Consider a single acting triplex pump having 7-in. liners and 12-in. stroke length operating at a discharge pressure of 3,428 psi and velocity of 100 stk/min. During a period of 4 minutes, the amount of mud collected at the flowline was 2,040 gal. Determine:

Q: Calculate the flow rate and average velocity for a 10-inch deep flow in the 12-inch diameter…

A: Given data in question  Diameter 12 inch n value 0.028 Slope 0.0085 To find out  Flow rate Velocity

Q: What is the water content (%) of a soil specimen given the following information following a…

A: Water content=MWet-MdryMdryMWet=M1-M3=80.7-11.4g=69.3gmMdry=M2-M3=76.9-11.4g=65.5gm

Q: Compute the discharge (in m3/s) of 3-m concrete (rough) pipe carrying water at 10°C. It is allowed…

A: Diameter (D) = 3 mHead loss = 2 m/km

Q: Q2: A spillway needs to be designed to carry a peak flow of 50m'is with the reservoir elevation Im…

A: The given data is shown below: Peak flow=50 m3/sReservoir elevation=1mElevation…

Q: The pressure at the 2nd floor faucet in the residential building is estimated to be about 45 psi for…

A:

Q: Assuming the pump is for a system in Prescott AZ (-5300 ft above sea level), compute the NPSHA for…

A: Data is not sufficient for the solution   Available NPSH NPSHA=Patmγ-hs-hfs-hv Where Patm =…

Q: discuss the differences between a full pipe flow and a partially full pipe flow.

A:

Q: Consider a single acting triplex pump having 7-in. liners and 12-in. stroke length operating at a…

A: So for calculation of the pump hydraulic horsepower we have to calculate pump factor and pump flow…

Q: it is generally recommended that pump operation should be maintained within +/- O 10 % of the…

A: Note:- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: For a coagulation basin designed to treat 0.05 m3/s of 20oC surface water, a) What volume is…

A: Velocity Gradient G = 700 s-1Discharge flow in basin = 0.05 m3/sec Detention time = 10 sec Dynamic…

Q: Question The values given in the table below were obtained from a flow observation station.…

A: Find The total flow.

Q: A pump discharge is 10l / s The NPSHR is 6 m, assun combined K_{L} of 10. The suction pipe diameter…

A: Given, Q = 10 L/s or 0.01 m3/s NPSHR = 6 m  KL = 10  D = 75 mm or 0.075 m

Q: Using the pump selection table below to determine the best pump for the given condition: Imp.gpm • A…

A: Following is required answer :

Q: A flocculation tank is to be designed for a total flow rate of 45000 m3/d. The following conditions…

A:

Q: The outflow rate (O) and storage (S) for the emergency spillway are linearly related as O =…

A: The given data is: Outflow, O=S/10,000 Where S=storage At Time=0 hr Inflow rate=0 m3/s Outflow…

Q: The pressure at the 2nd floor faucet in the residential building is estimated to be about 43 psi for…

A: