Considering the beam provided. If El = 200000 kNm² and using any method. Determine the difference in elevation between the highest and lowest point of the loaded beam. 6kN 2m B 2kN₁ 2m 16kN D C E hinge hinge 1m 1m 2m 2kN/m 6m

Q: By whom  are computers used for project administration/

A: Project administration is the part of project management. There are so much responsibilities in…

Q: Could you show the calculations for the table

A: The discharge through the section = Q = 100, 150, 200, and 250 cfs The slope of the section = S =…

Q: Thank you for you answer, but it's not comlplete. 1- I can't see the right side of the page 2-…

A: Wearing surface of hot mix asphalt with high rut resistance = 225 mm (8.86 inch) Recycled mixture…

Q: You are nominated as a Mine Surveyor for a project related to underground coal mines. A longwall…

A: i) Diagram of Mining Equipment Used in Longwall Coal Mining:The mining equipment used in longwall…

Q: Bim is: a collection of building plan prinouts. a method for cost control a data rich digital…

A: BIM is a data rich digital building model. And is explained as follows: BIM ( Building information…

Q: Question 24 Resource is a situation in which more resources than available are assigned to an…

A: Answer Resource Allocation Resource allocation is the way or process used to assigning and…

Q: How about discussing the principles of data analysis and modeling?

A:

Q: What are the other sources for change orders?

A: The change order can referred as a variation order, it is a work that has been excluded or added to…

Q: what is mean by the riser in drawings *

A: To Determine Definition of the term Riser used in the Drawings.

Q: Note: Please provide a detailed, step-by-step solution. It’s essential to double-check the entire…

A: Step 1:written procedure Step 2: Step 3: Step 4:

Q: What do you mean by fail safe design

A: Fail-safe designs are the methods of designs in which various techniques can be used to mitigate…

Q: .Is it compulsory to keep the approved samples showing material at the job site? why?

A: The materials required for execution of any work are first tested for their quality and standards,…

Q: Functional Analysis - complete two the Blackbox model - list sub-functions at list 5 critical…

A: In functional analysis, a Blackbox model is a representation of a system where the internal workings…

Q: i need all parts of question on the right hand corner solve I STATED FILL IN THE BLANKS.

A: Only 3 subparts can be answered at a time according to guildlines. Please resubmit the question…

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.