Conventional current (the movement of hypothetical positive charges) goes through a light bulb from: O the high V side to the low V side and loses electric energy in the process the high V side to the low V side and gains electric energy in the process the low V side to the high V side and gains electric energy in the process the low V side to the high V side and loses electric energy in the process

Conventional current (the movement of hypothetical positive charges) goes through a light bulb from: O the high V side to the low V side and loses electric energy in the process the high V side to the low V side and gains electric energy in the process the low V side to the high V side and gains electric energy in the process the low V side to the high V side and loses electric energy in the process

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 41P: Lightbulb A is marked 25.0 W 120. V, and lightbulb B is marked 100. W 120. V. These labels mean that...

See similar textbooks

Similar questions

The immediate cause of many deaths is ventricular fibrillation, an uncoordinated quivering of the heart, as opposed to proper beating. An electric shock to the chest can cause momentary paralysis of the heart muscle, after which the heart will sometimes start organized beating again. A defibrillator is a device that applies a strong electric shock to the chest over a time of a few milliseconds. The device contains a capacitor of a few microfarads, charged to several thousand volts. Electrodes called paddles, about 8 cm across and coated with conducting paste, are held against the chest on both sides of the heart. Their handles are insulated to prevent injury to the operator, who calls Clear! and pushes a button on one paddle to discharge the capacitor through the patient's chest Assume an energy of 3.00 102 W s is to be delivered from a 30.0-F capacitor. To what potential difference must it be charged?
Consider the circuit shown in Figure P20.52, where C1 = 6.00 F, C2 = 3.00 F, and V = 20.0 V. Capacitor C1 is first charged by closing switch S1. Switch S1 is then opened, and the charged capacitor is connected to the uncharged capacitor by closing S2. Calculate (a) the initial charge acquired by C1 and (b) the final charge on each capacitor. Figure P20.52
Consider the circuit shown in Figure P26.24, where C1, = 6.00 F, C2 = 3.00 F. and V = 20.0 V. Capacitor C1 is first charged by closing switch S1. Switch S1 is then opened, and the charged capacitor is connected to the uncharged capacitor by closing Calculate (a) the initial charge acquired by C, and (b) the final charge on each capacitor.
Some camera flashes use flash tubes that requite a high voltage. They obtain a high voltage by charging capacitors in parallel and then internally changing the connections of the capacitors to place diem in series. Consider a circuit that uses four AAA batteries connected in series to charge six 10-mF capacitors through an equivalent resistance of 100 . The connections are thenswitched internally to place the capacitors in series. The capacitors discharge through a lamp with a resistance of 100 . (a) What is the RC time constant and the initialcurrent out of the batteries while they are connected in parallel? (b) How long does it take for the capacitors to charge to 90% of the terminal voltages of the batteries? (c) What is the RC time constant and the initial current of the capacitors connected in series assuming it discharges at 90% of full charge? (d) How long does it rake the current to decrease to 10% of the initial value?
Residential building codes typically require the use of 12-gauge copper wire (diameter 0.205 cm) for wiring receptacles. Such circuits carry currents as large as 20.0 A. If a wire of smaller diameter (with a higher gauge number) carried that much current, the wire could rise to a high temperature and cause a fire. (a) Calculate the rate at which internal energy is produced in 1.00 m of 12-gauge copper wire carrying 20.0 A. (b) Repeat the calculation for a 12-gauge aluminum wire. (c) Explain whether a 12-gauge aluminum wire would be as safe as a copper wire.
Why do we need to be careful about work done on the system versus work done by the system in calculations?
A 4.00F capacitor and a 6.00F capacitor are connected in parallel across a 600-V supply line, (a) Find the charge on each capacitor and voltage across each, (b) The charged capacitors are disconnected from the line and from each other. They are then reconnected to each other with terminals of unlike sign together. Find the final charge on each capacitor and the voltage across each.
The batteries of a submerged non-nuclear submarine supply 1000 A at full speed ahead. How long does it take to move Avogadro’s number (6.02 1023) of electrons at this rate?
A battery is used to charge a capacitor through a resistor as shown in Figure P27.44. Show that half the energy supplied by the battery appears as internal energy in the resistor and half is stored in the capacitor. Figure P27.44
A prankster applies 450 V to an 80.0F capacitor and then tosses it to an unsuspecting victim. The victim’s finger is burned by the discharge of the capacitor through 0.200 g of flesh. Estimate, what is the temperature increase of the flesh? Is it reasonable to assume that no thermodynamic phase change happened?
4) In the figure below, battery Bị is recharging battery Bz. The current through B, and the potential across B2 may be (a) 3 A and 4 V. (b) 2 A and 5 V, or (c) 6 A and 2 V. Rank these pairs of values according to the rate at which electric energy is transferred from B1 to Bz, greatest first. B1 B2
As the electric charges travel around the circuit they lose electric potential energy. As electrons move through the wire, they collide with atoms. Their average kinetic energy remains constant. why ??????