COORDINATES. Determine the lengths and 14. RECTANGULAR bearings of the sides of a tract of land whose corners have the following X and Y coordinates: A(-105.45 m, -127.96 m); B(-289.63 m, -9.05 m); C(+512.50 m, +404.23 m); D(436.70 m, -59.92 m); dingly. and E(-5.52 m, +7.34 m). Tabulate values accor-

Q: A triangular lot ABC has a bearing and distance of line AB to be N 40deg E and 800m and CA equal to…

A:

Q: Where is the southwest corner of Section 32, T1N, R1E, Humboldt Meridian located? O About 2 miles…

A: The Humboldt meridian in California longitude 124° 07' 10" west from Greenwich, common points the…

Q: MEASURING ANGLES WITH TAPE. The measure 1063.55, 1840.33, and 1325.05 m. sides of a triangle…

A:

Q: (6 pts) The property below is to be subdivided so that the parcel labeled 1 must contain 6 acres.…

A: Given: The property below is subdivided so that parcel labelled 1 must contain 6 acres.    To Find:…

Q: Find the area (in ha) of a closed- polygon traverse whose corners have the following X and Y…

A:

Q: Q.4. Compute by DMDs the area in hectares within a closed-polygon traverse ABCDEFA by placing the X…

A:

Q: 6. The two frontage corners (A and D) of a large tract of land are joined by the following open…

A: Azimuth is the angle made by the line in a clockwise direction with respect to the vertical line in…

Q: determined that the elevation of point R

A:

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.