Consider a sealed can that is filled with refrigerant-134a at 20degrees C. Now a leak develops, and the pressure in the can drops to the local atmospheric pressure of 80 kPa. The temperature of the refrigerant in the can is expected to drop to (rounded to the nearest integer)Select one:a. 0 degrees Cb. -31 degrees Cc. -18 degrees Cd. 3 degrees Ce. 20 degrees Cf. Insufficient information to answer question

Q: Water contained in a piston-cylinder assembly, initially at 300°F, a quality of 70%, and a volume of…

A: The internal energy is calculated at each state. The amount of mass is obtained from volume and…

Q: Thermodynamics a) A wood-fired heating plant has a capacity of about 60 MW. The plant has an…

A: (a) Capacity of the wood firing plant, C=60 MW Thus actual capacity of the plant is given as, Q=60…

Q: A heat pump with refrigerant-134a (R-134a) as the working fluid is used to keep a space at 21 °C by…

A: Given information:   The working fluid used in a heat pump is a refrigerant R-134a.   Space…

Q: An ideal Rankine cycle as shown has a boiler pressure of 3 MPa and a condenser pressure of 8 kPa.…

A:

Q: En a heat exchanger with steam outside the tubes, a liquid gets heated to 45°C w ts flow velocity in…

A: This problem is based on heat transfer.  The initial flow velocity is given by v= 2 m/s. The…

Q: A thermal power plant in which the waste heat is used to heat the offices and other buildings does…

A:

Q: Which among the statement is incorrect. (A None of the choices B Bernoulli's equation is an…

A: The fluid flow problems are solved with a general energy equation. The elevation head, pressure…

Q: emperatures (°C) are measured at various points on a heated plate, which are reported in the…

A: Now, Kth degree polynomial approximation,

Q: A cylindrical open top vessel with 30 cm diameter contains 100 grams of water at 25 °C and 1 atm.…

A:

Q: A ball at 1200K is allowed to cool down in air at an ambient temperature of 300K. Assuming heat is…

A: Since you asked to solve this question by Runge-Kutta of fourth-order which is a lengthy process…

Q: 10. The water in a tank is pressurized by air, and the pressure is measured by a multifluid…

A: Given data: Density of water = 1000 kg/m3 Density of oil = 850 kg/m3 Density of mercury = 13,600…

Q: T2-45 °C 11-25 °C TI-45°C 12-40°C design condenser-inlet temperature of the process stream T1 =45…

A: Step 1: Convert mass flow rate of process stream to kg/sm˙=3600s/hr8060kg/hr​=2.239kg/s Step 2:…

Q: Tony and T’chaila are using another rare metal, the nnth metal ( c = 0.600 J/ g- degrees celcius)to…

A: Given Data :  Cp of metal = 0.6 J/g C  mass of metal to build cuirass (m) = 5 Kg  Initial…

Q: An evacuated 150-L tank is connected to a line flowing air at room temperature, 25oC, and 8 MPa…

A: Volume (V) = 150 L Tin = 25°c = 298 K T3 = 25°c = 298 K Pin = 8 MPa = 8000 KPa P2 = 6 MPa = 6000 KPa…

Q: Air is cooled and dehumidified as it flows over the coils of a refrigeration system from 35 ° C and…

A: Refrigeration is the process of cooling a substance or a material by removing heat from the…

Q: 290 K and the pressure is atmospherie. The residence time in the combustor is 0.1 s. As- suming the…

A:

Q: Manometers A cylindrical column is partially filled with three liquids: water, mercury, and…

A:

Q: 4

A: Given :Thermal conductivity, The temperature, The heat generation rate, The density, The specific…

Q: Please answer this correctly,You need to refer to the thermodynamics table.

A: your question about determining the quality of a two-phase liquid-vapor mixture of refrigerant-134a…

Q: Actual vapor quality at turbine's exit Actual work of

A:

Q: For practical reasons, oxygen and nitrogen are usually stored and distributed and argon at…

A: Given: Initially the nitrogen is stored as liquid nitrogen with conditions: Volume of the thermos,…

Q: 3. A PVT cell containing pure water (H₂O) shows two equilibrium phases of vapor and liquid at…

A: NOTE- Yes both part A and B are correct.Given,

Q: If the b. value of the distillation column feed equals 0.53, then the feed is O. Saturated liquid…

A:

Q: (b) In figure Q1(a) a system is taken from state A to state B along the path ACB, 95 J of heat flows…

A:

Q: In a company that supplies helium to balloon animal artists, they must fill their standard 6 m3…

A: Considered helium is filled in a tank of 6  which is initially empty and filled upto pressure of 4…

Q: A bottle of fresh orange juice is taken from a fridge at 40C and left in a room with an ambient…

A: It is given that,initial temperature of bottle ambient temperature overall heat transfer…

Q: 450 g of water at temperature of 22 °C is being heated until all of it is converted into steam.…

A: Weight of water = 450g = 0.45 kg Initial temperature = 22°c Final temperature = 100°c Specific heat…

Q: Consider a 400 Liters Tank contains 14.9 kg of refrigerant-134a at 12.0 °C. What is the quality of…

A:

Q: You have 1.4 Langley's available in your area. Assuming about 11 hours of sunlight per day and a…

A:

Q: Example :- Calculate the speed required for 0.6 m' tank in which 100 W/m is supplied to the tank,…

A: Given For 0.6 m3 power P = 100 W/m3

Q: Steam is used to cool a polymer reaction. The steam in the steam chest of the apparatus is found to…

A: The initial state of the steam is at a temperature of 250.5°C and a pressure of 4000 kPa. The final…

Q: A bathtub initially containing 64 L of cold water at 21.3°C receives hot water at 64.2°C, 0.7 L/s. A…

A: Here there is no heat loss to surroundings. The heat lost by water at coming is equal to the gained…

Q: Pressurized methane flows through a variable diameter pipe as indicated below. Given CHA physical…

A:

Q: QUESTION 3 Figure 3 shows the initial state of a system. Container A of 1 m3 contains Air at 300 K…

A: Given : Initial volume Initial pressure Temperature Gas constant Specific heat at constant volume

Q: Applying the phase rule at point d, F= ? 1.) 1 2.) 2 3.) 3 4.) 0

A: Given Data:  Applying phase rule and given PT diagram. Find Degree of Freedom at point d.

Q: There is a flow of 238 kg/h of water that will enter a heat exchanger at 37 °C to be used as a…

A:

Q: Gases behave as an ideal gas at low densities (ie., low pressure, high temperature), what is the…

A: When Gases Behave as an ideal gas at low density then Critical Temperature of Ideal Gas is always…

Q: A 0.2-m3 rigid tank equipped with a pressure regulator contains steam at 2  MPa and 300 °C, the…

A: Given that  volume of the tank[v1 ]=0.2 m3 initial condition of air pressure[p]=2 Mpa…

Q: 6. Term denoting the difference between the actual temperature and the saturation temperature at the…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…