Consider a linear elastic rectangular thin sheet of metal, subjected to uniform uniaxial tensile stress of 100 MPa along the length direction. Assume plane stress conditions in the plane normal to the thickness. The Young's modulus E = 200 MPa and Poisson's ratio v = 0.3 are given. The principal strains in the plane of the sheet are

Consider a linear elastic rectangular thin sheet of metal, subjected to uniform uniaxial tensile stress of 100 MPa along the length direction. Assume plane stress conditions in the plane normal to the thickness. The Young's modulus E = 200 MPa and Poisson's ratio v = 0.3 are given. The principal strains in the plane of the sheet are

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

20 and σ are the principal stresses at a point in a strained material. Poisson ratio for the material is 0.25. Modulus of elasticity of the material is 2.20. Total strain energy stored per unit volume of the material is ko. Then the value of k is (Round off to two decimal places.)
Determine principal stress
Question- Principal stress at a point in an elastic material are 1.50 (tensile), o (tensile) and 0.50 (compressive). The elastic limit in tension is 210 MPa and poisson's ratio=0.3. Find the value of o at the failure when computed by the maximum principal strain theory.
Please solve correctly
/
Figure Q4 shows a piece of triangular thin plate ABC with thickness 5 mm. A linear pressure as shown in the figure is being applied to edge AB with maximum intensity of 100 kN/m² at the middle of edge AB. The plate is made from stainless steel, with a Young's modulus of 200 GPa and Poisson's ratio of 0.3. The deformations in the plate are to be obtained. For such purposes, the finite element method is being employed. (a) (b) (c) (d) (e) State the type of problem involved in this case (to determine the stiffness matrix to be used). Model this problem optimally using the least number of orthogonal triangular elements only. Label the nodes and elements and indicate clearly the status of all the relevant degrees-of- freedom in this model. Set up the appropriate system of simultaneous equations and solve for the unknown displacements. Displacements at point T. Without any calculation, explain on the value of strain at points S and T.
Consider a linear elastic rectangular thin sheet of metal, subjected to uniform uniaxial tensile stress of 100 MPa along the length direction. Assume plane stress conditions in the plane normal to the thickness. The Young's modulus E = 200 MPa and Poisson's ratio v = 0.3 are given. The principal strains in the plane of the sheet are
The principal stress for a machine boiler are sigma , 0.5 sigma and 0. If yield stress is 240. Find the suitable value of sigma by Max principal strain theory Max shear stress theory
Use stress transformation method and not the equations.
At a point on the free surface of a machine component the strain rosette shown in the figure below
An initially rectangular element of a material is deformed into the shape shown in the figure. Find the: a. Normal strain in the x- direction b. Normal strain in the y- direction c. Total shear strain -Draw and label the diagram correctly, No diagram in the solution will be marked wrong. -Shortcut solution will be marked wrong.- Direction of the assumption of the equilibrium equation must be shown, no direction will be marked wrong.