Consider the pump on the right side of the drawing, which acts to reduce the air pressure in the pipe. The air pressure outside the pipe is one atmosphere. Find the maximum depth from which this pump can extract water from the well.

Q: complete solution for letter D and E

A: Open cylindrical tank 4 ft in diameter and 6 ft deep is filled with water up to its rim and rotated…

Q: find the specific gravity of the given unknown fluid, the hydrometry weight is 0.015 N. A=0.1 cm 63…

A: Weight of the hydrometry = 0.015 N = Buoyant force Calculating the specific weight of the unknown…

Q: What gauge pressure is required in the city mains for a stream from a fire hose connected to the…

A: The gauge pressure required in the city mains for a stream from a fire hose connected to the mains…

Q: 6. For the water system shown, determine the pressure at point "A", kPa 2.4 m Water 3.6 m 150-mm…

A:

Q: An open cylindrical tank 4 ft In diameter and 6 ft deep is filled with water up to its rim and…

A:

Q: n orifice for its outlet. When the water surface in the tank is 5m above the orifice, the surface…

A: given:z1=5mp1=1.0135×105N/m2v1=2ghv1=2×9.81×4=8.86m/ssecond casez2=5m

Q: Figure 4.46 shows a water tank with a circular tube connected at its bottom. A circular door seals…

A:

Q: The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 43 psi. The…

A:

Q: A pressurized tank is used to launch water into the air to create a water fountain. The center of…

A: x=5 m h=35 m And since PG=ρgh

Q: From pump 1.0 m 1.5 m a. Using a vertical bar chart, plot the pressure drop (i.e. P₁-P₂) for these…

A:

Q: 92 is 2m above the orifice. If there is a pressure of 15kpa at the top of the oil surface inside the…

A: given:s.g=0.92diameter d=70mmp1=15kpap2=0atmZ1=2m

Q: Q2 (a) An apparatus shown in Figure Q2 consists of a rubber squeeze bulb filled with sand connected…

A: Rise or fall of water level through small orifice is due to the capillarity phenomenon.

Q: Task 3 Gas, evolved as a result of a chemical reaction, sequentially flows from the retort A into…

A: Pressure: Since the tension is pushed per unit region, it is relative to push straightforwardly and…

Q: I 53 ft 5 ft Air Gasoline Water

A:

Q: How high does the water rise due to the capillary effect in a 15 micrometer diameter pipe?

A:

Q: What is the power ratio of a pump to its 1/5 scale model if the ratio of the heads is 4 to 1? Round…

A: Given:

Q: The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 35 psi. The…

A:

Q: Determine the relationship between the air pressure in the tank and the maximum height to which the…

A:

Q: level of mercury at B.

A: Given;  Given figure shows , mercury manometer is attached to a section of the pipe,Where manometer…

Q: 0 oil volume flow rate

A: given:

Q: e are willing to design a simple setup for the lubrication of a rotating rod. To do so, the…

A: The power will be dissipated due to the viscous shear resistance provided by the film of liquid on…

Q: the ratio of power output of the pump to the power input to the pump is known as

A: Pump efficiency,η=Power output of pumpPower input to pump where,Power output=ρgQHwhere,ρ=density of…

Q: The pressure difference measured by a mercury oil differential manometer on the two sides of the…

A:

Q: 9. The submerged, curve surface AB in figure below is one quarter of a circle of radius 4 ft. The…

A:

Q: The pressure at the suction of the pump reads 8 psi vacuum, while at the discharge is 41 psi. The…

A: Write the given data. P1=-8 psi+14.7 psi=6.7 psia=46.2 kPaP2=41 psi+14.7 psi=55.7 psia=384…

Q: Jet of liquid (14 mm diameter) ejections vertically into the atmosphere. The pressure inside the jet…

A:

Q: For a pumper truck pumping water to a fire, the back pressure is the additional pressure on the pump…

A: The total height of the building is h= (16 ft)*9 h= 144 ft

Q: The pressure through a section of pipe is 21 PSI and the velocity of the fluid is 1 ft/sec. If the…

A: given data; pressure at section 1st (P1)=21PSI=144789.903pavelocity at section…

Q: An inverted CONICAL tank (D = 0.5 m, H = 1 m) is full of water. Find the pressure at the bottom of…

A: D = 0.5 mH = 1 mDownward acceleration, a = 2 m/s2Required:P ( pressure at the bottom of the tank )

Q: The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank…

A:

Q: In figure 4, how will the maximum height, z1, that the pump can be located above the water surface…

A: Given:a Water at 120oFb Gasoline at 60oFFind:The maximum height z1 that the pump can be located…

Q: An open cylindrical tank 3ft in diameter and 5ft high contains 3ft of water. If the tank is rotated…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.