Consider the following circuit. The switch in the circuit has been open for a long time beforeclosing at t=0t= 0150N+120mA300231.25mH Ve0.5µF3VDetermine the roots of the characteristic equation.a) What is the value of s1?b) What is the value of s2?The response for iL(t) is iL(t)=iLf+Aje°$it+A2e¯$2tc) Determine İLF in mili amperesd) Determine A1 in mili amperese) Determine A2 in mili amperes

First we will draw the circuit for t<0 sec then and we will find the initial voltage across the…

Answered: Consider the following circuit. The…

Consider the following circuit. The switch in the circuit has been open for a long time before closing at t=0 t = 0 150N + 120mA 300N 31.25MH V. 0.5µF 3V 0000

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q1] find the current of the inductance 0.04H if the value of the source is: 3sin(100πt+30) volt…

A: To find thevenin impedence, short the voltage source and open the current source and then find the…

Q: Question 6 The switch opens at t= 0 after being closed a long time. Find the current through the…

A: As switch is closed before t=0 for the long time. first, determine the initial current and voltage…

Q: A 10-mH inductor is connected in series with a 10-ohm resistor, a switch and a 6-volt battery. What…

A: Given, A series RL circuit having, Inductance, L = 10 mH Resistance, R = 10 ohm

Q: What is the current through the capacitor in this AC circuit?

Q: + t=0 2 1 R Io H₁

A: Circuit diagram is given as,

Q: 2. A 100 µF capacitor and a 3.6 k 2 resistor are connected in series. How long will it take for the…

Q: Q2 Determine the energy and power of the following signal: t<0 0st <2 122 x(t)=(e-t-e-10t (1-e)et

A: Given the signal is. xt=0 t<0 e-t-e-10t 0≤t<2 1-e-5e-t t≥2

Q: i(t) = 4t² +02t A inductance = 0.5H what is p(t) ?

A: Given: The current, it=4t2+0.2t A. Inductance, L=0.5 H.

Q: In this image what is t and it indicates the time for what ?

A: Heisenberg's Uncertainty Principle is the following:∆E.∆t>hwhere delta(E) and delta(t) are the…

Q: Qui o 9v 0,2 U 3 0.2H What is the instantanees Curreat when the srwitch is elosed @ t =o After t =…

A: We need to current for resistor and inductor circuit .

Q: b) Draw the result signal for the following figure? 10 v m(t) = 0

A: to draw the result signal for the following figure

Q: What should be the voltage across the 3H inductor in the below given electrical circuit if the 5V…

A: The given data is shown below:

Q: Зи(-1) A + C VC + -2i₁

A: Given circuit:- R=91 ΩL=93 HC=3 mF We have to determine the value of the voltage equation across…

Q: The amount of the current through an inductor in a DC circuit:

A: The solution can be achieved as follows.

Q: What is the dc output voltage and ripple in given example? Sketch the output waveform.

A: Given Transformer ratio as 7:1 Vp = 120 V C1 = 68 if, RL = 2.2 kohm

Q: Find Cn for the waveform shown: x(t) -4 -3 -2 -1 1 3. 4 -2 Select one: O -0.5 O -1.5

A: Need to find Co

Q: The switch S has been open for a long time and is suddenly closed. Neither the battery nor the…

A: Given circuit shown

Q: When the charge in this circuit discharges, why does the charge on the capacitor have to go through…

A: In this question We need to explain why does the charge on the capacitor have to go through R2 only…

Q: In the circuit below, the switch closes at time t=0. Assume that Is = 3.76 A, R = 14.9 kΩ, and L =…

A: In this question we need to find the current through the inductor at time t=3.95 ns.

Q: An L-R-C series circuit has L = 0.800 H, C = 5.00 μF, and R = 340.0 2. At t = 0 the current is zero…

A: It is given that: L=0.8HC=5μFR=340Ωq0-=2.80×10-4C

Q: C1 1 µF C2 15 μF 1 Hz 60 Hz 0.047 мF C2 1 µF f = 1 kHz 10 μF (b)

A: Here C=0.047 μF =0.047×10-6Ff= 1kHz =1×103 HzSoCapacitive treactance…

Q: The energy stored in a 50 mH inductor is 25.6 µJ. The curren through it is : O a. can be any value O…

Q: In a lossless medium with &, = 81 and u, = 3, three point charges are located in the x - y plane as…

A: Given :

Q: Question 23 x. R1 Vs R2 3 C0 Vs = 24V R1 = 1Kohms R2 2 Kohms C-4uF. At t-0 the switch is opened. The…

