Consider the system Y(s) G(s) = 8-4 R(s) (s | 1)(8 + 2) = a) Give the steady-state response y(t) for a sinusoidal input r(t) = Asin(wt). b) What is the magnitude and the phase of the output signal y(t) for w = 1rd/s?

Consider the system Y(s) G(s) = 8-4 R(s) (s | 1)(8 + 2) = a) Give the steady-state response y(t) for a sinusoidal input r(t) = Asin(wt). b) What is the magnitude and the phase of the output signal y(t) for w = 1rd/s?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Calculate the steady-state errors that will occur if the following test signals are applied to the…

A: Given, Block diagram is We need to determine the steady state error for the following inputs, a)…

Q: D) A capacitor connecte to an inductor with no resistance O Is unstable Cannot have a damped…

A: A charged capacitor connected with an inductor generates sinusoidal signal. This is called LC tank…

Q: An RC circuit consists of a resistor R = 32 Ω, a capacitorC = 25 mF, and an ac generator with an rms…

A: According to the given information, the circuit can be drawn as…

Q: 3. Given the signal below: X(t)= 10+ 15 cos(60xt)-20 sin(60xt)-+ 12 cos(120mt) -30 sin (120xt) -5…

Q: Problems 1 Generate the following sequences using the basic MATLAB signal functions and the basic…

A: The objective of the question is to generate two sequences using MATLAB and comment on the waveform…

Q: D) E) F) Which of the following is g lineHurwiar approximation for cos(x)? 1-x O 1+x X+2 1 Which of…

Q: You are given a time-domain expression for a signal I = 0.55 cos (200t – 11.6) A. Which of the…

A: We need to find out the phasor of given signal .

Q: Consider a simple sine wave where [CO1-C2] x(t)= u(sinwt) = 1 when sinwt > 0 = 0 when sinwt < 0.…

Q: The average value of the sawtooth waveform with v(t) = Vm T (limits from 0 to T) is _. a) Vm T b)…

A: Given, The sawtooth waveform is V(t) = Vmt ,. For 0<t<T. We need to find the average value of…

Q: A second-order system has two poles at -3 ± j7 and no zero, find the system E, wn, PO, tp and t

Q: 3. Consider the discrete-time sinusoid x[n] = sin (™). a. Plot x[n] for n = 0, ..., 48. b. Is this…

A: Given Data:A discrete-time sequence of,To Find:Plot of the sequence for n=0 to 48.Period.Frequency…

Q: The non-sinusoidal waves which represent a sum of infinite number of harmonic waves can affect on…

A: harmoics are the integer multiple of the fundamental frequencies

Q: g(t) 200(cos (2t) + sin (3xt) + cos (5xt – *)) Find the fundamental period and fundamental frequency…

A: In this question we will find fundamental time period and fundamental frequency...

Q: Find the steady-state charge qo(t) and the steady-state current i(t) in an LRC-series circuit when L…

Q: Please provide a Karnaugh map for image shown. Groupings must be clearly shown.

A: Brief description: The given Boolean variables in the question bare P,D & W. Quadrants will…

Q: Consider a signal as follows: s(t) = sinc(2t-120) cos(400nt) (a) Find the expression for the…

A: Consider the signal G2t= F.T.G2t=sin2πf2πfBy duality property, sin2πf2πf=sinC 2t↔F.T.G2-f=G2f×2π…

Q: b) Consider a sinusoidal type of signal to be sampled, for which the highest frequency is given as…

A: Given, Maximum frequency of message signal is fm = 45 kHz Therefore, Let us consider the message…

Q: Example. Response of an RC-circuit to a single square wave. Find the current i(t) in the circuit…

A: In the given questions we need to calculate current i(t).

Q: Obtain the time-domain waveforms for -3 + 4j at angular frequency w = 30000 rad/s. The amplitude of…

Q: Consider the following continuous signal x(t). Using a definition of periodicity, determine whether…

Q: The two-sided spectrum of a signal contains components at four frequencies: -180 Hz, -120 Hz, 120…

A: For the given two-sided spectrum frequency components the value of the fundamental frequency needs…

Q: (c) L 8(t)e¬jwt di (d) o 8(1 – 2) sin t dt (h) ele-1) cos (x – 5)8(2x – 3) dx (g) 8(2 – 1)8(3 – 1)…

Q: Frequency Domain A 5[8(f – 200) + 8(f + 200)] В (5/2) rect(f/2)e-j4nf C 180 sinc(20 f)e¬j8nf D -84…

Q: Use MATLAB to plot the following signals in the range -3 <ts5 sec. Where u[n] is unit step function…

A: matlab code to generate signal -3<t<5 is given as follows

Q: 5) Check the periodicity of the discrete-time signals below i. x(n) = cos Στη S + cos 2mm 7 ii. x(n)…

A: In this question we need to find a time period of the given signal.

Q: Obtain the time-domain waveforms for - 6+ 8j at angular frequency w = 30000 rad/s. The amplitude of…

A: The given waveform should be represented in the time domain waveform so the given representation…

Q: a. Explain about Energy crisis.

A: we need to explain about energy crisis.

