Consider the Bode plot of a transfer function shown in the following and then find the expression of the transfer function. ** Note that the x-axis is the angular frequency w and s = jw IT(W) dB 20 -20 dB/decade 2

Consider the Bode plot of a transfer function shown in the following and then find the expression of the transfer function. ** Note that the x-axis is the angular frequency w and s = jw IT(W) dB 20 -20 dB/decade 2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: For the transfer function given, sketch the Bode log magnitude diagram which shows how the log…

Q: c) Fig. B2c shows a IGBT with a freewheeling diode use to protect the transistor in a motor control.…

A: According to the question an IGBT with a freewheeling diode is used to protect the transistor in a…

Q: S, a) For the Circuit shown ealeulate the value of C if the resonant frequency is 5c00 vad/sec 0.6mH…

A: In the question, At the resonance, imaginary part of the impedance and admittance is zero. Find…

Q: dB -20 dB/decade O dB/decade 16 -20 dB/decade 0.5 log w Find the transfer function in frequency…

A: Transfer function is ratio of output signal to input signal. It is the given as ratio of Laplace…

Q: a-) Determine the zero and poles of the circuit given above by obtaining the transfer function as…

Q: 2. A transfer function has the following zeros and poles: zero at s=-104 rad/s and s=0 poles at s=…

Q: Given the following transfer function, use the Bode plot paper and draw the asymptotic…

A: Given the following transfer function, draw the asymptotic amplitude/magnitude Bode plot and phase…

Q: If you have a signal with a power of 10 W and noise with a power of 5 W, what is the SNR in dB?

A: ANSWER:- SNR in dB = 3 dB

Q: The bode plot is a standard approach to feedback control systems analysis and design. The transfer…

A: Given transfer function is =

Q: d 19. Plot the Bode plot (magnitude and phase) of the following transfer function using graphical…

Q: The Bode magnitude plot of some plant is shown below. The plant transfer function has no right-half…

A: The initial slope of the graph is -20 dB/decade and this indicates that there is a pole located at…

Q: A parallel RLC resonant circuit has a quality factor Q-80, and a resonant frequency of 200 krad's.…

A: Given a RLC parallel resonant circuit hass quality factor of 80 and resonant frequency of 200k…

Q: For the circuit shown, let R = 600 22, L = 50µH and C1 = C2 = 40 nF. (a) Find the transfer function…

A: As per Bartleby guideline we need to answer the first three questions only. Kindly repost the rest…

Q: 753. For the transfer function (TF) 6s/ (s+9) and resulting Bode Plot, calculate the gains (dB) at…

Q: Sketch the Bode plot for the given function. G(s) = K/ S(S+3)(S+6) Determine the value of 0 Gain…

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: Find the analytical expression for the magnitude and phase of the frequency transfer function for…

Q: Draw the Bode Plot for the transfer function given below, show all details and mark the margins and…

Q: questions: a) What are the poles and zeros of G? b) For what K is a unity feedback of KG stable? c)…

Q: Draw the Bode Plot for the transfer function given below, show all details and mark the margins and…

Q: Consider the Bode plot of a transfer function G(s). As compared to the Bode plot of G (s), the Bode…

Q: 753. For the transfer function (TF) 2s/(s+3) and resulting Bode Plot, calculate the gains (dB) at…

Q: s+10 Q4- Draw the Bode Plot for the transfer function: mark on s(s+5)2 your plot the margins and…

A: Solution: Bode Plot is called logarithmic or corner plot which consists of two plots; one is called…

Q: G(s) 30000 s(s+ 100) (s + 10)

A: A bode plot is a plot used for studying the frequency response of the system. There are two types in…

Q: Sketch the Bode Plot of the following Question (1+if )(I +dF/lo0) AvS-9 AVSO o5 (+if/o14)…

Q: For the Transfer Function 100 (s + 1) s² + 110s + 1000 A) Find the factors of Bode stander transfer…

Q: (s + 1) 100 s² + 110s + 1000 A) Find the factors of Bode stander transfer function? B) For each…

Q: 3. A single-phase full bridge fully controlled thyristor rectifier ( a = 45°) is supplied by grid…

Q: NOTE: You would have to clearly mark out the cut-off frequencies and the slopes of the magnitude…

Q: A system has a transfer function ofH(s)=(s+100)/(s+1000). Sketch its asymptotic Bode magnitude…

Q: A parallel RLC resonant circuit has a quality factor Q-80, and a resonant frequency of 200 krad's.…

Q: 1. For the following transfer function: G(s) = 5 5s² + 22s a. Derive the analytical frequency…

A: a) We need to determine the analytical frequency response expressions for Magnitude and Phase.b) We…

Q: Sketch the Bode Plot of the following Question without using the semi- logi paper, so that one…

Q: For a parallel RLC circuit, which one of the following statements is NOT correct? 1. 2. 3. 4. The…

A: Given: For a parallel RLC circuit, which one of the following statements is NOT correct?

