Consider water flowing through a converging channel as shown and discharging freely to the atmosphere at the exit. What is the gage pressure at the inlet? Assume the flow to be incompressible, and neglect any frictional effects. 3D75 mm D2 = P2 = Patm 150 mm %3D %3D V, 1.2 m/s %3D

Q: 5. Use the assumption that there is a complete mixing of the two inflows before the discharge.…

A: 1) Mass rate of flow, m.c=7.215 slugs/sec. 2) Velocity at discharge, Vc=20.37 ft/sec. 3) Specific…

Q: A fan running at 1480 rpm takes in 6 m^3/min of air at inlet conditions of P_1=950 mbar and T_1=15^0…

A: Given, Speed,  N=1480 rpm Volume rate, Q=6m3/min Inlet pressure, P1=950 m bar Inlet Temperature,…

Q: A 3.5-hp pump delivers 1140 lbf of ethylene glycol at 20°C in 12 seconds, against a head of 17 ft.…

A: Calculate the efficiency of the pump in %.

Q: 3.) An air compressor handles 8.5 m³/min of with a density of 1.26 kg/m² and a pressure of 1 atm,…

A: Given data  Volume flow rate = 8.5 m3/min density (ρ)= 1.26 kg/m3  Pressure (P)= 1 atm  discharge…

Q: A B P4. Two holes are made in the side of the tank such that the jets of water flowing out of them…

A: The text says that the equation below describes the relationship between creep, strain, and time for…

Q: jet

A: α=30oV1=30 m/su=12m/sϕ=18o

Q: A tank of oxygen has a hole of area 0.5 cm² in its wall. The temperature of the oxygen in the tank…

A:

Q: projectile-like object with maximum diameter of 20 cm is placed at the exit of a 25-cm-diameter…

A:

Q: The entrance-to-exit area ratio of streamtube is given as 2. Consider incompressible flow entering…

A: Given Data- The ratio of the inlet to exit area A1/A2=2 We have to choose the correct option

Q: At the inlet to a certain nozzle the enthalpy of fluid passing is 2800 kJ/kg. In addition, the velc…

A:

Q: Aa hydraulic turbine receive water from a reservoir at elevated of 50 m above it. What is the…

A:

Q: The air in a car tire is held at a pressure of 220 kPa (gage) in an atmosphere where the atmospheric…

A:

Q: Air flows steadily at a pressure of 105 kPa at a speed of 0.1m / s and a temperature of 300K in a…

A: For steady and incompressible flow the continuity equation must be satisfied.

Q: Determine the velocity of efflux from the nozzle in the wall of the reservoir of (a) * .Figure, (b)…

A:

Q: A water truck drives slowly around a construction site, spraying water to keep dust down. A pump…

A:

Q: Consider the large open tank of water. At a height, h = 1 m, above the bottom, it is connected to a…

A:

Q: A very popular toy on the market several years ago was the water rocket. Water (at 10°C) was loaded…

A: Given Pressure inside the rocket , Pi = 100 KPa exit area is on tenth of the inside area .

Q: Air Compressor *(1) Air enters the compressor and piping system from left as shown in the figure.…

A:

Q: 1. An air compressor works with air at 20 °C compressing the air from 1 bar absolute (105 N/m²) to…

A: To find: The specific work and head generated. Given: The initial temperature is T=20°C. The initial…

Q: 3. Oil with density of 930 kg/m³ enters a diverging nozzle at 6.7 kg/s. If the ratio from the outlet…

A: According to the given data m˙=6.7 kg/s ρ=930kg/m3 A2A1=6 D1=10cm=0.1m We need to find The exit…

Q: jet fighter is flying at M = 3 at a height of 30,000 ft. A diffuser at its engine entrance reduces…

A:

Q: Q4: Two centrifugal pumps (A) and (B) are to be used to pump water for vertical distance equal to…

A:

Q: Water vapor, whose pressure is 650 kPa and temperature 573 K, enters a well-insulated device at a…

A: Initial pressure of vapor(P1) = 650 KPaFinal pressure of vapor(P2 ) =  130 KPaInitial temperature of…

Q: Water flows through the reducer, the inlet diameter is 20 cm and the outlet diameter is 10 cm. If…

A: Given:-  Inlet Conditions : Diameter (D1) = 20 CM = 0.20 m Velocity (C1) = 0.4 m/s Pressure (P1) =…

Q: If a jet is inclined upward 30O from the horizontal, what must be its velocity to reach over a 3-m…

A: Consider the diagram as shown below for the given system.

Q: ine a fluid packet moving through the Orifice plate. What happens when it’s Kinetic Energy as it…

A:

Q: The diffuser in a jet engine is designed to decrease the kinetic energy of air entering the engine…

A:

Q: of 1 in and 20 ft, resp

A:

Q: (3) The cart shown below is restrained from moving by a cable connected to a fixed wall. The tank…

A:

Q: In the figure below, given that: a = 9 mm b= 0.05 m %3D c= 18 mm D= 0.1 m Specific gravity of the…

A: Given data as per the question the specific gravity of manometric fluid =1.27 applying benaullis…

Q: Q1:-Calculate the power of the turbine as shown in fig.(1), neglecting the losses Fig.1 30 m D;=7.5…

A: The pressure in a fluid increases with depth. This means that a water container will have high…

Q: Two gases enter a combining tube and leave as a single mixture. . For the first gas, A₁=72in²…

A:

Q: 3. Find vi assuming incompressible flow and The tank is very large.

A: To determine the velocity V1.

Q: The water (density 1000 kg/m3) leaves the nozzle (area of the nozzle-0.01 m). Assuming steady,…

A:

Q: At the inlet to a certain nozzle the enthalpy of fluid passing is 2800 kJ/Kg. In addition, the…

A:

Q: . Indiana Jones needs to ascend a high-rise building. There is a large hose filled with pressurized…

A:

Q: Problem 7 Water with density Pwater = 1000 kg/m3 flows through a pipe, composed of two reduced in…

A: