Consider a short-circuited, 50 lossless TL. Find the shortest electrical length of the line such that (a) Zin =j50 (b) Zin=-j150 (c) Zin = ∞ (d) Zin = 0

Q: For an end condenser transmission line representation, transmission parameter A is

A: Given, An end condenser transmission line. The transmission parameter A is ?

Q: b. y = (C + D) + AC D + AB C + A BCD + AC Ď

A: K-MAP: K-Map is used to optimize the Boolean function by using grouping technique. It's also being…

Q: If T = 0.6260° and A = 20cm find the position of the second voltage maximum on the line. Select one:…

A: In this question we need to find a position of the second voltage maximum on the line

Q: Three lossless lines are connected as shown in the figure below. Determine the input impedance. a/2…

A:

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A: We will find out the characteristics impedance for given transmission line with give open circuit…

Q: Example: A lossy TL has a length of 200 Km and its characteristie impedance is Za 683-j1382. The…

A: Here, we have a lossy transmission line having length of 200 km and the characteristic impedance of…

Q: R1 = 50kΩ Im 5V R₂ = 8.2k R3 = 4.7k0 -5V

A: The solution is given below

Q: raw the single line diagram and form the Yus matrix for the data ven below. All the admittance…

A: Single line diagram if the admittance of the diagram is given.  Admittance matrix of the given in…

Q: Noise due to inductive coupling can be reduced by twisting the wires carrying a signal.  True…

A:

Q: A lossless TL with if the voltage a cross a load connected to lossless TL is 20 Vyrms and reflection…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Deficiency in transmission is caused by attenuation, distortion, and noise. What's the solution, and…

A: Attenuation The weakening of the signal over the transmission line causes attenuation. To solve the…

Q: If T 0.6/60° and X= 20cm find the position of the second voltage maximum on the line. %3D Select…

A: We need to tell about the location of maxima on transmission line. We know direct formula , we will…

Q: Q3 for lossless T-L shown, find Z, and Zdat diz R₂ for 10 14 + tu For Son 12 30m Zason

A:

Q: (b) Silver is a good conductor and it has a resistivity of 15.9n Qm. (i) Briefly explain mean free…

A: Given data:

Q: Q1. 30, 110 kV, 50 Hz, 150 km long transmission ine consisting of three conductors each of 10 mm…

A: Part (1) Critical Disruptive voltage, Vdc=δ×g0×m0×r×lndrg0=breakdown strength of air  = 302…

Q: Q-7 b, A transmission line has equal voltages at the two ends maintained constant by two sources a…

A: A transmission line- Equal voltages at the two ends maintained by 2 sources. A third source to be…

Q: A 500 loss line terminated in a purely resistive load has a voltage standing wave ratio of 3. Find…

A: Given: Zo=50 ΩVSWR=s=3

Q: 8. A transmission line has a characteristic impedance of 500 and a resistanc of 0.1 02/m. If the…

A: In this question we will find attenuation constant for distortionless transmission line....

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A: 1..>>Capacitance of line without effect of ground Radius of conductor is 0.4cm Distance…

Q: The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltage minima is 80…

A:

Q: 4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY…

A:

Q: The open circuit imepdance of a certain length of a loss-less line is 100 ohm. The short circuit…

A: Given: Open circuit impedance of line, Zoc=100 Ω Short circuit impedance of line, Zsc=100 Ω

Q: Can we used information signal has frequency 500 Hz? why? at AM-SSB

A: The solution is given below

Q: A 1002 transmission line with T = 0.447Z63.5°. Find Z1. Select one: a. 25 + 25j О Б. 25 — 25j O c.…

A: consider the given question

Q: If the first and the third reflection coefficients of a matched line are 0.2 and 0.01, then the…

A:

Q: Ideally, a dc load line is a straight line drawn on collector characteristic curves between which of…

A: The DC Load Line of BJT Biasing Circuit is a straight line drawn on the transistor output…

Q: Find the input impedance (Zin) for a lossless transmission line shown in below: B - 52/8 31/4 /2- Z,…

A:

Q: The power factor must be close to . . To insure that losses in the transmission lines will be…

A: The power factor of the system is calculated as cosine of phase angle between voltage and current of…

Q: The capacitance of a single phase two-wire transmission line depends on: Select one: O a. All the…

A: Capacitance of a Single Phase Two Wire Line consisting of two parallel conductors A and B spaced d…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A:

Q: b) A 602 characteristic impedance transmission line is fed by a DC source of 100V with an internal…

A:

Q: On distortionless line, the voltage wave is given by -100251 V = 120 0025 cos (10²t +21²) + 60 e²²…

A:

Q: Convergence interval and radius, Cnd interval points of Hhe Find the then Lest the Series (^+)(とXン…

A:

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.