cycle of a periodic waveform. By a simple inspection process, list the lowest five froquencies (including de if present) in the spectrum. 7-02a

Q: A sinusoidal signal passes a continuous time LTI system, the output is O another sinusoidal signal…

A: The solution is given below

Q: Identify the Peak value of the given waveform. 3 2 1 B -1 -2 -3 -4 O a. 8 O b. -8 O c. 4 O d. 0

A: Given waveform:

Q: How many sine waves are necessary to create a square wave that is "square"?

A: Square wave is the periodic waveform that is non-sinusoidal and can be interpreted as an infinite…

Q: What is the RMS value of the square wave with an amplitude of 50 A and a period of 20 ms shown…

A: Given data, Waveform is given as,

Q: 6. A periodic voltage has the following voltages: 15 V at 0.02 sec, 9 V at another 0.05 sec and 0 V…

A:

Q: Problem 5 Determine the period in ms, frequency in Hz, amplitude in volts, and phase in degrees (vs…

A:

Q: A certain waveform has a form factor of 2.3 and a peak factor of 3.5. If the maximum value is 100…

A:

Q: For the given waveforms, waveform C the waveform D and E. lags leads Degrees 30 60 90 180 210 540 M

A: For the given waveforms, waveform C ..... the waveform D and E

Q: What is the period of the sinusoidal waveform having 100 MHz frequency.

A: We know that the period can be calculated as : T=1f where, T is the time period, and f is the…

Q: The term used to describe a dc value (other than zero) that acts as the reference for a sine wave…

A: An ac sinusoidal signal has both positive and negative half cycles and zero average value.

Q: The periodic of a sine wave is 2ms. The frequency will be: 500.0 Hz a. 5.0 Hz b. 50.0 Hz C. 0.5 Hz…

A: Given, Time period of sine wave is T = 2 ms

Q: Find Co for the waveform shown: 3. -3 -2 -1 4 6. 8 -3 Select one: O 0.75 O -1.5 O 1.5

A: Co is the average value of signal in per unit time    Co =1T∫-T2T2 x(t)dt here T is the time period…

Q: Calculate the fastest rise time a sine wave can have to be reproduced by a CRO, if the bandwidth…

A: Given, For a CRO, the bandwidth ranges from 0 Hz to 10 Hz.

Q: At 50 cycle, a sinusoidal current has a magnitude of 3A at 3.55msec. Its maximum value (in vols) is

A: In this question we will find maximum value of current and time period of circuit....

Q: What is the phase difference between a cosine and sine waves? a. 2pi/3 b. pi/ 4 c. pi/ 2 d. pi

A: Let V(t) = Vm sin(wt) The above function can written as, V(t) = Vm cos(wt - 90°)

Q: HW 1- For the following waveform, determine the average and effective values. 1 cycle 10 () -10

A:

Q: Waveform A Waveform B Given the drawing above, the phase shift between Waveform A and Waveform B is:…

A: Given waveform Asked ti find the phase difference or phase shift between A and B?

Q: 1- For the following waveform, determine the average and effective values.

A: 1- The average of the above waveform is Vavg=110∫02-10dt+∫24 4dt +∫46 0dt +∫68 -2dt+∫8100dt…

Q: coil of watt meter is connected in series.

A: Fill the blank Which coil of Wattmeter is connect to series?    as per our guidelines we are…

Q: In a Negative going pulse waveform, the falling edge is the leading edge and the rising edge is the…

A: When it comes to a pulse, it has two edges: The initial edge of the pulse is called the leading edge…

Q: A function x with the following equation: | 2,0<x<3 (x)= -2,-3<x<0 _Period 6 Draw a symmetrical…

A: Property of symmetric waveform  Amplitude of positive and negative wave will be same Duration of…

Q: Find the period of a waveform given by i = 50 sin( 377t-30° ) amperes

A:

Q: Determine the fundamental period of the following: 1. cos 0.01an 30n. 2. cos 105 3. cos 3nn 62n 4.…

A: In this question,  Find the fundamental period of the following signals. Time period N= 2πm/n where…

Q: If e = 300 sin 157t, how long (in seconds) does it take this waveform to complete 1/2 cycle? %3D

A:

Q: 5. Calculate the r.m.s. value, the form factor and peak factor of a periodic voltage having the…

A: The waveform for alternating current is given below: Since, it is not sinusoidal but it is…

Q: kr = Eripplerms/Eave,

A: Equation of line with slope is- y=y2-y1x2-x1x+C

Q: I: An incoming sine wave results in a gain of -5db. The output sine wave has a peak value of 1V.…

A: Given Data: An RC High Pass Filter has, Peak Output voltage Vb=1 V Voltage gain AV=-5 dB To Find:…

Q: Find the ff: a. Peak Value b. Peak-to-Peak Value c. Period of the Waveform d. Frequency e. How many…

A:

Q: Given i(t)=5 cos (400t - 120o) A, determine the period and frequency of the current waveform?

A: The general expression of a sinusoidal current waveform is given as

Q: W nat IS tne angulal I1 having period of 1 msec

A:

Q: In a periodic process,the number of cycles per unit tume is called

A: For a periodic process, The cycle is defined as one complete wave. And, the period (T) is defined as…

Q: Question a, Draw a sine wave with a frequency of 250 Hz that lasts for a duration of 12 ms and…

A: Given a sinusoidal signal of 5V. f=50 Hz

Q: Assume you digitize a periodic waveform that has a frequency of 8kHz at 100 Msa/s . How many times…

A:

Q: CRO cannot be used for measuring the Sinusoidal waveform's frequency. Select one: O True False

A:

Q: What will be the average value of given waveform: V +15V 0.2 0.6 0.8 1.2 t(s) -3Vt---

A: Average value of any function f(t) is defined as, f(t)T = 1T∫0Tf(t)dt, Where T is the time period of…

Q: An alternating voltage is given by v1 = 75 sin( 200 Ttt -0.25 ) volts. What is the phase angle…

A: Answer :- 14.324°

Q: Sketch the resultant wave form when the following two pulses meet. (Assume the meeting point…

A: Generally, pulses are the representation of the signal shows its nature, amplitude, frequency, etc.

Q: A pure sine wave with no phase shift sin(a) reaches its maximum value at Select one: O a. 0° Ob.90°…

A: V(t) = sin(Alpha)

Q: • Calculate the average and rms values of the following periodic voltage signal. V(1) in volt 300…

A:

Q: Question 7 What is the frequency of a periodic wave that has a period of 3 minutes O5.55 mHz 55.5…

A: Time period T=3 minute =3×60=180 sec.

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.