Construct the influence diagrams for the reactions at A, B, and C, and the shear and moment at a point 3 meters from the leftmost end of the beam shown below. Compute the maximum value of each function resulting from a moving concentrated loads of 90 kN and 60kN, 1.5 m apart. B 1.000, 4.000 4.000 7.000 3.000

Q: The force F₁=50 N points to the East. The second force F2=100 N made with the first force an angle…

A:

Q: 10KN/m 15KN 3.00 4.00 1.00 1.00 SKN/m

A: In the given beam there is no longitudinal load so that there will not be any horizontal reaction in…

Q: The influence line for the reaction at B for the beam shown changes curvature between A and B;…

A: Given that there is curvature change between points A and B.

Q: I. Find the reaction at fixed end II. Find the reaction at the fixed end MA III. Find the shear…

A: My dear Given A cantilever beam LOADING 1) UDL 2) MOMENT Dear, according to guidlines of bartleby i…

Q: For the beam shown, calculate the reactions. Calculate the moment at point C. Also, calculate the…

A: We need to find out reactions, moment at C and shear at C

Q: Solve the reactions of the support by Double Integration and Three Moment Equation.

A: To determine:The reactions of the support by Double Integration Note: Since you have posted multiple…

Q: D 2m

A: Sign convention used for ILD:Influence line for reaction is positive if the reaction acts upwards.…

Q: 2.12 One end of a timber roof truss is supported on a brick wall but not securely fastened. The…

A: To find magnitude of force F1 And F2 and R

Q: Determine the reaction at the roller support. Ans.: Blank 1 N Determine the moment reaction at the…

A:

Q: 600N 15° 400 N B 4 m 8 m

A: The free body diagram of the beam is given below.

Q: | 5.14 Assuming that the reaction of the ground is uniformly dis- tributed, draw the shear and…

A: A beam with load arrangement is given as shown in the figure above and it has been asked to…

Q: 80 mm. @ A E B D 170 mm 125 mm C 75 mm ✓ PROBLEM 6.85 Determine the components of the reactions at A…

A:

Influence Lines

The graphs that show the variation of a function at a specific point on a beam or truss due to a unit load placed at any point along the structure are known as influence lines in engineering. Some common functions that are studied with influence lines are shear, moment, and deflection. In designing beams and trusses, it is important to use influence lines in structures where loads would move along their span such as bridges, crane rails, conveyor belts, floor girders, etc. The influence lines help to study where a load will create the maximum effect for any of the functions.