Consider a one-storey building that is a square. It will have an access point in each corner and one in the center of the square. Each access point can hear only its neighbor one. (That is the AP placed at a corner cannot hear another AP at the opposite corner.) Assign access point channels to the five access points if you are using 802.11g (2.4 GHz). Available channels are 1, 6, and 11. Were you able to eliminate interference between access points? If NO, Why? Otherwise, show your channel assignment. Repeat the a) part of the question, this time using 802.11a (5 GHz). Available channels are 36, 40, 44, 48, 53, 56, 60, 64, 149, 153, 157, and 161, but many NICS and access points only support channels below 100. APT AP4 AP5 AP2 АРЗ

Consider a one-storey building that is a square. It will have an access point in each corner and one in the center of the square. Each access point can hear only its neighbor one. (That is the AP placed at a corner cannot hear another AP at the opposite corner.) Assign access point channels to the five access points if you are using 802.11g (2.4 GHz). Available channels are 1, 6, and 11. Were you able to eliminate interference between access points? If NO, Why? Otherwise, show your channel assignment. Repeat the a) part of the question, this time using 802.11a (5 GHz). Available channels are 36, 40, 44, 48, 53, 56, 60, 64, 149, 153, 157, and 161, but many NICS and access points only support channels below 100. APT AP4 AP5 AP2 АРЗ

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

What is the maximum data rate of a channel with a bandwidth of 200 KHz if we use four levels of digital signaling. Select one: O a. 400 bps O b. 200 bps O c. 600 bps O d. 800 bps
You are designing the Wi-Fi for a classroom of 20 students and all students are using Wi-Fi at the same time. The protocol efficiency is 40% and the channel utilization is 80%. Each students uses a throughput of 2 Mbps. What is the minimum PHY rate requirement for the radio in Mbps?
We have a channel with a 1-MHz bandwidth. The SNR for this channel is 63. What are the appropriate bit rate and signal level?
These are the options for a choose from here
We would like to transmit information over a CAT-6 twisted pair cable with a bandwidth of 250 MHz. Calculate the channel capacity (in bps) knowing that the signal to noise ratio SNR is 12 dB (in decibel).
If transmission delay and propagation delay in a sliding window protocol are 2 msec. and 99 msec. respectively, and only six bits are reserved for sequence numbers, then the percentage efficiency would be ......... O 32% O 66.4% O 0.64% O 64% O 100%
QI: Suppose you have the following modulated signal: ø(t) = 6 cos(1600nt) + 22 cos(1800nt) + 6cos(2000nt) Сompute: I- Determine the modulating signal m(t) and the carrier signal c(t). 2- Determine the modulation index m. 3- Determine the ratio of the power in the sidebands to the power in the carrier. Q2 : Suppose you have the following modulated signal with the output wave changes of 5.5 V,: V (1) =15sin(27600x10' )t – 4.25cos(27490x10')t +3.75cos(2r460x10 Сompute: 1- Caleulate the modulation coefficient and percent modulation. 2- Calculate the peak amplitude of the modulated carrier, upper and lower side frequency voltages. 3- Calculate the maximum and minimum amplitude of the envelope. 4- Draw and label the frequency spectrum. 5- Sketch and label the output envelope.
Given the main frequency of the wideband channel to be 250MHZ with a bandwidth of 200MHZ, what will be the sub frequencies if the channel is divided into 4? Your answer
I need the answer as soon as possible
What is the bandwidth of a modulated signal compared to ?message signal Eヨ x x, 3 I I x, E E 12pt
Consider a channel with bandwidth B = 2Mhz and a signal to noise ratio of 40dB (expressed in log scale, remember the conversion!). What is the maximum data rate achievable? Explicitly mention the theorem and the calculation that lead to the solution.
Suppose, there are two channels to multiplex, one bits from each source and use TDM with 180Kbps and 190Kbps. Pulse stuffing is allowed if requires. What is the datarate? * 1203kbps 1308kbps 380kbps 830kbps Suppose, there are two channels to multiplex, one bits from each source and use TDM with 180Kbps and 190Kbps. Pulse stuffing is allowed if requires. What is the frame rate? 370k frame/s 180k frame/s 910k frame/s 190k frame/s