Consider the following 3 aqueous solutions of ionic compounds by assuming all the solutions have the same density (1.0 g/ml). Solution A: 0.60 m Zn(NO3)2 (strong electrolytes) Solution B: 0.60 m KF (strong electrolytes) Solution C: 0.35 m Na3PO4 (strong electrolytes) Which of the following statements is correct about the properties of these solutions? a. 0.60 m Zn(NO3)2 has a higher freezing point than 0.35 m NagPO4 has. O b.0.60 m Zn(NO3)2 has a lower osmotic pressure than 0.35 m NagPO4 has. O.0.60 m KF has the same boiling point as 0.60 m Zn(NO3)2 has. d.0.60 m KF has a higher freezing point than 0.35 m NagPO4 has.

Consider the following 3 aqueous solutions of ionic compounds by assuming all the solutions have the same density (1.0 g/ml). Solution A: 0.60 m Zn(NO3)2 (strong electrolytes) Solution B: 0.60 m KF (strong electrolytes) Solution C: 0.35 m Na3PO4 (strong electrolytes) Which of the following statements is correct about the properties of these solutions? a. 0.60 m Zn(NO3)2 has a higher freezing point than 0.35 m NagPO4 has. O b.0.60 m Zn(NO3)2 has a lower osmotic pressure than 0.35 m NagPO4 has. O.0.60 m KF has the same boiling point as 0.60 m Zn(NO3)2 has. d.0.60 m KF has a higher freezing point than 0.35 m NagPO4 has.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

22' A student needs to prepare 250 mL of a 0.200 M aqueous solution of sucrose, C₁₂H₂2011 (aq), which is used frequently in biological experiments. 200 mL 250 mL 150 200 100 150 100 250 mL 50 A B C Which type of glassware should be used to make this solution (assuming that the accuracy of the concentration is important)? B How should the correct amount of solute be obtained? O Measure out x g of solid sucrose on a balance. Measure out x cm of sucrose with a ruler. Measure out x mol of solid sucrose on a molemeter. A Based on the selected correct unit, what is the value of x? x = How should the solute and solvent be mixed in the container?
The data table below is used for the next two questions. For both questions, you're being asked about an ideal solution with an electrolyte and 500.0 g of water. Molar Mass (g/mole) 74.55 133.34 95.21 349.01 Item potassium chloride aluminum chloride magnesium chloride lead (IV) chloride 3. Formula KCI AlCl3 MgCh PbCl 1 OF 1 QUESTION a. Which electrolyte solution would have the highest boiling point? Briefly explain. b. For the electrolyte solution you discussed in part a, determine the i. c. For the electrolyte solution you discussed in parts a and b, calculate the solution boiling point.
at a certain temperature,1.85 grams of barium hydroxide will dissolve to form 100.0 ml of a saturated barium hydroxide solution. the molar mass barium hydroxide is 171.34 grams/mole. what is the concentration of the solution in unit molarity? what is the constitution of the hydroxide ion in the same solution?
44.0 mL of water was added to 100.0 mL of 0.250 M CaCl₂ solution. Assume the volumes are additive. Determine the CaCl₂ concentration in the diluted solution.
A 0.15 M solution of HCl is used to titrate 30.0 mL of a Ca(OH)2 solution of unknown concentration. If 140.0 mL of HCl is required, what is the normality of the Ca(OH)2 solution? What is the molarity?
The three drawings below represent aqueous ionic solutions. Solution A has a total volume of 25 mL, solution B has a total volume of 50. mL, and solution C has a total volume of 100. mL. If each sphere represents 0.011 mol of ions, calculate the total molarity of solute.
How many liters of 0.0300 M NaOH solution can be prepared from 2.00 g of NaOH?
The density of commercial concentrated HNO3 is 1.41 g/mL The concentrated acid contains 69% (w/w of pure acid. Determine a) Molarity of the commercial concentrated acid. b) Volume in mL of concentrated acid is needed to prepare 500 mL of 2.50 M HNO3 solution.
What mass (in grams) of Mg(NO3)2 is present in 145 mL of a 0.150 M solution of Mg(NO3)2? a) 3.23 g b) 0.022 g c) 1.88 g d) 143 g
Calculate the amount of: a) Glucose, in grams, that must be dissolved in water to obtain 75 ml of a 0.350 M solution of C6H12O6. b) Methanol, CH3OH (ρ=0.792 g/ml), in ml, which must be dissolved in water to obtain 2.25 L of a 0.485 M CH3OH solution
1. Calculate the normality of 0.321 g sodium carbonate (106.0 g/mol) when it is mixed in a 250 mL solution. 2. What is the normality of 0.0521 M H3PO4? 3. A12.5-mL portion of a base solution of an element from group 2A is diluted to 500 mL; the resulting concentration of this solution is determined to be 0.125 M. What is the normality of the original solution. 4. A sample of USP-grade citric acid (H3C6H5O7, three titratable protons) is analyzed by titrating with 0.1087 M NaOH. A 0.2678-g sample requires 38.31 mL of the titrant for titration. A. What is the normality of the titrant? B. What is the stoichiometric relationship between the analyte and the titrant? C. How many moles of the titrant were consumed to react with the analyte? NOTE: please include the given, the unknown, the chemical reaction, the calculation process, and the final answer with the proper number of significant figures.
A chemist needs 225 mL of 2.3 M HCl. What volume of 12 M HCl must be dissolved in water to form this solution? (Ignore significant figures for this problem.)