Convert the following. Show all necessary solutions. 1. 67 miles = 2. 34ft 3. 50 yards cm(centimeter) Km(Kilometer) _mm(millimeter) %3D %3D

Q: 2. In the calculation of the area of the same square measuring: 5.0 cm ±.05 cm by 5.0 cm ±.05 cm,…

A: The area of square is, A=a2 Here, a is the side of the square.

Q: Express the following in scientific notation and indicate how many significant figures each has. a.…

A: Scientific notation and indicate how many significant figures each has. a. 5780.0 b. 0.008401 c.…

Q: A house is 45.0 ft long and 30 ft wide and has 9.0 ft-high ceilings. What is the volume of the…

A:

Q: Question 1 Solve the system of equations below for x. Assume that a=7.75, b=6.87, and y=2.51. Ca = x…

A:

Q: 1. Calculate a: 8 cm U a 5 cm

A:

Q: How much longer (percentage) is a one-mile race than a 1500-m race ("the metric mile")? Use the unit…

A:

Q: 3. Perform the indicated operations: (All answers should be expressed in scientific notation. Apply…

A: (a) solution- (4.0× 10-⁶ )×(3.0×10⁴) = 4.0× 3.0 × 10-² =12.00× 10-² 12.00× 10-² have 4 significant…

Q: O The speed in km/min equal to 78.0 mi/h O The area in ft? of a rectangle with sides 18.6 m and 3.82…

A:

Q: n (h) = nl0)e - (6.676 » 1023)(9.8) (8) -25 = (2.445×10°5)e (1.31 - 10*)( se0) (2.45- 105) e 2.127…

A:

Q: 3) Find B and 0 for B with components Bg = 75.5 m and By = 6.20 m. Draw a diagram and label your…

A: Given data *The horizontal component of the magnetic field is Bx = 75.5 m *The vertical component of…

Q: How many significant figures are there in 100cm? a) Unlimited b) ambiguous c) 1 d) 3

A: significant figures in 100 cm .

Q: The Mechanic’s Rule for approximating √a, a > 0, is given as attached. Where x1 is an…

A: Step 1: Given: xn+1=12(xn+axn), n=1,2,3,.... is the Mechanic's rule for approximation  awhere a>0…

Q: 4. One million seconds are how many days? Challenge Problems: 5. How many feet are in 25 kilometers?…

A:

Q: Which of the below expressions meets the requirements of using scientific notation? Select one: O a.…

A: Introduction: Scientific notation is a way of expressing numbers that are too large or too small to…

Q: 5) The B has a component B, = - 2.10 meter and B, = -1.70 meter Find angle 6. Draw the diagram and…

A: Given Bx= -2.1 m By= -1.7 m

Q: Find the ratio of A1÷A2 in the attached figure.

A:

Q: In the figure shown below the ratio "sin 03/sin 0," 03 02

A:

Q: A lecture period (50 min) is close to 1 microcentury. (a) How long is a microcentury in minutes?…

A: (a) Let t denotes the microcentury. Therefore, the microcentury can be determined as,     Thus,…

Q: Use dimensional analysis to sole the following problems. A sign in a town gives the speed limit at…

A: Given data:  Speed (v) = 50.00 km/hr Required: Speed in cm/sec

Q: 1) Perform the indicated mathematical operations. State the uncertainty of the final answer as ±…

A: In the given question, the calculations can be performed as,

Q: Help on calculating this and with setps to help understand. Thanks

A: Step 1: Given, the corner of the room is taken as origin So, the coordinate of origin = (0, 0).And a…

Q: A tank is filled with water to various depths, h. The pressure, P, at the base of the tank is…

A: Here question 1 has 7 subparts in the first image. Where in second image, Q1 has 8 subparts and Q2…

Q: ㅋ multiplying through out by 7. 18.2 (11.9 13 + 15) + 7×11.2 1₂ = 7x9 294.98 13 - 210 13 - 210…

A:

Q: Determine the centroid coordinates (x̄ , ȳ) for the solid and homogenous section shown in Figure…

A: To determine the centroid co-ordinate?

Q: 48. You are working with the formula V = ²h. You are given values of r= 1.00 ft and h = 2.00 ft.…

A: Detailed solution of given question is given in below steps.

Q: 6. The diameter of a spherical bob is a vernier callipers. 9 divisions of the the vernier callipers,…

A:

Q: Question 3 ( quantity is measured by two different methods and the values and standard deviations…

A: The value is the average of two values.

Q: Given that 1 treky is equal to 7.08 x 10 yards. How many Gm are there in 81.0 treky? Report your…

A:

Q: 17. 1.2 x103÷ 2.5 x 109 = ? A. 4.8 x10-13 B. 4.8 x105 C. 3.0 x 10-13 D. 3.0 x105

A:

Q: 4. Convert these dimensions in 3 significant figures; a) 350 lb fto N-m b) 350 lb/ft to kN/m³

A:

Q: If velocity v=at + Bx-yxt, then find dimension of a, ß and y.

A: The dimension of a physical quantity is defined as the power to which the fundamental quantities are…

Q: OA. 4 3 B. · TD 3 4лD² O C. D3 OD. I -D³

A:

Q: Measurement Directions: Read and analyze the questions carefully. Write the letter of the correct…

A: As per our guidelines, we are supposed to answer only first three subparts in case of multiple…

Q: Express the following quantities in standard decimal form and indicate how many significant figures…

A: Given values: a. 4.56×10-3 b. 0.08120×105 c. 4.56×104

Q: Consider the following equation: F = G mm₂ r² (Note: [F] = ML/T², [m₂] = [m₂] = M, and [r] = L) For…

A: The equation of the gravitational force is expressed as F=Gm1m2r2

Q: A rectangle has length 3.24 m and height 0.532 m. To the correct number of significant figures, what…

A: To Find the correct number of significant figure in the area of a rectangle. We know a rectangle has…

Q: How many square kilometers

A:

Q: Solve the formula for the specified variable. Gm,m2. d2 F = m1 (physics) m1 = Solve the formula for…

A:

Q: Convert 2.87 m/s to mile/hour, the answer is (1 m 39.37 in and 1 mile = 5280 ft)? (q239) a) 00.11 b)…

A:

Q: eview: Trigonometric Ratios in a Right Triangle 2 ease answer the following question(s): Calculate…

A:

Q: etermine (a) the x, y, z components of the 200 N force in g. P1.3, (b) the angles Ox, Oy, and 0z…

A: components of a vector is obtained by resolution of vector

Q: The following lengths are given in meters. Use metric prefixes to rewrite them so the numerical…

A: (a) 7.59 x 107 m = 759 x 105 km = 759 x 100 km = 75900 km    (b) 0.0074 m = 0.0074 x 1000 mm = 7.4…

Q: A, = -4.00 km, A, = -8.00 km. Express your answer in kilometers. Vo AEO ? |A| JÄ = km

A: In component form, a vector A→ can be written as A→=Axi^+Ayj^ Where, the magnitude of the vector,…

Q: A. Volume: Table A.l: Volume of cube Length Measuring Instrument Height (em) Width Volume (em) (em)…

A: The Volume of the cube  a) When measured through Meter stick Volume=length×Breadth×height…