Considesing the relationshb Tas =dU+ befween the enry(s), interred enegy (U), poresscre (p), temferafure (T) 8& Volume (v). which af the following. Sktement is cosvect ? (a) T4 is epplicable only fa Roteversible porore (b) for an irreversible process, TdS7dU .ic) It is Velid.only for an id eal. gay (d) It is equivalent to 1 t lauwifor a revesisible paocess

Q: 27. You have the following compound machine. 60 teeth 40 teeth 20 teeth a. What is the speed of Gear…

A:

Q: The beam AB is homogeneous and has a mass of 5,191. The tension in the cable of the crane can not…

A:

Q: (Compute) What is line OA's direction cosine angle, in degrees, from the y-axis (θy)? Note that…

A: The cosine angle between two vectors  is as followes,

Q: Question Completion In the figure below, which of the following represents the dedendum? zeta gamma…

A: Circular pitch is the distance measured from a point on one tooth to the corresponding point on the…

Q: Draw the orthographic views of the following isometric figure.

A:

Q: why is the angle 26.56 and then you use 22.56

A:

Q: create 2 fourbar designs that include the dimensions and angle of motion

A: It is asked to draw four bar mechanism with given motion

Q: The figure shows a shaper machine that uses Whitworth quick return mechanism wherein the different…

A: Given Data OA=75cm OP=50cm CA=150cm CD=135 cm

Q: I didn't understand how you fond the angle teta

A: For solution refer below images.

Q: A) Draw the two limiting positions of the following crank-slider mechanism. Indicate all known sizes…

A: Given:To find:(a) Draw the two limiting positions.(b) Determine the piston stroke.

Q: Write a CNC program code to machine this part.

A: Since the part is symmetrical, thus divide the given component into half and the half part.

Q: A drilling machine is to have 8 speeds ranging from 100 rev/min to 1000 rev/min. if the speeds from…

A: The total number of terms for this AP is: n=8 The first number is: a=100 rev/min The last number is:…

Q: What is the gear ratio supplied by the gear system shown to the right? (It is a single pitch…

A: Here number of teeth in gear ( Tg)=30 Here number of threads/teeth in worm (tw)=5 For single pitch…

Q: QUESTION 3 Code for a clockwise circular move to an end point that is 1 inch over in the X direction…

A: consider the following diagram:

Q: What is Line J? ARROWHEAD .35mm A 7.0 В

A: Solution:

Q: Please show calculations

A: MMC: MMC is also called the maximum material condition. It is represented by the circled M. The…

Q: SHAFT KEY

A:

Q: 0 = 0° A

A:

Q: By and bx are labeled wrong

A:

Q: If gear 1 turns 620 degrees, how many degrees will gear 3 turn? N1 =20, N2

A:

Q: Finish the Orthographic drawing

A: Please refer the following Front view, right hand side view and top of the given isometric view. 1…

Q: SPECIFY WHERE DIMENSIONS NEED TO BE PLACED FOR THE FOLLOWING PART NOTE: JUST NOTE WHERE…

A: To mark the letters on the following figure mentioned.

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.