Consider a TCP connection using the slowstart congestion control scheme with aninitial threshold value of 64 kB and amaximum segment size(MSS) of 2 kB. Thereceiver's advertised window is initially 32kB. The first transmission attempt isnumbered 0, and all transmission attemptsare successful except for the timeouts onattempt number 4. Find the size (in kB) ofthe sender's congestion window attemptnumber 9.

Answered: Image /qna-images/answer/27556423-ff62-4f62-9542-1a7c3c7fcc40.jpg

Answered: value of 64 kB and ent size(MSS) of…

Engineering

Computer Science

value of 64 kB and ent size(MSS) of ised window is in smission attempt all transmission

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Do not give me incorrect solution. I will report .
Consider a simple congestion-control algorithm that uses linear increase and multiplicative decrease but not slow start, that works in units of packets rather than bytes, and that starts each connection with a congestion window equal to one packet. Give a detailed sketch of this algorithm. Assume the delay is latency only and that when a group of packets is sent only a single ACK is returned. Plot the congestion window as a function of round-trip times for the situation in which the following packets are lost: 9, 25, 30, 38, and 50. For simplicity, assume a perfect timeout mechanism that detects a lost packet exactly 1 RTT after it is transmitted.
Suppose two TCP connections share a path through a router R. The router's queue size is six segments; each connection has a stable congestion window of three segments. No congestion control is used by these connections. A third TCP connection now is attempted, also through R. The third connection does not use congestion control either. Describe a scenario in which, for at least a while, the third connection gets none of the available bandwidth. and the first two connections proceed with 50% each. Does it matter if the third connection uses slow start? How does full congestion avoidance on the part of the first two connections help solve this? 10:33 am Type a message Dorcon 1 tahir re
(a) Suppose a server S and client C are connected over the Internet. The one-way prop- agation delay from S to C is 50 ms. The maximum throughput between S and C is R = 200 Mbps. A browser on client C makes an HTTP request for a webpage on server S. The base HTML file is of size 500 KB and it references five objects, each of size 5 MB. Find the total response time for the client to receive the entire webpage using nonpersistent HTTP with up to two parallel connections. Assume that when two par- allel connections are active, the throughput for each connection is 40% of the maximum throughput R. (b) Suppose an application running on host ece.gmu.edu needs to resolve the domain name cs.vtech.edu. Draw a diagram (with labels) showing the sequence of queries/responses in a recursive DNS query to find the answer in a scenario where all levels of the DNS hierarchy are involved.
In TCP connection, congestion occurs if the load on the network is greater than the capacity of the network. TCP uses the following algorithm to handle congestion. The algorithm is based on the size of the congestion window (cwnd) which starts with one maximum segment size (MSS). The MSS is determined during connection establishment. At each time the whole window of segments is acknowledged (one transmission), the size of the window grows exponentially. To stop this exponential growth, the sender keeps the track of a threshold. The threshold is set to 16 MSS. After reaching the threshold, the size of the congestion window is increased by 1. After how many transmissions the congestion window size will be 22 MSS?
Consider a TCP connection betweek two hosts between A and B. The first data byte sent by A is numbered 1. The LastByteRcvd at B is 500. Then, the range of values SendBase at A may take is from to 500
A frame containing http request is sent from Computer (A) [in whichever subnet it is now, make sure to show it in your figure], to the access point it is associated with. Draw the address fields (1, 2, and 3) of the frame travelling from Computer A to AP and the source and destination addresses of the frame travelling from AP to R1. The MAC addresses of AP1, AP2, and AP3 are M1, M2, and M3 respectively, and the Router R1’s MAC address connected to this Switch/AP is MRA. IP address values are already given, and the port addresses could also be used as given. The Router’s MAC address facing WAN side is MRW.
Suppose a TCP connection, with window size 1, loses every other packet. Those that do arrive have RTT: 1 second. What = happens? What happens to TimeOut? Do this for two cases: (a) After a packet is eventually received, we pick up where we left off, resuming with Estimated RTT initialized to its pre-timeout value, and TimeOut double that. (b) After a packet is eventually received, we resume with TimeOut initialized to the last exponentially backed-off value used for the timeout interval. In the following four exercises, the calculations involved are straightforward with a spreadsheet.
Consider a client connecting to a web server via a router as shown in Fig.Q2. Client A sends a request to the server to retrieve a 7.5 Mbytes file. Given that the segment size is 50 Kbytes, the round trip time (RTT) between the server and client is 10 ms, the initial slow-start threshold is 16 and the client's buffer always has a storage space of 1 Mbytes. Assume that TCP Reno is used, there is no loss during transmission and the headers of protocols are ignored. 400 Mbps 200 Mbps 400 Mbps Link a Link b Link c Client Web Server Fig.Q2 (a) Describe how the value of sending window changes as a function of time (in units of RTT) during the whole connection time. 2.
Suppose a client is communication with a server via a TCP Reno connection. The client has sent the data up to sequence number 120. The client has received acknowledgment number 80 from the server, and the received window is 50 in the last message received by the client from the server. Moreover, the client has estimated the congestion window as 36 for the server. If the client receives two more acknowledgment number 80, then how much maximum data the client can send to the server? Justify your answer via proper references and procedure. (coding required)
Asap
An HTTP client opens a TCP connection using an initial sequence number (ISN) of 14,534 and the ephemeral port number of 59,100. The server opens the connection with an ISN of 21,732. Show the three TCP segments during the connection establishment if the client defines the rwnd of 4000 and the server defines the rwnd of 5000. Ignore the calculation of the checksum field.