Q: The current flowing through a coil in 0.8 s decreases from 12 A to zero. What will be the inductance…

A: Given di = 12 A dt = 0.8s V = 0.3V

Q: In the circuit below: 1. Determine equations for inductor current and inductor voltage after the…

Q: An 8 pF capacitor is charged up and stored away (i.e., disconnected froma battery). The stored…

Q: The capacitor is initially uncharged The switch is moved to position 1 for a time of 5t The switch…

Q: two inductors are in a series. one inductor has 5 mH and the other has 600 microH. what is the total…

Q: A capacitor is charged with 150mC and the energy stored is 1.2 Joules, then the value of capacitor…

A: Capacitor- Capacitance does not depend upon Q and V but depends on the ratio of Q and V. The charge…

Q: Is it more efficient if the transient response is high or is it more efficient if the transient…

A: In general systems, we require the response to any change in the voltage to be faster, hence the…

Q: A dc source is connected to a series RLC circuit by a switch that closes at t = 0, as shown in…

A: Given:a series RLC circuit with dc source, the switch is closed at t=0. we need to find:a) the…

Q: How to calculate the AB voltage and AB current when the switch is ON and OFF, if it is known that R…

A: The value of each resistance in the circuit will be, The value of the cpacitor,

Q: Determine fundamental period of given signal x(t) = 2 cos 1.5 nt + sin 3.5 t

Q: An RC circuit's time constant is measured to be 12 s. The capacitor and resistor are connected in…

Q: What is current in a 50 µF capacitor if the source voltage is 100sin(100t) V? -500sin(100t+90°) mA…

A: To find the current through capacitor

Q: Convert the given Delta circuit to Y and find R2

Q: An inductor of inductance of 2 H is connected in series to a resistor of 10 2 and a 12 v battery.…

Q: e capacitor is completely empty at the beginning of the circuit in the: 10v C-1000pF

Q: A LED which bright one color when forward and another color on reverse is called One directional LED…

Q: Q: Draw output voltage waveform for this circuit if ß-50. +10v +5v -1v Vi 2 4 t(ms) 50k www +10v 10k…

A: Brief description: A common emitter amplifier is a wisely used amplifier because it provides…

Q: Co.OSH 100v 20uF

Question

Consider the following circuit. The switch in the circuit has been open for a long time before
closing at t=0
t= 0
150N
+
120mA
3002
31.25mH Ve
0.5µF
3V
Determine the roots of the characteristic equation.
a) What is the value of s1?
b) What is the value of s2?
The response for iL(t) is iL(t)=iLf+Aje°$it+A2e¯$2t
c) Determine İLF in mili amperes
d) Determine A1 in mili amperes
e) Determine A2 in mili amperes

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The switch has been in position A for a long time. Assume the switch moves instantaneously from A to B at t=0. Click all that apply
7.5mA 20k0 www 80k0 Find v(t) and draw the waveform of v(t). 0.4uFv(t) The switch is moved from position a to position bat t=0 50k
Draw the output voltage waveform of the circuit shown. Make sure to label the values.
Three capacitors 10 µF, 20 µF, 30 μF are connected in series across 150V (sinusoidal). Then identify the correct statement Maximum voltage will be applied across 10 µF Maximum voltage will be applied across 30 µF Maximum voltage will be applied across 20 µF Minimum voltage will be applied across 10 µF
A capacitor stores energy in a O they do not store energy at all O on the two conductive plates that are separated by a dielectric magnetic field O electric field
Please answer in typing format
Please Asap
Find the value of the inductor current when the switch is closed under DC condition
Assuming the capacitor is fully charged, what is the voltage across the capacitor 2 seconds after the switch is opened? E=33 V, R1=300 kſ, R2=300 k, C=10 uF R2 R1 ww + 55.2 V None of the above 31.5 V 47.3 V 23.6 V 39.4 V #6 C
The circuit below has fully adjusted to the closed switch. What is the currentthrough the inductor right before, and right after the switch is opened
The capacitance of a certain variable capacitor may be varied between limits of 1 × 10-20 F and 5×10-10 F by turning a knob attached to the movable plates. The capacitor is set to 5 × 10-10 F, and is charged by connecting it to a battery of EMF 200 V. What is the charge on the plates? The battery is then disconnected and the capacitance changed to 1 × 10-10 F. Assuming that no charge is lost from the plates, what is now the potential difference between them? How much mechanical work is done against electrical forces in changing the capacitance?