Q: Consider the following transfer function 100(s + 10)(s + 500) s(s+ 5)(s+ 6)

A: Given,Open loop transfer function is GsHsGsHs=100s+10s+500ss+5s+6…

Q: A series RLC circuit has 30 volt input. Resonance of circuit occurs at 333(Hz) and 3 dB bandwidth is…

A: Given values are - Vin=30Voltfo=333HzBandwidth=33Hz

Q: dB -20 dB/decade O dB/decade 16 -20 dB/decade 0.5 5 log o Find the transfer function in frequency…

A: We will find out the transfer function by given bode plot.

Q: Please i want answer son as possible

A: In this answer we will find the required parameters one by one by using the standard second order…

Q: Following figure shows magnitude Bode diagram of a Band Pass Filter 0.5 2.5 3.5 100 110 130…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: 50( jo+1) jø(-w² +10j@+25) H (ω) =

Q: ive a verbal definitia ndicate how each is c-

A: Since you have asked a multiple question we will solve the first question for you, If you want any…

Q: Write the Transfer function H(s) determine the poles and zeroes and sketch a Bode Plot (frequency…

Q: The plot below is a sketch of the magnitude response of the asymptotic Bode plot of a system G(s).…

A: We need to calculate the G(s) from the given bode plotBode plot:-

Q: 1- Determine the values of x, and y (5x+j10)(2-jy) = 90-170 2- At steady state, what is the current…

Question

Consider the Bode plot of a transfer function shown in the following and then find the expression of the transfer function.
** Note that the x-axis is the angular frequency w and s = jw
IT(W)
'dB
20
-20 dB/decade
3
w
80(2s + 6)
6(s +3)2
T(s)
elp
4:10 PM
78°F Haze
5/24/2021
P Type here to search

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Can someone explain why the answer is 77dB? I don't understand it.
15. ..) Given the following Bode plot, what transfer function for H(s) best defines this bode plot? 4018 30d8- 2008. 1000- -10 6 -2018. 14 a 10 d 100 40. (A +100) (+100) (A+109000) -20dB decade C₁ 100 (1 +100,000) 2 (2 +100) (A+1000) 1000 18,000 IF d. 00000 6. 40 (1 +1000) (A+100)ª(2+ 100,000)2 .-40dB de cade 100 (A+1000) (D+100) (A+ 100, 000) d i meg W
QUESTION 4 Create the magnitude and phase slope contribution from each pole and zero for the following transfer function; s+6 (8+3)(s²+4s+49) G(s) = Start you work by writing the standard form for a general second order equation in Bode plot and the normalized form for the given question. Show necessary calculations.
Solve it fast plz
instrumentation and control systems
Solve the problem.
Q3. For series RLC circuit, if the input is a voltage source and the output is the voltage across the resistor. 1. Find the transfer function If R=11 Q, C-10 mF and L-100 mH, answer the following questions: 2. Plot the magnitude Bode-plot 3. Find the gain in dB for o-50 and 1000 rad/s 5. If the input source is 5cos (500t+15), find the output voltage and show this case on the magnitude plot. 200
The emitter follower, shown in the figure below, is designed to provide a gain of 0.85 when biased with a collector current of 10 mA. Find th value of the load resistance Consider that V- = 26 mV Vin J" Vcc +9₁ VCE 110 Select one O a. 147 ΚΩ b. 1479 d. 1470 ERL E VEE None of these Vout
Will upvote
Sketch the Bode Plot of the following Question Avs 9 AVSO o5 (1+if/oi4) (I+jf/500)(-jlo00/F) (1+3f )(I táF/loo) %3D
Express the transfer function (Vo(w)/Vin(w)) and draw the bode plot of both magnitude and phase of it.
Given the following transfer function, use the Bode plot paper and draw the asymptotic amplitude/magnitude Bode plot, as well as phase plot. Show all values on sketches