Consider the following three phase balanced circuit. 21020° Vrms j0.5 N 24– j21 N 2102-120° Vrms j0.5 2 (-+) | 24– j21 2 ell | 24– j21 N 210/120° Vrms j0.5 2 Find average power dissipated by the delta connected load. (a) 8587.18 W (b) -8587.18 w (c) 7514.41 W (d) -7514.41 W

Q: In the transformer circuit shown, find the primary current I1 (Polar form, in Aprms). Refer all…

A:

Q: In an installation there is a three-phase load of 300 kVA with a power factor of 0.8 behind, in…

A: Here, it is given in the problem that :Load 1 is 300 KVA with 0.8 power factor,Load 2 is 150 KVA…

Q: I- Purely Inductive Load 1. Sketch a three-phase 100VAC RMS phase-voltage, Wye (Y) Connected power…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 7. For the circuit below, calculate the value of Zz for maximum average power transfer to the load.…

A: Calculate the value of Z for maximum average power tyansfer to the load. In addition, deternmine the…

Q: 2. Two trausformes A and B of ratings 5uokVA.and 25okl; Supplying a load kVA of 750 ato.8Pt lagginy.…

A: Ans (a)

Q: (a) A single phase, unity power factor load takes 70 A at 25 kV. Using a base voltage of 60 kV and…

A: Per unit

Q: VASSESSMENT PROBLEM Objective 5-Be able to analyze circuits with ideal transformers .15) The source…

A: Current in primary =1 I1=25kv∠01.5kΩ+j6*103=4.04∠-75.96o Secondary current is I1a  where a is turns…

Q: 1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and…

A: 1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and…

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

A:

Q: What is minimum and non minimum phase system. Draw its phase characteristic curve.

A: Transfer function is ratio of output signal to input signal. It is the given as ratio of Laplace…

Q: R14. Two sequence components and the corresponding phase voltage of 3ø system are ollowing,…

A:

Q: (b) A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical delta-…

A:

Q: A 3 phase 200 MVA capacitor bank is to be switched off (disconnected) the grid that operates at…

A: Restriking voltage: It refers to the transient voltage that appears across the contacts of a…

Q: Find the impedance angle Each load on the left is 25.1972+j240.0237 ohms. Voltage source is 230V…

A:

Q: Two 3-phase, 6.6 kV, star-connected alternators supply a load of 3000 kW at .f. lagging. The…

A:

Q: VI) For the circuit shown, answer the questions from 15-19, The load Zt = 8+j6 ohms, and the source…

A:

Q: uror Ab Hom end nas a fota Ear end, the voltage V, = 240 V and the current is 100 A at a pf of 0-8…

A:

Q: Two SGs are supplying a load by Poad with 0.9 PF lagging. G1 has a no-load frequency of 54H2, and a…

A: Given are the details of two synchronous generator  fnl1=54 Hzfnl2=51 HzSp1=1.1 MW/HzSp2=1.1…

Q: * 3. F the network of Fig. 8.66: a) Calculate In. lo and r (b) Determine Z, and Z.. (c) Calculate A,…

A: As per company guidelines we can solve only first three sub parts kindly post another parts…

Q: A single phase a.c. distributor AB is fed from point A has a total impedance of (0.1+j0.2) N. At far…

A: Given system is : Step 1: Calculate respective impedance  Total impedance =0.1+j0.2 ΩiImpedance of…

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load draws…

A:

Q: Power factor correction is a method to do which of the following. ⒸRaising the power factor to…

A: In this question, we need to choose the correct option. What is way to improve the power factor .

Q: A symmetrical three-phase voltage source, wye connected with Van = 200 Vrms feeds a three phase load…

A:

Q: 3. A three phase source, 4-wire having a per phase voltage of 230V. An unbalanced load is connected…

A: I will appreciate your kind rate. Please assess my answer, and if there is any doubt, do not…

Q: There is an installation with two equal triphasic loads of 300 kVA each and a power factor of 0.9…

A: The installation has a total apparent power of 600 kVA with a power factor of 0.9 lagging. The total…

Q: c) Figure 6 is the waveform of output voltage, vo from synchronous connection changer. The primary…

A: Solution: This is a question of 2-stage sequence control of voltage controllers. Supply Voltage (Vs)…

Q: A. Find the net average value, net rms value, Form factor and Peak factor of the two waveforms of…

A: For a triangular wave: With a peak voltage of VP. The RMS value of the wave is: Vrms=VP3=0.577VP And…

Q: Two impedances Z₁ and Z2 are connected in series to a voltage source with voltage Vs volts. Let V₁…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: VI) For the circuit shown, answer the questions from 15-19. The load Zt = 8+j6 ohms, and the source…

A:

Q: 2. Determine Zbus for the system whose reactance diagram is shown in figure below, where the…

A:

Q: Consider the system in the figure to the right. The Zbus for the system is given as follows: [j0.411…

A: Given data Zbus=j0.411j0.310j0.354j0.310j0.446j0.333j0.354j0.333j0.450 To find out We have to…

Q: In a seriescircuit, a load having an impedance of 39 +12602 is fed from a voltage source through a…

A: Note: Resistance consume active power and dissipate interms of heat Inductive and capacitive…

Q: S. 20020°V L ms In the circuit in the figure; • L1 load draws 15 kVA with lagging power factor 0.6.…

A: From the complex power

Q: Which of the following descriptions IS NOT correct for loads in power systems? A. The purely…

A: capacitive load will deliver reactive power to the grid.     so option C is the wrong one

Q: (b) A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical delta-…

A:

Q: The voltage across a load is t) = 104/2cos(wt + 75°) and the current through the load is ¡(t) =…

A:

Q: Given the circuit below. A 220'n U,07t 100 -v 3-4 source b B U,097$ ICA lạc 22- 30°n Determine the…

A: From the three phase system ..

Q: 02Agle phae aveltag cnterin the figure elm haaret ad of end the ingut vetape i 1201, se l. The deles…

A: We will derive output rms voltage from the given firing angle.  From obtained output rms we will…

Q: A three-phase, variable-frequency drive (VFD) draws lagging non-sinusoidal line current, resulting…

A: The  given question deals with spectral analysis of the non-sinusoidal line current of a three-phase…

Q: The Full-load and No-load of a regulator are 5.2V and 5.3V, respectively. Then the % load regulation…

A:

Q: Three Impedances each of (8 - j24)N are connected in mesh across a three-phase 420V ac supply.…

A: Calculate the above parameters

Q: a. As an electrical engineer, explain about the power system in Figure Q2 with respect to the…

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.