Q: Problem1: a. What is g() if G(): 4+81(f-5) b. g(t)-z(t)cos(2000xt)+z(t)*Sinc(t) i. Plot the…

A: (a) we have find g(t) given that G(f) =14+8πjf-5 =14+j8πf-j40π = 14j2πf-j10π+1…

Q: R V(t) C Ve

Q: Q2/ Choose the correct answer 1. For the pulse signal v(t) as shown in Figure (1). v(t) 1 Figure (1)…

Q: The steady-state frequency response of the following digital system H(z) for a sinusoidal input u(k)…

A: By the help of steady state response of the z transform definition we have got the result. H(Z) =…

Q: iven a continuous time sinusoid with frequency 10 Hz and 15 Hz respectively as…

A: Ts=1/Fs=1/40 to convert in discrete-time , we need to replace t by nTs which is equal to n/40 ie,…

Q: The following figure shows the density function of the signal spectrum g (t). A) What is the average…

A: We need to calculate power of given power spectral density. We also need calculate the auto…

Q: 1.6. What is the power dissipated by each resistor in Figure P1.6? How much power is supplied by…

A: The circuit diagram,

Q: show that the output y(t) consists of a dc com- ponent and a sinusoidal component. (a) Specify the…

Q: 3. Determine the instantaneous frequency (expressed both in rps and cycles/sec) of the signal x(t)…

Q: Find the following signals' auto correlation 1) f(t)=10cos2t 2) g(t)=5eyn/i3+)

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: Determine the discrete time signal in time-domain by using the magnitude and phase responses -10 4…

Q: Q2/ For the figure shown below if qo = 15. 10 - 6C.q1 = 45. 10 - 6C.q2 = - 36 • 10 - 6C.q3 = 20 - 10…

A: Any charged particle produces an electric field. This electric field is directed from the positive…

Q: Determine the fundamental frequency of the given continous-time signal, x(t) in Hz, and then express…

Question

Consider the system
Y(s)
G(s) =
=
R(s) (s | 1)(s + 2)
a) Give the steady-state response y(t) for a sinusoidal input r(t) = Asin(wt).
b) What is the magnitude and the phase of the output signal y(t) for w = 1rd/s?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: Solution of subpart a

VIEW

Step 3: Solution of subpart b

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Select all of the responses that are true regarding the below graphic. 20 10 A 0 Hz 12 10 kHz 18 20 kHz The overall equation for the signal is: y = 12 sin (2 π 10,000 t) + 18 sin (2 T 15,000 t) + 8 sin (2 π 30,000 t). The equation for the lowest frequency component could be: 30 kHz Frequency Domain Graph The image shows a frequency domain graph with two component signals. The second component of the signal has the equation y = 12 sin (2 T 10,000 t). y = 8 sin (2 T 10,000 t) + 4 sin (2 TT 10,000 t). 8 00 f
Consider the discrete-time signal æ[n] = 8[n +1] + 8[n – 1]. There exists a continuous-time signal y(t) such that x n] = y(n) for all integers n. This signal is O y(t) = sinc(t +1) + sinc(t – 1) O none of the other answers O y(t) = sinc(t – 1) – sinc(t + 1) O y(t) = sinc(t + 1) – sinc(t – 1)
A continuos-time signal x(4) has frequencies in the range 30 to 40H2. The signal is Sompled with period Ts so that we obtain a discrete - time signal x[]=x(nTs) The amplitude spectrum x (F)| of x(t) is as following (F in hertz, using w=2RF) F(Hz) 30 40 - 40 -30 ) What's the Ny quist Srequency at which x(4) Should be sampled to avoid alising? b) We sample at a rate of So H2, and apply a Low -pass fiter with fc= 30Htz. What will the min and max frequency of the resulted dignal?
c) The continuous time signal: x(t) = cos(2n. t) + sin(2n. t) is correctly sampled at fs = 2Hz. The sequence x[n] is the sampled version of x(t)). Find the first 6 values in x[n]. Evaluate the energy and power in the sequence x[n] over the sample values n=0 to n=5. Will the complete x[n] over n = 0 to n = inf inity be a power or an energy signal?
Q3) For the signal f(t) = cos(nt)sin(4nt) a) Determine if the signal f(t) is a periodic signal or not. If it is periodic, find its period. b) Determine if the signal f(t) is a power or an energy signal. Prove that. c) Sketch two-sided magnitude spectrum of the signal f(t). d) Sketch one-sided magnitude spectrum of the signal f(t). e) Calculate the power of the signal using frequency domain.
Please look at the questions below. Will upvote thanks!
I need the answer as soon as possible
Use the ideal model for the op amp to find the voltage v(t) as a function of time. 9 cos (2000) V 47 k www 60 k 29 nF v(t): 3.19cos(2000t+117.81) V frequency is correct; the phase is wrong of sº Your amplitude is only close (within 5%); the
3. Consider the two sinusoidal signals a(t) and b(t). Where a(t) = exp (jt) and b(t) = cos (t) and their product yields x(t) as shown in the following figure. Find if x(t) is periodic? If so, find the fundamental period of x(t). a(t)- b(t)-
The wave power per length is 1740 W/m, the device-width of the wave energy system is 5.1 m, the capture width ratio is 0.36, the rated power is 18608 W. Determine the percentage degree of utilization. O 14.59 O 17.17 O 15.45 O 18.88
Please help answering this question. Please write and explain clearly.
the signal x(t) = cos (360 pi t + pi/4) is sampled at 100 hz and the sampled signal is reconstructed at 200hz to recover the analog signal xr(t) a. what is the period n and digital frequency f of the sampled signal x(n) b. how many full period of x(t) are required to generate one period of x(n) c. write the expression for xr(t) ..