Problem #2Consider two free-falling parachutists with linear drag. The first jumper is 70 kg and has a dragcoefficient of 12 kg/s. If the second jumper has a drag coefficient of 15 kg/s and a mass of 75 kg,how long will it take him to reach the same velocity the first jumper reached in 10 s?v(t) = " (1-egmC

Answered: Consider two free-falling parachutists…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. A 1500 kg electric vehicle travels along an asphalt roadway with a 5° grade at 100 km/h and a rolling resistance coefficient of 0.013. The frontal area is 2.05 m² and a drag coefficient is 0.32. The battery capacity is 85kWh and the battery nominal voltage is 320V. The air density of 1.2 kg/m3. (a) What is the power required to propel this vehicle? (b) The gear ratio is 10.7, the tire radius is 0.23m. Assume 100% efficiency for the gear. (i) What is the torque seen by the ac propulsion motor (ii) What is the power and speed of the motor? (c) What is the range of the vehicle considering 80% Depth of Discharge on a flat road at a speed of 50 km/h? 3. In the system of problem 2, the propulsion motor used is a star connected interior permanent magnet motor fed by a three phase IGBT inverter. The motor is operated in direct torque controlled mode. The inverter output voltage is 414V(L-L) and the modulation index is 0.9. The motor efficiency is 98% and power factor is 0.78. The dc link…
A commercial airplane has a total mass of 70,000 kg and a wing planform area of 150 m2. The plane has a cruising speed of 558 km/h and a cruising altitude of 12,000 m, where the air density is 0.312 kg/m3. The plane has double-slotted flaps for use during takeoff and landing, but it cruises with all flaps retracted. Assuming the lift and the drag characteristics of the wings can be approximated by NACA 23012 , determine (a) the minimum safe speed for takeoff and landing with and without extending the flaps, (b) the angle of attack to cruise steadily at the cruising altitude, and (c) the power that needs to be supplied to provide enough thrust to overcome wing drag.
A 10.0 m by 3.0 m by 1.3 m barge (495 kg) is floating in water (SG=1.05) and being loaded with a 0.32 m diameter dredging liquid stream (SG = 1.41) with a velocity of 15.5 m/s. If the minimum permissible freeboard during loading (boat edge above the waterline) is 0.35 m, what is the maximum time (seconds) that the barge can be 'filled'. +0.32 m BARGE 10.0 m 1.3 m
Experiments were conducted in a wind tunnel with a wind speed of 16.66 m/sec on a flat plate having area 2.25 x 10 4 cm2 and 1.5 m wide. The density of air is 1.2 kg/m3, the co-efficient of lift and drag are 0.25 and 0.70 respectively. Determine (i) the lift force, (ii) the drag force, (iii) direction of resultant force and (iv) the power exerted by air on plate.
Еxample 5 The total mass, wing area, cruising speed, and air resistance power of a small aircraft are 1800 kg, 42 m², 280 km/hr, and 190 kW, respectively. Determine the lift and drag coefficients of this airplane while cruising at an altitude of 4000 m.
Q1
A cloud of coal particles is traveling through a system. The cloud diameter estimated to be 0.027 m and the individual particles are 50 um in diameter with the density of 1300 kg/m'. The total cloud is moving such that its drag coefficient is constant at 0.44. The individual particles in the cloud move much slower, such that the drag coefficient given by stock's law. The system has atmospheric air transporting and the cloud density is 190 kg/m3. Determine the ratio of internal velocity to cloud velocity. Atmospheric air density 1.2 kg/m'.
A person is driving his motorcycle at a speed of 90 km/h in air at 20°C. The frontal area of the motorcycle and driver is 0.75 m2. If the drag coefficient under these conditions is estimated to be 0.90, the drag force acting on the car in the flow direction is (a) 379 N (b) 204 N (c) 254 N (d ) 328 N (e) 420 N
handwritten
Consider that you are in an area of Seattle where the wind is blowing at 40 km/h with a temperature of 0 ° C. If you can be mathematically modeled as a cylinder with diameter external of 0.3m and height of 1.70 m. Calculate the number of hot dogs that you need to eat to make up for the amount of energy you lose in heat form for an hour. Note 1: Consider that the external temperature of the clothes is kept constant at 25 ° C. Note 2: Consider a 150 kcal hot dog.
b) What is induced drag on wings? Can the induced drag be minimized by (1) long and narrow wings or (2) short and wide wings? Please justify your answer.

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

Consider two free-falling parachutists with linear drag. The first jumper is 70 kg and has a drag coefficient of 12 kg/s. If the second jumper has a drag coefficient of 15 kg/s and a mass of 75 kg, how long will it take him to reach the same velocity the first jumper reached in 10 s?