Consider the wires that carry electric current and are arranged as shown below. In this case the length of segment a = 12 cm, b = 16 cm. Where the current flowing along the wire i = 4.5t2 - 10 t (where i is in amperes, t is in seconds). -b- b a. Determine the magnitude of the emf in the square loop (square wire) at t = 3 seconds. b. Determine the direction of induction in the square loop

Consider the wires that carry electric current and are arranged as shown below. In this case the length of segment a = 12 cm, b = 16 cm. Where the current flowing along the wire i = 4.5t2 - 10 t (where i is in amperes, t is in seconds). -b- b a. Determine the magnitude of the emf in the square loop (square wire) at t = 3 seconds. b. Determine the direction of induction in the square loop

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

I I,- The picture shows two perpendicular wires where I1 is 14.6 amps, and I2 is 21.9 amps. The location A is in the plane of the two wires and is 25.0 mm from the x-axis and 15.9 mm from the y-axis. Given the direction of current in each wire, what is the B-field at the location A in micro teslas? (If the B-field points toward you, make it positive; if it points away from you, make it negative. Give answer as an integer with correct sign. Do not enter unit.)
3. Four long wires are parallel to each other, their cross section forming a square 20 cm on edge, as shown in Figure 1 below. A 20 amp current is set up in each wire. What is the force per meter acting on the lower left wire, in magnitude and direction? represents current flowing through wire in the direction out of the paper, direction into the paper. represents current flowing through wire in the a a a Figure. 1
what help
C. For wire m to be levitated. what is the direction of its eurrent ? d) Find the mas m of the third wire. Your answer should be in terms of , I, Im, a, h, g, and l
1. A 1000-turn coil of wire 2.0 cm in diameter is in a magnetic field that drops from 0.10 T to 0.0 T in 10 ms. The axis of the coil is parallel to the field. What is the emf of the coil?
Q1.. Explain Faraday's law of induction and Lenz's Laws. The magnetic flux passes perpendicular to the plane of the circuit and is directed into the paper. If the magnetic flux varies with respect to time as per the following relation: B = (2t³ +3t2 + 8t +5) mWb, what is the magnitude of the induced emf in the loop when t= 3 s? Find out the direction of current through the circuit. X X XX www
14. A wire is oriented into a loop that has a diameter of 1 cm. This loop is then pulled closed in 0.5 s. If there was a magnetic field directed through the loop of 0.25 T, what emf is induced?
Two parallel wires separated by 4.00 cm repel each other with a force per unit length of 2x10-4 N/m. The current in one wire is 5.00 A.a. Find the current in the other wire.b. Are the currents in the same or opposite direction? c. What would happen if the direction of one current were reversed and doubled?
The alternating e.m.f. e = 150 sin (200 t) volt is applied to a pure resistance of 50 N. current through %3D Calculate R.M.S. the resistance.
4. possible emf when the loop is placed in a time-varying magnetic field. You investigate the three loop geometries in Figure A: a long, thin rectangle; a square; and a circle. Which one will give the largest emf? 1 mm O Figure A
Can you answer?
4. Fold the unlimited long wire with current I = 10.0A into the shape as shown in the figure. The radius of the semi -ring rings is r = 0.10m.Seeking the magnetic induction strength of the point O point O.