consumes 1 bbl (42 gallons) of industrial fuel of 25 OAPI at 27 oC in amo unt

Q: In the cooling curve shown, the heat of fusion would be used to calculate the energy released in the…

A:

Q: Given the ultimate/gravimetric analysis of coal as follows: C=81.95%, H2 = 4.63%, S=0.96%, N2=1.3%,…

A: Carbon (C) = 81.95%Hydrogen (H2) = 4.63%Sulfur (S) = 0.96%Nitrogen (N2) = 1.3%Oxygen (O2) = 5.75%Ash…

Q: Liquid fuel with 76% C, 3% S, 12% H in its composition is burned in a steam boiler as complete…

A: To calculate the amount of actual specific air (SA), we need to use the equation: SA = (n x (O2 +…

Q: QUESTION 3 12%, oxygen 8%, and the remainder ash. Calculate: The percentage analysis, by mass of a…

A:

Q: If the air-to-fuel ratio for propane is 17.16, the combustion in this process will be called O rich…

A: The stoichiometric air-fuel ratio for propane is 15.67:1.

Q: Which of the following can be used as fuel in compressed form? a. Petrol b. Natural Gas c. Coal d.…

A: Natural gas is fuel mainly consists of hydrocarbon which is found naturally. It's main component is…

Q: weight. C = 67 %, Ash = 5 %, Moisture = 8%, N = 6%, H = 3 %, Sulfur = 7%, = 4%. Calculate the…

A:

Q: In the absorber and evaporator of LiBr-H2O absorption system, low heat flux leads to Select one: O…

A: Option c is correct.

Q: Illustrate, Label and Discuss the following on fuel processes: a)Distillation

A: given; Illustrate, Label and Discuss the following on fuel processes: (a) Distillation

Q: Please solve the Problem 1 elaborately, use other shortcut Methods you have or you may Solve both or…

A: Problem 1:- Given that, Fuel=C5H8Mass of fuel, mf=0.18 kg,Excess air=42 %   Theoretical air: Writing…

Q: SUpplied to the system equal to 125 BTU. Calculate A thermal efficiency of a combustion chamber…

A:

Q: 25°C and 90%RH.

A: Consider 70% Sulfur is burned in excess air supplied   at rate of 5m^ 3 /kg of Sulfur at 25 ^ 0 * C…

Q: How do you call the heating value of the fuel if the water in the products of combustion is in the…

A: Higher calorific value/ Gross calorific value:

Q: 2. Propylene gas was fed in a cutting torch at 298 K, 1 atm. It was burned with 200% stoichiometric…

A: In case (a), the inlet air temperature is 298 K and in case (b), the inlet air temperature is 400 K.

Q: How the Road Octane Number is different from Research Octane Number and Motor Octane Number? For a…

A: given; How the Road Octane Number is different from Research Octane Number and Motor Octane Number?…

Q: 1.A boiler burns fuel oil with 20% excess air. The fuel oil may be represented by C15H32.Calculate…

A: Given data: excess air=20% Need to determine the air fuel ratio by weight.

Q: I need the answer as soon as possible

A:

Q: C₂H, is burned at an actual AFR of 15 kg fuel/kg air. What percent excess air or deficient air is…

A:

Q: 2. Liquid hydrocarbon fuel, C16H43 is burned with 25% excess air. Calculate the actual air fuel…

A:

Q: . Liquefied petroleum gas contains 7% propene, 52% propane, 11.2% butene and 29.8% butane. Determine…

A: The composition of LPG fuel is 7% propene, 52% propane, 11.2% butene, 29.8% butane.

Q: Which of the following material cannot be used as a moderator?

A:

Q: Calculate the amount of air in kg necessary for combustion of 1 kg of octane (C8H18) with 30 %…

A: Calculate the amount of air in kg necessary for combustion of 1 kg of octane (C8H18) with 30 %…

Q: 2) The gas which may be used as a fuel gas gas welding process is O Hydrogen Oxygen O Nitrogen…

A: In gas welding there are two types of cylinders are used that is acetylene cylinder and oxygen…

Q: Gasoline having a chemical formula CaH17 is burned in an engine at a fuel-air equivalence ratio o…

A:

Q: A fuel has the following constituents: carbon 85%, hyrdogen 13%, oxygen 2%. When burning this fuel…

A: GivenC=85%H=13%O=2%air supply is 50% in excess

Q: Part 1:Design a three-component gasoline blend. Specify the boiling temperature of your…

A: The objective of the first part of the question is to design a three-component gasoline blend and…

Q: 5. Calculate the theoretical air/fuel ratio by mass and the percentage composition of the products…

A: According to terms and conditions of bartleby we can only provide 1st solutions (Q5). Thank you !

Q: A GACEOUS FUEL WAS REPORTED to HAVE THE TOLLOWING VOLUMETRIC ANALYCIS: 84.1% 6.7% CH4 0.8% 8.4% CO2…

A: Given that, Volume fractions,CH4=84.1 %,C2H4=6.7 %,CO2=0.8 %,N2=8.4 %, Write the chemical equation…

Q: Explain the process of a Rankine. List the types of fuel used

A: To explain the Rankine cycle:

Q: Given the ultimate/gravimetric analysis of coal as follows: C-81.95%, H2 = 4.63%, S=0.96%, N2-1.39%,…

A: Carbon (C) = 81.95%Hydrogen (H₂) = 4.63%Sulfur (S) = 0.96%Nitrogen (N₂) = 1.3%Oxygen (O₂) = 5.75%Ash…

Q: Meth anol is burned in an with air at an equi valence ratio of $ =0.7s. Write the balanced chemical…

A: Given: The equivalence ratio is 0.75.

Q: Calculate the energy contained if 500 kg of PMMA burns, assume the caloric value of PMMA is 24 MJ/kg…

A: Calculate the energy contained if 500 kg of PMMA burns, assume the caloric value of PMMA is 24 MJ/kg…

Q: Explain the process of Off-stoichiometric combustion (OSC)?

A: Given Data : Process of off-stoichiometric combustion

Q: Calculate the electricity energy required in units of D for desalinating 150 w of water and it takes…

A: The amount of waterV=150 l=0.15 m3 The electricity for per unit of water 3.70 kWhm3

Q: What is the maximum amount of energy released when a 5 kg sample ofcoal from McDowell, West Virginia…

A: Write the higher heating value of coal from McDowell, West Virginia. HHV=36.2 MJ/kg

Q: the air - Q₂) Find the stoichiometric air-fuel ratio for the combustion of C8H18 in petrol engine.…

A:

Q: Can you write a small research on the Applications of Hydrocarbon Fuels?

A: Hydrocarbon fuels are adaptable items utilised in every end-use sector, including residential,…

Q: Describe what is done in the combustion process in the combustion chamber of a gas turbine to…

A: The compression system of a gas turbine engine feeds high-pressure air to the combustor or…

Q: The enthalpy of combustion, when all the water formed during combustion is in liquid phase is known…

A:

Q: Show the complete combustion equation and calculate the minimum amount of air (in kg) required for…

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.