Q7 only Common data for Q7-Q9Consider the non-linear systemi = x² – 4.7) How many equilibrium points does the systemhave?8) What is the value of stable equilibrium point ofthe system?9) What is the value of unstable equilibrium pointof the system?

For non linera systems, all those points where rate of change is zero are known as equilibrium…

Answered: Consider the non-linear system à = x2 –…

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 5RQ

See similar textbooks

Similar questions

Describe how steady-state accuracy of the system can be measured. Determine the accuracy of the system given different types of test inputs. Show examples for every type of test inpts to prove your answer.
Subject : Power electronics
1/ Suppose that there are two types of H.V.T.Ls operating at the same voltage and carrying the same current, but one of them with smooth shapewhile the other with standard shape. Which of them, you will choose? a. choosing the smooth one. b. choosing the standard one. c. choosing the one with hollow construction shape. d. all these answers are wrong. 2/ As the ambient temperature in crease the disruptive critical voltage of coron a is: a. Decreased b. Increased c. No effect d. All these answers are wrong. 3/ Using HV underground cable improvevoltageprofile and power factor in any loaded inductive electrical grid because. a. Due to its inductive power effect. b. Due to resistive Effect. c. Due to its capacitive power effect. d. All of the above answers are wrong.
The swing equation provides the information about Stability of the system Efficiency of the system Power flow under steady state Performance of the system
J62 For the magnetically coupled circuit shown, find K J72 the values of coupling coe fficient "k" when the power at 100 resistance is equal to (40W) if Vs=5020°v. (Ans.: 0.279) Vs 4.672
H.W Q1: In your own words, explain how the galvanometer works? Q2: In your own words, what are the cases of dynamic behavior of PMMC?
For the system given below, a) Find K1 and K2 so that the steady-state error is zero, the settling time is one second, and the overshoot is 5% for a unit step input. b) Specify the system type and find the steady-state error a unit ramp input using the computed K1 and K2 values. "Can you explain step by step " check image "
Q1. In which of the following cases, the Electrostatic Discharge (ESD) is more? Explain how the ESD event taken place in both the cases. a. A person walking across a synthetic carpet on a dry day and generates a potential of 15 kV on his body. b. A person walking across a plain ground surface on a dry day and generates a potential of 100 V on his body.
please sir solve these 2 questions, thanks alot
SHOW YOUR COMPLETE SOLUTION
8. a) Inductors_________ oppose a change of current.a) always b) sometimes c) never d) all of the above B) What is the direction of a self-induced emf in relation to any change in current? a) . the same direction as the current flow that caused itb) the opposite direction as the current flow that caused it c) may laemettherlalgr "b" d) neither a nor b C). Hysteresis loss is caused by _________a) low voltage DC. b) poorly insulated conductors c) molecular friction d) none of the above
In the Maxwell bridge as shown in given figure, the value of resistance R, and inductance L, of a coil are to be calculated after balancing the bridge. The component values are shown in the figure at balance. The value of R, and L, will respectively be

SEE MORE QUESTIONS

Recommended textbooks for you

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning