the difference between in-phase and out of phase Impedances. What are the first order…

A: Impedance, denoted Z, is an expression of the opposition that an electronic component, circuit, or…

Q: Given v₁ = 20sin(wt +60-) and v2 = 60cos(wt -10-), determine the phase angle between the two…

A: Given data, V1=20sinωt+60° VV2=60cosωt-10° V

Q: Using what you have learned constructing the phasor diagram for the LRC series circuit, construct a…

Q: mpedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

Q: An impedance draws a current i(t) = 10sin (wt-30°) ampere from a voltage v(t) = 220cos(wt-65°)…

Q: The 3-phase power equation in terms of phase voltage and phase current is VLI_Coso /3VplpCoso…

A: Power in in terms of phase voltage and phase current is givan as P=3VpIpCOSΦ

Q: For the circuit: a. Find the total impedance Zr in polar form. b. Find the value of C in microfarads…

A: Given RLC series circuit shown

Q: A source delivers 50-kVA to a load with a power factor of 65percent lagging. Find the load’s average…

A: The fraction of complicated power that belongs to energy storage and retrieval rather than…

Q: How to solve for a (+) Phase Sequence and (-) Phase Sequence? Give an example and explain the steps.

A: When a unsymmetrical fault occurs in the system then system becomes unbalanced. To understand the…

Q: Perform the following operations a) (6.21 + j3.24) + (4.13 - j9.47). b) (-24 + j12) - (35 - j16) -…

A: It is given that:

Q: Q: For the following SLD, take Sg = 100 MVA and VB = 22 kV at Bus 1 to: 1. Draw the impedance…

A: 1)To find the per unit impedance on given base of 100 MVA and 22 kv - Per unit impedance of…

Question

(D) For the network in Figure (8), find:
1) The total impedance Z, and total admittance Yr.
2) The Quality factor (Q).
3) The power factor of the network and indicate whether it is leading or lagging.
R9.10
ZT
V = 60 VZ30
X= 120
Xc = 120
Figure (8)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the given circuit: a.Find the total impedance ZTin polar form. b.Find the current I and the voltages VRand VLin phasor form. c.Find the power factor of the circuit, and indicate whether it is leading or lagging.
and the new peru impedance of the motor is a load absorbs 50 MVA at 0.8 pf leading at line to line voltage of 18 KV. find the perunit impedance of this load on a base of 100MVA and 20 KV. Select one: O a. 5.183 - j 3.888 pu O b. 5.183 + j 3.888 pu O c. 1.295 - j 0.972 pu O d. 1.295 +j 0.972 pu O e. None of these
please answer d-e
Reply as soon as possible and clearly, do not use italics 1) For the circuit in Figure, what is the value of S1, S2, S3, S4 and ST? Response format: a complex number in rectangular format. 2) What is the power factor of the circuit? (Response format for power factor: a number real rounded to two decimal places) and What is the value of the impedance seen by the source? ( Response format for impedance: a Complex number in rectangular format.)
For the circuit shown below, determine the total impedance and current
Draw an RLC parallel circuit and draw current triangle (using phasor representations) if source phase is o degree and the source current is leading source voltage 30 degrees. Draw voltage and current phasor diagram for circuit.
Please do it fast please
Impedances Z1 = 5.83 at angle of -59 deg. and Z2 = 8.94 at an angle of 63.43 deg. are in series and carry an effective current of 5A. Determine the Power and power factor of the circuit indicating if it is leading or lagging.
For the network shown in figure . determine the imput impedance ,out put impedance, Noltage gain , cuent gain and source Voltage gain by using complet hybrid equivalent modle if hie = l.6k2 hve =2*10 hfe =110 and ho = 20 us -12 V 1ouf 3 Kohm 1kohm 8-2 Kohm luf V =10 mU 3 kohm
Problem: Five linear components of complex impedances Z1, Z2, Z3, Z4 and Z5 are connected as it is shown in the circuit bellow. They are supplied by a sine wave voltage source U. Z1 Z4 Il Z3 13 Z2 Z5 If it is known that: Z1 Z3 Z4 Z5 II 13 Ω Ω Ω Ω A A 30 + j5 30 + j10 30 + j15 0+ j25 0.470 - jo.114 0.002 - j0.007 A) Find the average power that each component dissipates; B) Find the average power absorbed by the circuit; C) Verify the results.
Solve all the 3 subtparts
4) Given: R = 700-N, Xc = - j 500-N, e(t) = 150 sin(wt) V Find: a) Total impedance of the ckt. b) Total current in phasor and sinusoidal form c) Voltage drop across the resistor and capacitor in phasor and sinusoidal form d) Total Power and Power factor