Consider the given figure. 20 kips 24 kips 10 kips 2010 A B K 6 @ 20'= 120' Using the influence lines, determine the maximum live load force produced by the 54-kip truck as it transverses the bridge, which consists of two trusses. Assume the truck moves along the center of the roadway so that one-half of the truck load is carried by each truss. Assume the truck can travel in either direction. The maximum live load compression (FAL) in bar is The maximum live load compression (FKJ) in bar is The maximum live load tension (FKJ) in bar is kips. 20' kips. kips.

Q: (a) determine the max. moment due to loads at C  (b) determine max positive V at C

A: Using ILD calculation of -

Q: The bridge truss shown in is to be subjected to moving loads, L, 8 m, s= 4 m, P-0 kN, 0= 50 degrees…

A: CALCULATIONS of ILD for JK member of truss and CALCULATIONS of Maximum Axial load due to given type…

Q: 1. Determine the resultant of the distributed loading acting on the beam shown. 1(A) 1(B) w N/m 4…

A: To find the resultant of the distributed loading acting on the beam shown.

Q: A cantilever beam is fixed on the left end and free on the right end. The span of the beam is 12 ft.…

A: The moment reaction at fixed end of the beam = ?

Q: Draw the influence line for the force in member EH. Then compute the largest force that can be…

A: Given:- live load=2kN udl=0.5kN/m To find:- Influence line

Q: force water. Determine the force & angle on gate AB.

A:

Q: Determine quantitatively the influence lines for Ay, ME and VẸ for the statically determine system…

A: Data given: Asked: Influence lines for Ay, ME and VE

Q: Two solid steel shafts (G = 77.2 GPa) are connected to a coupling disk B and to fixed supports at A…

A: Given data : G = 77.2 GPa   A) Reaction at each support  B) Max. shear stress in shaft AB  C) Max…

Q: The value of moment generated at guided roller support C due to a concentrated point load of 10 kN…

A:

Q: F₁ O 260 kN (C) O 170 KN (C) 180KNC) F₂ F₂ 'В d₂ (2) C

A:

Q: 1. Draw the influence line of the beam shown below for a uniform load of w kN/m for the following.…

A: Acc   For ILD at B for reaction ,  remove the support at B and apply unit virtual displacement.…

Q: Problem 3. Determine the components of reaction at the ball-and-socket joint A and the tension in…

A:

Q: Determine the dead and live load acting on girder AB or CD. (unit weight of concrete is 23.6 kN/m^3)…

A:

Q: A cantilever beam is fixed on the left end and free on the right end. The span of the beam is 10 ft.…

A: Determine the moment reaction at fixed end of the beam.

Q: For all problems, draw the indicated influence lines. For #1, use both the "unit load method" and…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.